| 11. |
- Andersson, Viktor, et al.
(författare)
-
Comparative study of organic thin film tandem solar cells in alternative geometries
- 2008
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 104:12, s. 124508-
-
Tidskriftsartikel (refereegranskat)abstract
- Optical modeling of one folded tandem solar cell and four types of stacked tandem solar cells has been performed using the finite element method and the transfer matrix method for the folded cell and the stacked cells, respectively. The results are analyzed by comparing upper limits for short circuit currents and power conversion efficiencies. In the case of serial connected tandems all of the five cell types may be compared, and we find that the folded cells are comparable to stacked tandem cells in terms of currents and power conversion efficiencies.
|
|
| 12. |
- Andersson, Viktor, et al.
(författare)
-
Imaging of the 3D Nanostructure of a Polymer Solar Cell by Electron Tomography
- 2009
-
Ingår i: Nano letters (Print). - : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 9:2, s. 853-855
-
Tidskriftsartikel (refereegranskat)abstract
- Electron tomography has been used for analyzing the active layer in a polymer solar cell, a bulk heterojunction of an alternating copolymer of fluorene and a derivative of fullerene. The method supplies a three-dimensional representation of the morphology of the film, where domains with different scattering properties may be distinguished. The reconstruction shows good contrast between the two phases included in the film and demonstrates that electron tomography is an adequate tool for investigations of the three-dimensional nanostructure of the amorphous materials used in polymer solar cells.
|
|
| 13. |
- Andersson, Viktor, et al.
(författare)
-
Optical modeling of a folded organic solar cell
- 2008
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 103:9, s. 094520-
-
Tidskriftsartikel (refereegranskat)abstract
- The optical behavior of a reflective tandem solar cell (V cell) is modeled by means of finite element method (FEM) simulations. The absorption of solar light in the active material as well as in both electrode layers is calculated. The FEM solves the electromagnetic wave equation on the entire defined geometry, resulting in the consideration of interference effects, as well as effects of refraction and reflection. Both single cells and tandem cells are modeled and confirmed to be in accordance with reflectance measurements. Energy dissipation in the active layers is studied as a function of layer thickness and folding angle, and the simulations clearly display the advantage of the light trapping feature of folded cells. This is especially prominent in cells with thinner active layers, where folding induces absorption in the active layer equivalent to that of much thicker cells.
|
|
| 14. |
- Asplund, Maria, 1978-, et al.
(författare)
-
Composite biomolecule/PEDOT materials for neural electrodes
- 2008
-
Ingår i: Biointerphases. - NY : American Institute of Physics. - 1559-4106 .- 1934-8630. ; 3:3, s. 83-93
-
Tidskriftsartikel (refereegranskat)abstract
- Electrodes intended for neural communication must be designed to meet boththe electrochemical and biological requirements essential for long term functionality. Metallic electrode materials have been found inadequate to meet theserequirements and therefore conducting polymers for neural electrodes have emergedas a field of interest. One clear advantage with polymerelectrodes is the possibility to tailor the material to haveoptimal biomechanical and chemical properties for certain applications. To identifyand evaluate new materials for neural communication electrodes, three chargedbiomolecules, fibrinogen, hyaluronic acid (HA), and heparin are used ascounterions in the electrochemical polymerization of poly(3,4-ethylenedioxythiophene) (PEDOT). The resultingmaterial is evaluated electrochemically and the amount of exposed biomoleculeon the surface is quantified. PEDOT:biomolecule surfaces are also studiedwith static contact angle measurements as well as scanning electronmicroscopy and compared to surfaces of PEDOT electrochemically deposited withsurfactant counterion polystyrene sulphonate (PSS). Electrochemical measurements show that PEDOT:heparinand PEDOT:HA, both have the electrochemical properties required for neuralelectrodes, and PEDOT:heparin also compares well to PEDOT:PSS. PEDOT:fibrinogen isfound less suitable as neural electrode material.
|
|
| 15. |
|
|
| 16. |
- Asplund, M, et al.
(författare)
-
Toxicity evaluation of PEDOT/biomolecular composites intended for neural communication electrodes
- 2009
-
Ingår i: BIOMEDICAL MATERIALS. - : IOP Publishing. - 1748-6041 .- 1748-605X. ; 4:4, s. 045009-
-
Tidskriftsartikel (refereegranskat)abstract
- Electrodes coated with the conducting polymer poly(3,4-ethylene dioxythiophene) (PEDOT) possess attractive electrochemical properties for stimulation or recording in the nervous system. Biomolecules, added as counter ions in electropolymerization, could further improve the biomaterial properties, eliminating the need for surfactant counter ions in the process. Such PEDOT/biomolecular composites, using heparin or hyaluronic acid, have previously been investigated electrochemically. In the present study, their biocompatibility is evaluated. An agarose overlay assay using L929 fibroblasts, and elution and direct contact tests on human neuroblastoma SH-SY5Y cells are applied to investigate cytotoxicity in vitro. PEDOT: heparin was further evaluated in vivo through polymer-coated implants in rodent cortex. No cytotoxic response was seen to any of the PEDOT materials tested. The examination of cortical tissue exposed to polymer-coated implants showed extensive glial scarring irrespective of implant material (Pt:polymer or Pt). However, quantification of immunological response, through distance measurements from implant site to closest neuron and counting of ED1+ cell density around implant, was comparable to those of platinum controls. These results indicate that PEDOT: heparin surfaces were non-cytotoxic and show no marked difference in immunological response in cortical tissue compared to pure platinum controls.
|
|
| 17. |
|
|
| 18. |
- Barrau, Sophie, et al.
