| 1. |
- Aasmundtveit, K.E., et al.
(författare)
-
Structural anisotropy of poly(alkylthiophene) films
- 2000
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 33:8, s. 3120-3127
-
Tidskriftsartikel (refereegranskat)abstract
- The structural anisotropy of various poly(alkylthiophene) films have been studied by X-ray diffraction, using both conventional methods and synchrotron radiation at grazing incidence. Solution-cast films orient with the side chains preferably normal to the film surface, whereas spin-cast films of nonstereoregular material orient with both the main and the side chains in the film plane. For thick (10-50 µm) solution-cast films, the degree of orientation depends strongly on the solvent used for casting, and on the stereoregularity of the polymer, films of stereoregular materials being more oriented than those of nonregular materials. The most oriented nonregular films are those cast from mixtures of chloroform and tetrahydrofuran. Thin (50-500 nm) solution-cast films are more oriented than the thicker ones, and the effects of different stereoregularity or different casting solvents are small. For spin-cast films, the degree of orientation is independent of substrate and solvent. Spin-cast films of stereoregular material have two different phases: One with the side chains normal to the substrate, and another where they are parallel to the substrate. The diffraction peaks of spin-cast poly(octylthiophene) narrow considerably upon heating.
|
|
| 2. |
- Aasmundtveit, K.E., et al.
(författare)
-
Structural aspects of electrochemical doping and dedoping of poly(3,4-ethylenedioxythiophene)
- 2000
-
Ingår i: Synthetic metals. - 0379-6779 .- 1879-3290. ; 113:1, s. 93-97
-
Tidskriftsartikel (refereegranskat)abstract
- Electrochemical dedoping and redoping of p-toluene sulfonate doped poly(3,4-ethylenedioxythiophene) (PEDOT) has been studied with in situ grazing incidence diffraction with water used as an electrolyte. The diffraction peak positions and integrated intensities do not change significantly during doping and dedoping, while the peak widths increase upon dedoping and decrease upon doping. This implies that the lattice parameters and the relative positions of the polymer chains and the p-toluene sulfonate ions remain unchanged, the redox processes being carried out by the motion of smaller ions between the polymer and the electrolyte, and that the structural order decreases upon dedoping and increases upon doping in a reversible manner.
|
|
| 3. |
- Aasmundtveit, K.E., et al.
(författare)
-
Structural ordering in phenyl-substituted polythiophenes
- 2000
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 33:15, s. 5481-5489
-
Tidskriftsartikel (refereegranskat)abstract
- Various substituted poly(phenylthiophene)s have been studied by X-ray diffraction. They are semicrystalline, with very different degrees of crystallinity. Those with para-substituted phenyl groups have a low degree of crystallinity, whereas those with ortho-substituted phenyl groups are more crystalline. The most crystalline materials in this study have two equally long substituents on the phenyl ring, one at the ortho position and the other at the ortho or meta position on the opposite side of the phenyl ring. Poly(3-(2,5-dioctylphenyl)thiophene) (PDOPT) was most thoroughly studied, and a structural model is proposed. The structure of PDOPT is quite different from previously studied substituted polythiophenes in that the octyl side chains are directed normal to the thiophene planes. In this way, the conjugated polymer chains are kept separated from each other. Solution-cast and spin-cast PDOPT films are anisotropic, with the octyl side chains oriented normal to the film surface in both cases. This is contrary to the situation for poly(3-alkylthiophene)s, where solution-cast and spin-cast films orient in different ways.
|
|
| 4. |
- Admassie, S., et al.
(författare)
-
Electrochromism in diffractive conducting polymer gratings
- 2004
-
Ingår i: Journal of the Electrochemical Society. - : The Electrochemical Society. - 0013-4651 .- 1945-7111. ; 151:6
-
Tidskriftsartikel (refereegranskat)abstract
- The electrochromic polymer poly(3,4-ethylenedioxythiophene)-poly(styrene sulfonate) (PEDOT-PSS) spin-coated on ITO/glass was patterned with a soft lithographic method in order to diffract the incident light and thereby modify absorption of light by the film to improve the electrochromic efficiency of the polymer. The absorbance peak at around 610 nm was found to be much higher in the patterned PEDOT-PSS film than the one observed in the unpatterned film. Values of coloration efficiencies varying from 107 to 174 cm2/C were obtained for three different unpatterned PEDOT-PSS films, whereas for three different patterned PEDOT-PSS films higher values ranging from 211 to 371 cm2/C were found. These increased values of the electrochromic efficiencies are attributed to diffraction. © 2004 The Electrochemical Society. All rights reserved.
|
|
| 5. |
- Andersson, M.R., et al.
