| 1. |
- Abeysekera, John, et al.
(författare)
-
Some design recommendations to improve comfort in helmets : a case study from China
- 1996
-
Ingår i: Journal of Human Ergology. - 0300-8134. ; 25:2, s. 145-154
-
Tidskriftsartikel (refereegranskat)abstract
- Unless the basic user needs are satisfied in safety helmets, it is difficult to get workers to wear them habitually and for long periods. Hotness, weight and fitting problems are major wearability issues that require improvements. The enormous need for an optimally designed helmet in China prompted a case study on comfort aspects in helmets. The subjective impressions of the wearers of test helmets provided useful information for design changes to improve comfort. The heat transfer measurements through helmets indicated the need for ventilation openings to be provided on the shell of plastic helmets. Due to the advantage of low weight and good ventilation, it is recommended that cane helmets be further developed to improve protection, wearability and durability, and subsequently be produced in large scale
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Bergquist, Karin, et al.
(författare)
-
A method for dynamic measurement of the resistance to dry heat exchange by footwear
- 1997
-
Ingår i: Applied Ergonomics. - 0003-6870 .- 1872-9126. ; 28:5-6, s. 383-388
-
Tidskriftsartikel (refereegranskat)abstract
- Five different types of cold protective footwear have been tested with regard to their resistance to dry heat loss (i.e. the insulation) with a new electrically heated foot model. The model is able to simulate ‘walking' movements in order to provide a more realistic simulation of wear conditions. Thermal insulation of shoes with and without a steel toe cap was the same. The insulating properties during simulated walking movements were 10-25% lower compared with static conditions. For two of the shoe models a significantly lower insulation value for the sole area was obtained when adding a weight of 30 kg. A significant difference could also be found between the insulation values of two different sizes of one of the models. Measurements with the standard method (EN 344) correlated well with the local insulation value of the sole part of the thermal foot. Correlation with the insulation value for the whole shoe was much less, variation was bigger and ranking in terms of cold protection differed between methods. The electrically heated foot model appears to provide a reproducible, accurate and more realistic method for measuring the insulation properties of shoes than EN 344.
|
|
| 5. |
- Bröde, Peter, et al.
(författare)
-
Deriving the operational procedure for the Universal Thermal Climate Index (UTCI)
- 2012
-
Ingår i: International Journal of Biometeorology. - : Springer Science and Business Media LLC. - 1432-1254 .- 0020-7128. ; 56:3, s. 481-494
-
Tidskriftsartikel (refereegranskat)abstract
- The Universal Thermal Climate Index (UTCI) aimed for a one-dimensional quantity adequately reflecting the human physiological reaction to the multi-dimensionally defined actual outdoor thermal environment. The human reaction was simulated by the UTCI-Fiala multi-node model of human thermoregulation, which was integrated with an adaptive clothing model. Following the concept of an equivalent temperature, UTCI for a given combination of wind speed, radiation, humidity and air temperature was defined as the air temperature of the reference environment, which according to the model produces an equivalent dynamic physiological response. Operationalising this concept involved (1) the definition of a reference environment with 50% relative humidity (but vapour pressure capped at 20 hPa), with calm air and radiant temperature equalling air temperature and (2) the development of a one-dimensional representation of the multivariate model output at different exposure times. The latter was achieved by principal component analyses showing that the linear combination of 7 parameters of thermophysiological strain (core, mean and facial skin temperatures, sweat production, skin wettedness, skin blood flow, shivering) after 30 and 120 min exposure time accounted for two-thirds of the total variation in the multi-dimensional dynamic physiological response. The operational procedure was completed by a scale categorising UTCI equivalent temperature values in terms of thermal stress, and by providing simplified routines for fast but sufficiently accurate calculation, which included look-up tables of pre-calculated UTCI values for a grid of all relevant combinations of climate parameters and polynomial regression equations predicting UTCI over the same grid. The analyses of the sensitivity of UTCI to humidity, radiation and wind speed showed plausible reactions in the heat as well as in the cold, and indicate that UTCI may in this regard be universally useable in the major areas of research and application in human biometeorology.
|
|
| 6. |
- Bröde, Peter, et al.
(författare)
-
Heat gain from thermal radiation through protective clothing with different insulation, reflectivity and vapour permeability
- 2010
-
Ingår i: International Journal of Occupational Safety and Ergonomics. - 2376-9130. ; 16:2, s. 231-244
-
Tidskriftsartikel (refereegranskat)abstract
- The heat transferred through protective clothing under long wave radiation compared to a reference condition without radiant stress was determined in thermal manikin experiments. The influence of clothing insulation and reflectivity, and the interaction with wind and wet underclothing were considered. Garments with different outer materials and colours and additionally an aluminised reflective suit were combined with different number and types of dry and pre-wetted underwear layers. Under radiant stress, whole body heat loss decreased, i.e., heat gain occurred compared to the reference. This heat gain increased with radiation intensity, and decreased with air velocity and clothing insulation. Except for the reflective outer layer that showed only minimal heat gain over the whole range of radiation intensities, the influence of the outer garments’ material and colour was small with dry clothing. Wetting the underclothing for simulating sweat accumulation, however, caused differing effects with higher heat gain in less permeable garments.
|
|
| 7. |
- Bröde, Peter, et al.
