1. |
- Lindberg, Hans, 1977, et al.
(författare)
-
High-power optically pumped 1550-nm VECSEL with a bonded silicon heat spreader
- 2004
-
Ingår i: IEEE Photonics Technology Letters. - 1041-1135 .- 1941-0174. ; 16:5, s. 1233-1235
-
Tidskriftsartikel (refereegranskat)abstract
- We present an optically pumped 1550-nm vertical-external-cavity surface-emitting laser with improved output power and operating temperature using a bonded heat spreader. The laser comprises an InGaAsP-based gain element, with a resonant periodic gain structure on top of a distributed Bragg reflector, and a high reflectivity spherical mirror as the external reflector. Heat transport is enhanced by a Si heat spreader bonded to the InGaAsP surface by liquid capillary bonding. Optical pumping is achieved using a 1250-nm fiber Raman laser. A maximum continuous output power of 250 mW was obtained under multitransverse mode operation at 240 K. Under operation in the fundamental near-Gaussian mode, we obtained a maximum power of 230 mW with a beam quality factor (M-2) of 1.22. At room temperature, the output power was limited to 12 mW.
|
|
2. |
- Lindberg, Hans, 1977, et al.
(författare)
-
InP-based optically pumped VECSEL operating CW at 1550 nm
- 2004
-
Ingår i: IEEE Photonics Technology Letters. - 1041-1135 .- 1941-0174. ; 16:2, s. 362-364
-
Tidskriftsartikel (refereegranskat)abstract
- We present a vertical external-cavity surface-emitting laser operating at 1550 run. The laser comprises an InGaAsP-based gain element, with a resonant periodic gain structure on top of a distributed Bragg reflector, and a high reflectivity spherical mirror as the external reflector. Optical pumping is achieved using a 1250-nm fiber Raman laser. A maximum continuous output power of 70 mW was obtained under multitransverse mode operation at 233 K. Under single-mode operation, we obtained a maximum power of 60 mW with a beam quality factor M-2 less than 1.1.
|
|
3. |
- Carlsson, Christina, 1975, et al.
(författare)
-
RF transmission over multimode fibers using VCSELs-comparing standard and high bandwidth multimode fibers
- 2004
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 22:7, s. 1694-1700
-
Tidskriftsartikel (refereegranskat)abstract
- Fiber-optic radio-frequency links have been assembled using oxide-confined vertical-cavity surface-emitting lasers (VCSELs) and multimode fibers. Links with single and multimode VCSELs and with standard and high-bandwidth fibers have been evaluated and compared in the frequency range of 0.1-10 GHz. The best results were obtained for links with a multimode VCSEL and a high-bandwidth fiber. For a 500-m-long link, a spurious free dynamic range of 104 dB. HZ(2/3) at 2 GHz and 100 dB (.) Hz(2/3) at 5, GHz were obtained while allowing for a VCSEL-fiber misalignment of +/-12 mum. Corresponding numbers for the intrinsic link gain and noise figure are -29 and -33 dB, and 39 and 42 dB at 2 and 5 GHz, respectively. Inferior performance Was observed for the standard fiber link due to a larger variation in modal group velocities. This paper also presents a detailed link analysis to identify performance limitations and to suggest modifications for improved performance.
|
|
4. |
|
|
5. |
|
|
6. |
|
|
7. |
|
|
8. |
|
|
9. |
|
|
10. |
|
|