(författare)
-
The effect of the polymerisation temperature on molecular weight and photoluminescence quantum yield for a phenylsubstituted PPV
- 2001
-
Ingår i: Synthetic metals. - 0379-6779 .- 1879-3290. ; 119:1-3, s. 63-64
-
Tidskriftsartikel (refereegranskat)abstract
- We present the synthesis and characterisation of poly(2-(2',5'-bis(2?-ethylhexyloxy)phenyl)-1, 4-phenylenevinylene) (BEHP-PPV) polymerised under different conditions. The photoluminescence efficiencies (?PL) in the solid state of BEHP-PPV obtained at 144°C and 0°C are 28% and 60%, respectively. Polymerisation temperatures below 0°C decreases the molecular weight without changing the photoluminescence efficiency to any large extent.
|
|
| 6. |
- Asberg, D.P., et al.
(författare)
-
PEDOT/PSS hydrogel networks as 3-D enzyme electrodes
- 2003
-
Konferensbidrag (refereegranskat)abstract
- A mesoscopic network in the form of a hydrogel of the highly conductive polymer PEDOT/PSS hydrogel was used in an enzyme electrode setup. Osmium was used both as a crosslink point in the hydrogel network and as a mediator between the prosthetic group of the enzyme and the conductive polymer matrix. Both biostability and high conductivity is important aspects when building nerve- or cell- electrodes. Diffusion of analytes surrounding the cells into the matrix electrode is feasible due to the open hydrogel structure. The high water content in these structures is important when buffering them to a pH of choice.
|
|
| 7. |
- Bolognesi, A., et al.
(författare)
-
High photoluminescence efficiency in substituted polythiophene aggregates
- 2003
-
Ingår i: Synthetic metals. - 0379-6779 .- 1879-3290. ; 139:2, s. 303-310
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper we discuss the optical (absorption and photoluminescence) and solvatochromic properties of a newly synthesized alternating copolymer based on poly(3-alkylthiophene) structure. In this copolymer an unsubstituted thiophene ring is linked to a 3-alkyl-substituted thiophene, the two repeating units being alternated in the copolymer chains. Moreover, a bulky group, THP, with high steric hindrance has been introduced in the side chain. This copolymer, designed to preserve the backbone planarity of polythiophenes and to prevent a close packing arrangement through the non-regioregular insertion of the bulky substituted monomer, shows high PL quantum yield in the solid state and in solution aggregates. The electroluminescence of this copolymer is reported for a simple single layer device. © 2003 Elsevier Science B.V. All rights reserved.
|
|
| 8. |
- Chen, LC, et al.
(författare)
-
Excitation transfer in polymer photodiodes for enhanced quantum efficiency
- 2000
-
Ingår i: Advanced Materials. - 0935-9648 .- 1521-4095. ; 12:15, s. 1110-
-
Tidskriftsartikel (refereegranskat)abstract
- The realization of polymer solar cells is the driving force behind this research. In an idea inspired by photosynthesis, the authors have constructed efficient bilayer photodiodes by a well-chosen combination of conjugated polymers (see Figure) in the donor layer. Forster energy transfer within the donor layer allows the absorbed light to be channeled to the C-60 acceptor layer, improving the total photoconversion of the blend device.
|
|
| 9. |
|
|
| 10. |
- Chen, LC, et al.
(författare)
-
Self organised polymer photodiodes for extended spectral coverage
- 2000
-
Ingår i: Thin Solid Films. - 0040-6090 .- 1879-2731. ; 363:1-2, s. 286-289
-
Tidskriftsartikel (refereegranskat)abstract
- We report the use of self organised blends of conjugated polymers for improving the spectral coverage of the solar spectrum, and in this way to enhance solar energy conversion efficiency in photodiodes and solar cells. (C) 2000 Elsevier Science S.A. All rights reserved.
|
|
