| 51. |
|
|
| 52. |
|
|
| 53. |
- Brenning, Nils, et al.
(författare)
-
The role of Ohmic heating in dc magnetron sputtering
- 2016
-
Ingår i: Plasma sources science & technology. - : Institute of Physics Publishing (IOPP). - 0963-0252 .- 1361-6595. ; 25:6
-
Tidskriftsartikel (refereegranskat)abstract
- Sustaining a plasma in a magnetron discharge requires energization of the plasma electrons. In this work, Ohmic heating of electrons outside the cathode sheath is demonstrated to be typically of the same order as sheath energization, and a simple physical explanation is given. We propose a generalized Thornton equation that includes both sheath energization and Ohmic heating of electrons. The secondary electron emission yield gamma(SE) is identified as the key parameter determining the relative importance of the two processes. For a conventional 5 cm diameter planar dc magnetron, Ohmic heating is found to be more important than sheath energization for secondary electron emission yields below around 0.1.
|
|
| 54. |
- Brenning, Nils, et al.
(författare)
-
Understanding deposition rate loss in high power impulse magnetron sputtering : I. Ionization-driven electric fields
- 2012
-
Ingår i: Plasma sources science & technology. - : IOP Publishing. - 0963-0252 .- 1361-6595. ; 21:2, s. 025005-
-
Tidskriftsartikel (refereegranskat)abstract
- The lower deposition rate for high power impulse magnetron sputtering (HiPIMS) compared with direct current magnetron sputtering for the same average power is often reported as a drawback. The often invoked reason is back-attraction of ionized sputtered material to the target due to a substantial negative potential profile, sometimes called an extended presheath, from the location of ionization toward the cathode. Recent studies in HiPIMS devices, using floating-emitting and swept-Langmuir probes, show that such extended potential profiles do exist, and that the electric fields E-z directed toward the target can be strong enough to seriously reduce ion transport to the substrate. However, they also show that the potential drops involved can vary by up to an order of magnitude from case to case. There is a clear need to understand the underlying mechanisms and identify the key discharge variables that can be used for minimizing the back-attraction. We here present a combined theoretical and experimental analysis of the problem of electric fields E-z in the ionization region part of HiPIMS discharges, and their effect on the transport of ionized sputtered material. In particular, we have investigated the possibility of a 'sweet spot' in parameter space in which the back-attraction of ionized sputtered material is low. It is concluded that a sweet spot might possibly exist for some carefully optimized discharges, but probably in a rather narrow window of parameters. As a measure of how far a discharge is from such a window, a Townsend product Pi(Townsend) is proposed. A parametric analysis of Pi(Townsend) shows that the search for a sweet spot is complicated by the fact that contradictory demands appear for several of the externally controllable parameters such as high/low working gas pressure, short/long pulse length, high/low pulse power and high/low magnetic field strength.
|
|
| 55. |
- Butler, Alexandre, et al.
(författare)
-
On three different ways to quantify the degree of ionization in sputtering magnetrons
- 2018
-
Ingår i: Plasma sources science & technology. - : IOP PUBLISHING LTD. - 0963-0252 .- 1361-6595. ; 27:10
-
Tidskriftsartikel (refereegranskat)abstract
- Quantification and control of the fraction of ionization of the sputtered species are crucial in magnetron sputtering, and in particular in high-power impulse magnetron sputtering (HiPIMS), yet proper definitions of the various concepts of ionization are still lacking. In this contribution, we distinguish between three approaches to describe the degree (or fraction) of ionization: the ionized flux fraction F-flux, the ionized density fraction F-density, and the fraction a of the sputtered metal atoms that become ionized in the plasma (sometimes referred to as probability of ionization). By studying a reference HiPIMS discharge with a Ti target, we show how to extract absolute values of these three parameters and how they vary with peak discharge current. Using a simple model, we also identify the physical mechanisms that determine F-flux, F-density, and a as well as how these three concepts of ionization are related. This analysis finally explains why a high ionization probability does not necessarily lead to an equally high ionized flux fraction or ionized density fraction.
|
|
| 56. |
- Böhlmark, Johan, et al.
(författare)
-
Measurement of the magnetic field change in a pulsed high current magnetron discharge
- 2004
-
Ingår i: Plasma Sources Science and Technology. - : IOP Publishing. - 0963-0252 .- 1361-6595. ; 13:4, s. 654-661
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper we present a study of how the magnetic field of a circular planar magnetron is affected when it is exposed to a pulsed high current discharge. Spatially resolved magnetic field measurements are presented and the magnetic disturbance is quantified for different process parameters. The magnetic field is severely deformed by the discharge and we record changes of several millitesla, depending on the spatial location of the measurement. The shape of the deformation reveals the presence of azimuthally drifting electrons close to the target surface. Time resolved measurements show a transition between two types of magnetic perturbations. There is an early stage that is in phase with the axial discharge current and a late stage that is not in phase with the discharge current. The later part of the magnetic field deformation is seen as a travelling magnetic wave. We explain the magnetic perturbations by a combination of E × B drifting electrons and currents driven by plasma pressure gradients and the shape of the magnetic field. A plasma pressure wave is also recorded by a single tip Langmuir probe and the velocity (~103 m s−1) of the expanding plasma agrees well with the observed velocity of the magnetic wave. We note that the axial (discharge) current density is much too high compared to the azimuthal current density to be explained by classical collision terms, and an anomalous charge transport mechanism is required.
|
|
| 57. |
- Böhlmark, Johan, et al.
