| 51. |
|
|
| 52. |
|
|
| 53. |
|
|
| 54. |
|
|
| 55. |
|
|
| 56. |
|
|
| 57. |
|
|
| 58. |
- Robles-Zurita, Jose, et al.
(författare)
-
SCOT : a comparison of cost-effectiveness from a large randomised phase III trial of two durations of adjuvant Oxaliplatin combination chemotherapy for colorectal cancer
- 2018
-
Ingår i: British Journal of Cancer. - : Springer Science and Business Media LLC. - 0007-0920 .- 1532-1827. ; 119:11, s. 1332-1338
-
Tidskriftsartikel (refereegranskat)abstract
- BACKGROUND: The Short Course Oncology Therapy (SCOT) study is an international, multicentre, non-inferiority randomised controlled trial assessing the efficacy, toxicity, and cost-effectiveness of 3 months (3 M) versus the usually given 6 months (6 M) of adjuvant chemotherapy in colorectal cancer.METHODS: In total, 6088 patients with fully resected high-risk stage II or stage III colorectal cancer were randomised and followed up for 3-8 years. The within-trial cost-effectiveness analysis from a UK health-care perspective is presented using the resource use data, quality of life (EQ-5D-3L), time on treatment (ToT), disease-free survival after treatment (DFS) and overall survival (OS) data. Quality-adjusted partitioned survival analysis and Kaplan-Meier Sample Average Estimator estimated QALYs and costs. Probabilistic sensitivity and subgroup analysis was undertaken.RESULTS: The 3M arm is less costly (-4881; pound 95% CI: -6269; pound -3492) pound and entails (non-significant) QALY gains (0.08; 95% CI: -0.086; 0.230) due to a better significant quality of life. The net monetary benefit was significantly higher in 3M under a wide range of monetary values of a QALY. The subgroup analysis found similar results for patients in the CAPOX regimen. However, for the FOLFOX regimen, 3M had lower QALYs than 6M (not statistically significant).CONCLUSIONS: Overall, 3M dominates 6M with no significant detrimental impact on QALYs. The results provide the economic case that a 3M treatment strategy should be considered a new standard of care.
|
|
| 59. |
- Streeter, M. J.V., et al.
(författare)
-
Characterization of laser wakefield acceleration efficiency with octave spanning near-IR spectrum measurements
- 2022
-
Ingår i: Physical Review Accelerators and Beams. - 2469-9888. ; 25:10
-
Tidskriftsartikel (refereegranskat)abstract
- We report on experimental measurements of energy transfer efficiencies in a GeV-class laser wakefield accelerator. Both the transfer of energy from the laser to the plasma wakefield and from the plasma to the accelerated electron beam was diagnosed by simultaneous measurement of the deceleration of laser photons and the acceleration of electrons as a function of plasma length. The extraction efficiency, which we define as the ratio of the energy gained by the electron beam to the energy lost by the self-guided laser mode, was maximized at 19±3% by tuning the plasma density and length. The additional information provided by the octave-spanning laser spectrum measurement allows for independent optimization of the plasma efficiency terms, which is required for the key goal of improving the overall efficiency of laser wakefield accelerators.
|
|
| 60. |
- Sudireddy, B. R., et al.
(författare)
-
Development of Robust Metal-Supported SOFCs and Stack Components in EU METSAPP Consortium
- 2017
-
Ingår i: Fuel Cells. - : Wiley. - 1615-6846 .- 1615-6854. ; 17:4, s. 508-516
-
Tidskriftsartikel (refereegranskat)abstract
- The potential of MS-SOFCs was demonstrated through the previous EU METSOFC project, which concluded that the development of oxidation resistant novel metal-supported solid oxide fule cell (MS-SOFC) design and stack is the requirement to advance this technology to the next level. The following EU METSAPP project has been executed with an overall aim of developing advanced metal-supported cells and stacks based on a robust, reliable and up-scalable technology. During the project, oxidation resistant nanostructured anodes based on modified SrTiO3 were developed and integrated into MS-SOFCs to enhance their robustness. In addition, the manufacturing of metal-supported cells with different geometries, scalability of the manufacturing process was demonstrated and more than 200 cells with an area of approximate to 150 cm(2) were produced. The electrochemical performance of different cell generations was evaluated and best performance and stability combination was observed with doped SrTiO3 based anode designs. Furthermore, numerical models to understand the corrosion behavior of the MS-SOFCs were developed and validated. Finally, the cost effective concept of coated metal interconnects was developed, which resulted in 90% reduction in Cr evaporation, three times lower Cr2O3 scale thickness and increased lifetime. The possibility of assembling these cells into two radically different stack designs was demonstrated.
|
|
