| 1. |
- Mantsinen, M. J., et al.
(författare)
-
Localized bulk electron heating with ICRF mode conversion in the JET tokamak
- 2004
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 44:1, s. 33-46
-
Tidskriftsartikel (refereegranskat)abstract
- Ion cyclotron resonance frequencies (ICRF) mode conversion has been developed for localized on-axis and off-axis bulk electron heating on the JET tokamak. The fast magnetosonic waves launched from the low-field side ICRF antennas are mode-converted to short-wavelength waves on the high-field side of the He-3 ion cyclotron resonance layer in D and He-4 plasmas and subsequently damped on the bulk electrons. The resulting electron power deposition, measured using ICRF power modulation, is narrow with a typical full-width at half-maximum of approximate to30 cm (i.e. about 30% of the minor radius) and the total deposited power to electrons comprises at least up to 80% of the applied ICRF power. The ICRF mode conversion power deposition has been kept constant using He-3 bleed throughout the ICRF phase with a typical duration of 4-6 s, i.e. 15-40 energy confinement times. Using waves propagating in the counter-current direction minimizes competing ion damping in the presence of co-injected deuterium beam ions.
|
|
| 2. |
- Rantamäki, K., et al.
(författare)
-
LH wave coupling over ITER-like distances at JET
- 2007
-
Ingår i: Radio Frequency Power in Plasmas. - : American Institute of Physics (AIP). - 0735404445 - 9780735404441 ; , s. 261-264
-
Konferensbidrag (refereegranskat)abstract
- Good coupling of LH power at plasma-launcher distance of 15 cm has been obtained at JET. Near-gas injection is used to increase the density in front of the grill. The role of LH power in the density increase at constant gas level is demonstrated. For the first time at JET the temperature of the hot spots caused by parasitic absorption of LH power has been measured.
|
|
| 3. |
- Coad, J. P., et al.
(författare)
-
Erosion and deposition in the JET MkII-SRP divertor
- 2007
-
Ingår i: Journal of Nuclear Materials. - : Elsevier BV. - 0022-3115 .- 1873-4820. ; 363, s. 287-293
-
Tidskriftsartikel (refereegranskat)abstract
- Carbon-13 labelled methane was injected into the outer divertor during a series of H-mode discharges on the last day of operations with the JET MkII-SRP divertor. Tiles from around the vessel were removed during the subsequent shutdown and surface deposits were analysed by IBA techniques and SIMS. First attempts to model the pattern of 13 C deposition using EDGE2D are reported. Erosion of W markers at the outer divertor was observed, with implications for the ITER-like wall experiment planned for JET, whilst thin film growth in the same region has been followed by the effect on infrared measurements. The composition of thick films deposited at the inner divertor during the MkII-SRP campaign, and the migration to the inner corner of the divertor observed by a quartz micro-balance, provide further information on divertor transport. Crown
|
|
| 4. |
- McDonald, C., et al.
(författare)
-
ELMy H-modes in JET helium-4 plasmas
- 2004
-
Ingår i: Plasma Physics and Controlled Fusion. - : IOP Publishing. - 0741-3335 .- 1361-6587. ; 46:3, s. 519-534
-
Tidskriftsartikel (refereegranskat)abstract
- ELMy H-modes in helium-4 plasmas provide valuable information on ELMy H-mode physics as well as a possible early low activation operational phase for next-step tokamaks, such as ITER. With this in mind, a series of helium-4 H-mode experiments were performed on JET with pure helium-4 NBI auxiliary heating (up to 12 MW). A set of ELMy H-mode plasmas were produced, in both the Type I ELM regime and a second regime, which showed characteristics similar to the deuterium Type III regime, but with a reverse ELM frequency dependence on power. Sawteeth were also observed, and had similar behaviour to those seen in deuterium. Compared with deuterium plasmas, Type I ELMy H-mode confinement is seen to be 28 +/- 6% poorer in helium-4 plasmas and the L-H power threshold 42 +/- 10% larger. This is the opposite of the behaviour predicted by experimental isotope mass scalings from hydrogenic plasmas.Comparison with a wider hydrogenic database, enables the effects of isotopic charge and mass to be studied independently.
|
|
| 5. |
- Rubel, Marek J., et al.
(författare)
-
Beryllium and carbon films in JET following D-T operation
- 2003
-
Ingår i: Journal of Nuclear Materials. - 0022-3115 .- 1873-4820. ; 313, s. 321-326
-
Tidskriftsartikel (refereegranskat)abstract
- After the D-T operation (DTE-1 campaign) at JET a large number of limiter and divertor tiles were dismounted from the torus for ex situ examination. The relative distributions of deuterium, tritium, beryllium and carbon are presented and discussed. Significant asymmetry observed in the distribution of erosion and deposition zones indicates preferential flow of the deuterium background plasma and impurities towards the inner divertor leg. The comparison of the beryllium content on the limiter tiles from the main chamber and the content of this element on the inner divertor tiles clearly proves the beryllium erosion from the main chamber wall and its transport to the divertor. However, no beryllium is detected in the shadowed regions of the divertor where the formation of thick and fuel-rich carbon films occurs. This is interpreted in terms of different mechanisms governing the erosion and transport of Be and C. The results allow a conclusion that the operation with a full beryllium wall would lead to a significantly decreased fuel inventory due to removal of the carbon source.
|
|