(författare)
-
Heat transfer through protective clothing under symmetric and asymmetric long wave thermal radiation
- 2008
-
Ingår i: Zeitschrift für Arbeitswissenschaft. - 0340-2444. ; 62:4, s. 267-276
-
Tidskriftsartikel (refereegranskat)abstract
- This report considers results of an ED funded research on thermal properties ofprotective clothing and their use in the assessment of the thermal strain at work. In order to study the effects of the asymmetry oflong wave thermal radiation on the heat transfer through protective clothing, the heat loss under all-side and unilaterally applied radiation with the same incident radiant power of 279 W/m2 was measured with a thermal manikin and compared to a reference condition where mean radiant temperature was equal to air temperature. With exposure to radiation a lowered heat loss, i.e. heat gain for the whole covered body area was observed, which did not depend on radiant asymmetry for the dry as well as for the combined dry and evaporative heat loss, and which was attenuated when wearing a more insulating underwear. However, under one-sided radiation a more inhomogeneous spatial distribution occurred with higher heat gains and higher surface temperatures at the irradiated body parts. Practical Relevance The direction ofthermal radiation in the horizontal plane may be neglected when assessing the physiological heat strain in protective clothing by heat budget models. In contrast to this, it may be advisable to consider radiant asymmetries with respect to thermal comfort with low intensity radiation, and the most intense radiant source when assessing the risk of skin burns.
|
|
| 8. |
- Bröde, Peter, et al.
(författare)
-
Non-evaporative effects of a wet mid layer on heat transfer through protective clothing
- 2008
-
Ingår i: European Journal of Applied Physiology. - : Springer Science and Business Media LLC. - 1439-6327 .- 1439-6319. ; 104:2, s. 341-349
-
Tidskriftsartikel (refereegranskat)abstract
- In order to assess the non-evaporative components of the reduced thermal insulation of wet clothing, experiments were performed with a manikin and with human subjects in which two layers of underwear separated by an impermeable barrier were worn under an impermeable overgarment at 20 °C, 80% RH and 0.5 ms-1 air velocity. By comparing manikin measurements with dry and wetted mid underwear layer, the increase in heat loss caused by a wet layer kept away from the skin was determined, which turned out to be small (5-6 Wm-2), irrespective of the inner underwear layer being dry or wetted, and was only one third of the evaporative heat loss calculated from weight change, i.e. evaporative cooling efficiency was far below unity. In the experiments with 8 males, each subject participated in two sessions with the mid underwear layer either dry or wetted, where they stood still for the first 30 minutes and then performed treadmill work for 60 minutes. Reduced heat strain due to lower insulation with the wetted mid layer was observed with decreased microclimate and skin temperatures, lowered sweat loss and cardiac strain. Accordingly, total clothing insulation calculated over the walking period from heat balance equations was reduced by 0.02 m2 °C W-1 (16%), while for the standing period the same decrease in insulation, representing 9% reduction only showed up after allowing for the lower evaporative cooling efficiency in the calculations. As evaporation to the environment and inside the clothing was restricted, the observed small alterations may be attributed to the wet mid layer’s increased conductivity, which, however, appears to be of minor importance compared to the evaporative effects in the assessment of the thermal properties of wet clothing.
|
|
| 9. |
- Chen, Fang, et al.
(författare)
-
A field study of cold effects among cold store workers in China
- 1991
-
Ingår i: Arctic Medical Research. - 0782-226X. ; 50:Suppl. 6, s. 99-103
-
Tidskriftsartikel (refereegranskat)abstract
- A field study was carried out among cold store workers in China. A self administrative questionnaire and health check-up were taken among 463 male workers from two different types of cold stores, all during their whole daily work. 296 men from Lower Temperature Stores (LTS), where the air temperature was between -10 to -25 degrees C, and 167 men from Ice Stores (IS), where the air temperature was between -5 and +5 degrees C participated. Another group of 152 men working in normal stores and exposed to an air temperature between 20 and 30 degrees C served as a control group. The study did not indicate any special disease attributable to the cold environment. The number of complaints of lower back pain and knee pain in the cold exposed group were significantly higher than that of the control group (in LTS: 42.3%, 46.6%; IS: 52.7%, 50.8%; control group: 9.2%, 14.5%; low back and knee pain, respectively). After 5 years of cold exposure work, the lower back and knee symptoms were very frequent. The point press pain on the knees of the cooler group (LTS) was higher than in the moderate cold group (IS). We suppose that the cold factor contributed to lower back and knee pain. 12.2% of 463 cold exposed workers had frostbite on the body extremities viz: hand, foot and ear. Self estimation of health indicated more problems among cold exposed workers (28.0%) than control group (2.7%).
|
|
| 10. |
- Gao, Chuansi, et al.
(författare)
-
Cooling vests with phase change material packs: the effects of temperature gradient, mass, and covering area
- 2010
-
Ingår i: Ergonomics. - : Informa UK Limited. - 0014-0139 .- 1366-5847. ; 53:5, s. 716-723
-
Tidskriftsartikel (refereegranskat)abstract
- Phase change material (PCM) absorbs or releases latent heat when it changes phases, making thermal-regulated clothing possible. The objective of this study was to quantify the relationships between PCM cooling rate and temperature gradient, mass, and covering area on a thermal manikin in a climatic chamber. Three melting temperatures (24, 28, 32 °C) of the PCMs, different mass, covering areas, and two manikin temperatures (34 and 38 °C) were used. The results showed that the cooling rate of the PCM vests tested is positively correlated with the temperature gradient between the thermal manikin and the melting temperature of the PCMs. The required temperature gradient is suggested to be greater than 6 °C when PCM vests are used in hot climates. With the same temperature gradient, the cooling rate is mainly determined by the covering area. The duration of the cooling effect is dependent on PCM mass and the latent heat
|
|
