| 1. |
- Ansari, Rafay Iqbal, et al.
(författare)
-
Control-Data Separation Architecture for Dual-Band mmWave Networks : A New Dimension to Spectrum Management
- 2019
-
Ingår i: IEEE Access. - 2169-3536. ; 7, s. 34925-34937
-
Tidskriftsartikel (refereegranskat)abstract
- The exponential growth in global mobile data traffic, especially with regards to the massive deployment of devices envisioned for the fifth generation (5G) mobile networks, has given impetus to exploring new spectrum opportunities to support the new traffic demands. The millimeter wave (mmWave) frequency band is considered as a potential candidate for alleviating the spectrum scarcity. Moreover, the concept of multi-tier networks has gained popularity, especially for dense network environments. In this article, we deviate from the conventional multi-tier networks and employ the concept of control-data separation architecture (CDSA), which comprises of a control base station (CBS) overlaying the data base station (DBS). We assume that the CBS operates on the sub-6 GHz single band, while the DBS possesses a dual-band mmWave capability, i.e., 26 GHz unlicensed band and 60 GHz licensed band. We formulate a multi-objective optimization (MOO) problem, which jointly optimizes conflicting objectives: the spectral efficiency (SE) and the energy efficiency (EE). The unique aspect of this work includes the analysis of a joint radio resource allocation algorithm based on Lagrangian Dual Decomposition (LDD) and we compare the proposed algorithm with the maximal-rate (maxRx), dynamic sub-carrier allocation (DSA) and joint power and rate adaptation (JPRA) algorithms to show the performance gains achieved by the proposed algorithm.
|
|
| 2. |
- Azeem, Muhammad, et al.
(författare)
-
Chemical composition and repellent activity of native plants essential against dengue mosquito, Aedes aegypti
- 2019
-
Ingår i: Industrial crops and products (Print). - : Elsevier BV. - 0926-6690 .- 1872-633X. ; 140
-
Tidskriftsartikel (refereegranskat)abstract
- Aedes aegypti L. (Diptera: Culicidae) mosquito is an important vector of chikungunya, dengue and yellow fever. Plant based essential oils may serve as good alternatives to commercially available mosquito repellent, DEET. Steam distillation was used for the extraction of essential oils from fresh collected aerial parts of plants viz Chenopodium ambrosioides, Conyza sumatrensis, Erigeron canadensis, Eucalyptus camaldulensis, Mentha spicata, Parthenium hysterophorus, and Tagetes minuta. The essential oils were tested for mosquito repellent activity against laboratory reared female Ae. aegypti by human bait technique. Identification of chemical constituents of essential oils was carried out by gas chromatography-mass spectrometry (GC-MS). The essential oil of M. spicata, E. canadensis, P. hysterophorus, C. sumatrensis, T. minuta, C. ambrosioides, and E. camaldulensis exhibited 100%, 80%, 63.9%, 51.4%, 50.2%, 39.7%, and 13.7% mosquito repellent activity respectively, at the tested dose of 30 mu g/cm(2). The most abundant constituents of M. spicata, E. canadensis, P. hysterophorus, C. sumatrensis and T. minuta essential oils were piperitenone oxide (47.1%), limonene (41.3%), germacrene D (36.6%), cis-lachnophyllum ester (33.3%) and dihydrotagetone (20.9%) respectively. M. spicata essential oil completely inhibited the attractiveness of human hands toward female mosquitoes for more than 45 min thus showed bioactivity comparable to that of commercially used mosquito repellent, DEET. This study suggests that the dilute solution of M. spicata essential oil could be used as potent mosquito repellent against Ae. aegypti alternative to commercially available synthetic mosquito repellents.
|
|
| 3. |
- Gowin, Krisstina, et al.
(författare)
-
Survival following allogeneic transplant in patients with myelofibrosis
- 2020
-
Ingår i: Blood Advances. - : AMER SOC HEMATOLOGY. - 2473-9529 .- 2473-9537. ; 4:9, s. 1965-1973
-
Tidskriftsartikel (refereegranskat)abstract
- Allogeneic hematopoietic cell transplantation (HCT) is the only curative therapy for myelofibrosis (MF). In this large multicenter retrospective study, overall survival (OS) in MF patients treated with allogeneic HCT (551 patients) and without HCT (non-HCT) (1377 patients) was analyzed with Cox proportional hazards model. Survival analysis stratified by the Dynamic International Prognostic Scoring System (DIPSS) revealed that the first year of treatment arm assignment, due to upfront risk of transplant-related mortality (TRM), HCT was associated with inferior OS compared with non-HCT (non-HCT vs HCT: DIPSS intermediate 1 [Int-1]: hazard ratio [HR] = 0.26, P < .0001; DIPSS-Int-2 and higher: HR, 0.39, P < .0001). Similarly, in the DIPSS low-risk MF group, due to upfront TRM risk, OS was superior with non-HCT therapies compared with HCT in the first-year post treatment arm assignment (HR, 0.16, P = .006). However, after 1 year, OS was not significantly different (HR, 1.38, P = .451). Beyond 1 year of treatment arm assignment, an OS advantage with HCT therapy in Int-1 and higher DIPSS score patients was observed (non-HCT vs HCT: DIPSS-Int-1: HR, 2.64, P < .0001; DIPSS-Int-2 and higher: HR, 2.55, P < .0001). In conclusion, long-term OS advantage with HCT was observed for patients with Int-1 or higher risk MF, but at the cost of early TRM. The magnitude of OS benefit with HCT increased as DIPSS risk score increased and became apparent with longer follow-up.
|
|
| 4. |
- Khan, Sabih Ahmad, et al.
(författare)
-
Investigation of the mechanical behavior of FDM processed CFRP/Al hybrid joint at elevated temperatures
- 2023
-
Ingår i: Thin-walled structures. - : Elsevier BV. - 0263-8231 .- 1879-3223. ; 192
-
Tidskriftsartikel (refereegranskat)abstract
- This research is focused on investigating the mechanical behavior of Fused Deposition Modeling (FDM) processed CFRP/Al hybrid riveted joints at elevated temperatures. A two-pronged approach was adopted entailing experimental and computational domains. In the experimental thrust, the developed joint was evaluated for its mechanical behavior by employing Digital Image Correlation, micro-XCT, and fractographic analysis. The tensile testing was performed at four different temperatures, i.e., Room Temperature (RT), 50°C, 75°C, and 100 °C. At RT, the joint experienced net-sectioning in the CFRP sheet along with minute secondary bending. Further, distinct failure modes were noticed for each ply orientation where the inherent porosity/voids appeared as the governing factor for the damage progression. Novel constitutive models were developed using accrued strain and change in energy dissipation to estimate the damage progression. The damage accumulation was found to be more uniform in the 0° layer as compared to 90°. Moreover, the 90° layer exhibited a more catastrophic damage pattern toward final failure. At elevated temperatures, a significant reduction in mechanical properties along with a non-uniform warping/bending of the plies was noticed due to viscoelastic behavior change. The computational analysis, having a hierarchical approach, was performed for the validation of the experimental results, and both were found to be in good agreement.
|
|