(författare)
-
The ion energy distributions and ion flux composition from a high power impulse magnetron sputtering discharge
- 2006
-
Ingår i: Thin Solid Films. - : Elsevier BV. - 0040-6090 .- 1879-2731. ; 515:4, s. 1522-1526
-
Tidskriftsartikel (refereegranskat)abstract
- The energy distribution of sputtered and ionized metal atoms as well as ions from the sputtering gas is reported for a high power impulse magnetron sputtering (HIPIMS) discharge. High power pulses were applied to a conventional planar circular magnetron Ti target. The peak power on the target surface was 1-2 kW/cm(2) with a duty factor of about 0.5%. Time resolved, and time averaged ion energy distributions were recorded with an energy resolving quadrupole mass spectrometer. The ion energy distributions recorded for the HIPIMS discharge are broader with maximum detected energy of 100 eV and contain a larger fraction of highly energetic ions (about 50% with E-i > 20 eV) as compared to a conventional direct current magnetron sputtering discharge. The composition of the ion flux was also determined, and reveals a high metal fraction. During the most intense moment of the discharge, the ionic flux consisted of approximately 50% Ti1+, 24% Ti2+, 23% Ar1+, and 3% Ar2+ ions.
|
|
| 58. |
- Du, Hao, et al.
(författare)
-
Bipolar HiPIMS : The role of capacitive coupling in achieving ion bombardment during growth of dielectric thin films
- 2021
-
Ingår i: Surface & Coatings Technology. - : Elsevier BV. - 0257-8972 .- 1879-3347. ; 416
-
Tidskriftsartikel (refereegranskat)abstract
- Bipolar high-power impulse magnetron sputtering (HiPIMS) is used to achieve ion acceleration for ion bombardment of dielectric thin films. This is realized by increasing the plasma potential (U-p), during the interval in-between the HiPIMS-pulses, using a positive reversed voltage (U-rev). As long as the film surface potential (U-s) is maintained low, close to ground potential, this increase in U-p results in ion-acceleration as ions approach the film surface. The effect of U-rev on the ion bombardment is demonstrated by the growth of dielectric (Al,Cr)(2)O-3 films on two sets of substrates, Si (001) and sapphire (0001) utilizing a U-rev ranging from 0 to 300 V. A clear ion bombardment effect is detected in films grown on the conductive Si substrate, while no, or a very small, effect is observed in films grown on the dielectric sapphire substrate. This is ascribed to the changes in U-s when the substrate is subjected to the bombardment of positive ions. For a film surface that has a high capacitance to ground, U-s remains close to ground potential for an extended time in-between the HiPIMS pulses, while if the capacitance is low, U-s quickly attains floating potential (U-float) close to U-p. The simulated temporal evolutions of U-s for the films by using capacitors show that for a 1 mu m thick (Al,Cr)(2)O-3 film on a conductive substrate, U-s is maintained close to ground potential during the entire 20 mu s that U-rev is applied after the HiPIMS pulse. On the other hand, when a capacitance corresponding to the 0.5 mm thick sapphire substrate is used, U-s rapidly attains a potential close to U-rev.
|
|
| 59. |
- Ekeroth, Sebastian, 1988-, et al.
(författare)
-
Catalytic nanotruss structures realized by magnetic self-assembly in pulsed plasma
- 2018
-
Ingår i: Nano Letters. - : American Chemical Society (ACS). - 1530-6984 .- 1530-6992. ; 18:5, s. 3132-3137
-
Tidskriftsartikel (refereegranskat)abstract
- Tunable nanostructures that feature a high surface area are firmly attached to a conducting substrate and can be fabricated efficiently over significant areas, which are of interest for a wide variety of applications in, for instance, energy storage and catalysis. We present a novel approach to fabricate Fe nanoparticles using a pulsed-plasma process and their subsequent guidance and self-organization into well-defined nanostructures on a substrate of choice by the use of an external magnetic field. A systematic analysis and study of the growth procedure demonstrate that nondesired nanoparticle agglomeration in the plasma phase is hindered by electrostatic repulsion, that a polydisperse nanoparticle distribution is a consequence of the magnetic collection, and that the formation of highly networked nanotruss structures is a direct result of the polydisperse nanoparticle distribution. The nanoparticles in the nanotruss are strongly connected, and their outer surfaces are covered with a 2 nm layer of iron oxide. A 10 μm thick nanotruss structure was grown on a lightweight, flexible and conducting carbon-paper substrate, which enabled the efficient production of H2 gas from water splitting at a low overpotential of 210 mV and at a current density of 10 mA/cm2.
|
|
| 60. |
- Ekeroth, Sebastian, et al.
(författare)
-
Magnetically Collected Platinum/Nickel Alloy Nanoparticles as Catalysts for Hydrogen Evolution
- 2021
-
Ingår i: ACS Applied Nano Materials. - : American Chemical Society (ACS). - 2574-0970. ; 4:12, s. 12957-12965
-
Tidskriftsartikel (refereegranskat)abstract
- The hydrogen evolution reaction (HER) is a key process in electrochemical water splitting. To lower the cost and environmental impact of this process, it is highly motivated to develop electrocatalysts with low or no content of noble metals. Here, we report on an ingenious synthesis of hybrid PtxNi1-x electrocatalysts in the form of a nanoparticle-nanonetwork structure with very low noble metal content. The structure possesses important features such as good electrical conductivity, high surface area, strong interlinking, and substrate adhesion, which render an excellent HER activity. Specifically, the best performing Pt0.05Ni0.95 sample demonstrates a Tafel slope of 30 mV dec-1 in 0.5 M H2SO4 and an overpotential of 20 mV at a current density of 10 mA cm-2 with high stability. The impressive catalytic performance is further rationalized in a theoretical study, which provides insight into the mechanism on how such small platinum content can allow for close-to-optimal adsorption energies for hydrogen.
|
|