(författare)
-
Nanomorphology of Bulk Heterojunction Organic Solar Cells in 2D and 3D Correlated to Photovoltaic Performance
- 2009
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 42:13, s. 4646-4650
-
Tidskriftsartikel (refereegranskat)abstract
- Control of the nanoscale morphology of the donor-acceptor material blends inorganic solar Cells is critical for optimizing the photovoltaic performances. The influence of intrinsic (acceptor materials) and extrinsic (donor:acceptor weight ratio, substrate, solvent) parameters was investigated, by atomic force microscopy (AFM) and electron tomography (ET), on the nanoscale phase separation of blends of a low-band-gap alternating polyfluorene copolymers (APFO-Green9) with [6,6]-phenyl-C-71-butyric acid methyl ester ([70]PCBM). The photovoltaic performances display an optimal efficiency for the device elaborated with a 1:3 APFO-Green polymer:[70][PCBM weight ratio and spin-coated from chloroform solution. The associated active layer morphology presents small phase-separated domains which is a good balance between as a large interfacial donor-acceptor area and Continuous paths of the donor and acceptor phases to the electrodes.
|
|
| 19. |
- Bjorstrom, Cecilia M., et al.
(författare)
-
Influence of solvents and substrates on the morphology and the performance of low-bandgap polyfluorene: PCBM photovoltaic devices - art. no. 61921X
- 2006
-
Ingår i: Proceedings of SPIE, the International Society for Optical Engineering. - : International Society for Optical Engineering; 1999. - 0277-786X .- 1996-756X. ; 6192, s. X1921-X1921
-
Tidskriftsartikel (refereegranskat)abstract
- Spin-coated thin films of poly[(9,9-dioctylfluorenyl-2,7-diyl)-co-5,5-(4,7-di-2-thienyl-2,1,3-benzothiadiazole)] (APFO-3) blended with [6,6]-phenyl-C-61-butyric acid methyl ester (PCBM) are used as the active material in polymer photovoltaic cells. Such blends are known for their tendency to phase separate during film formation. Tuning the morphology of the blend in a controlled way is one possible road towards higher efficiency. We studied the effect of adding chlorobenzene to chloroform-based blend solutions before spin-coating on the conversion efficiency of APFO-3:PCBM photodiodes, and related that to the lateral and vertical morphology of thin films of the blend. The lateral morphology is imaged by atomic force microscopy (AFM) and the vertical compositional profile is obtained by dynamic secondary ion mass spectrometry (SIMS). The profiles reveal compositional variations consisting of multilayers of alternating polymer-rich and PCBM-rich domains in the blend film spin-coated from chloroform. The vertical compositional variations are caused by surface-directed spinodal waves and are frozen in during the rapid evaporation of a highly volatile solvent. With addition of the low-vapour pressure solvent chlorobenzene, a more homogeneous vertical composition is found. The conversion efficiency for solar cells of this blend was found to be optimal for chloroform: chlorobenzene mixtures with a volume-ratio of 80:1. We have also investigated the role of the substrate on the morphology. We found that blend films spin-coated from chloroform solutions on PEDOT:PSS-coated ITO show a similar compositional structure as the films on silicon, and that changing the substrate from silicon to gold only affects the vertical phase separation in a region close to the substrate interface.
|
|
| 20. |
- Björk, Per, et al.
(författare)
-
Conjugated polythiophene probes target lysosome-related acidic vacuoles in cultured primary cells
- 2007
-
Ingår i: Molecular and Cellular Probes. - : Elsevier BV. - 0890-8508. ; 21:5-6, s. 329-337
-
Tidskriftsartikel (refereegranskat)abstract
- Conformation-sensitive optical probes for studying biological processes and structures are of great interest. The present work shows for the first time that conjugated polyelectrolyte (CPE) probes can be used for specific targeting of chromatin, nuclear and cytoplasmatic vesicles, and cytoskeletal components in a complex system of cultured cells. One of the probes could also be used for vital staining of live cells. When bound to different entities, the polythiophene derivative probes emitted light with different colors due to the unique spectral properties of these conformation sensitive probes. The physical pre-requisites for binding could also be exploited for characterization of the target. Unexpectedly, lysosome-related acidic vacuoles were targeted in cultured primary cells by both anionic, cationic, and zwitter-ionic polythiophene derivatives. Pre-treatment with Bafilomycin A1, a specific inhibitor of vacuolar-type H+-ATPase, caused redistribution of the staining. The targeting of lysosome-related acidic vesicles could not be demonstrated in transformed cells (melanoma, neuroblastoma, and prostate cancer cell lines), indicating a difference in the localization, structure, accessibility, or quantity of the target in cultured normal cells as compared with the malignant cell lines. The chemical nature of the conjugated polyelectrolyte complex in the cytoplasmatic vacuoles remains elusive.
|
|
