| 1. |
- Le Lay, G., et al.
(författare)
-
STM and synchrotron radiation studies of "prototypical" metal{plus 45 degree rule}semiconductor systems
- 1994
-
Ingår i: Surface Science. - 0039-6028. ; 307-309:PART A, s. 280-294
-
Tidskriftsartikel (refereegranskat)abstract
- Since the origin of surface science noble metal{plus 45 degree rule}elemental semiconductor couples have been considered as "prototypical" systems. After three decades of research their structural and electronic properties remain an intriguing maze despite recent advances made, especially thanks to the development of the near-field microscopies and the extensive use of synchrotron radiation in surface crystallography and in high-resolution photoelectron spectroscopy. In the last few years, lead, as a replacement inert metal, has nearly gained the pole position in the display of exotic behaviour. This paper gives a flavour of this mystery story and highlights some puzzling questions. © 1994.
|
|
| 2. |
- Dzhigaev, D., et al.
(författare)
-
Bragg coherent x-ray diffractive imaging of a single indium phosphide nanowire
- 2016
-
Ingår i: Journal of Optics. - : IOP Publishing. - 2040-8978 .- 2040-8986. ; 18:6
-
Tidskriftsartikel (refereegranskat)abstract
- Three-dimensional (3D) Bragg coherent x-ray diffractive imaging (CXDI) with a nanofocused beam was applied to quantitatively map the internal strain field of a single indium phosphide nanowire. The quantitative values of the strain were obtained by pre-characterization of the beam profile with transmission ptychography on a test sample. Our measurements revealed the 3D strain distribution in a region of 150 nm below the catalyst Au particle. We observed a slight gradient of the strain in the range of 0.6% along the [111] growth direction of the nanowire. We also determined the spatial resolution in our measurements to be about 10 nm in the direction perpendicular to the facets of the nanowire. The CXDI measurements were compared with the finite element method simulations and show a good agreement with our experimental results. The proposed approach can become an effective tool for in operando studies of the nanowires.
|
|
| 3. |
- Aasmundtveit, K.E., et al.
(författare)
-
Structural anisotropy of poly(alkylthiophene) films
- 2000
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 33:8, s. 3120-3127
-
Tidskriftsartikel (refereegranskat)abstract
- The structural anisotropy of various poly(alkylthiophene) films have been studied by X-ray diffraction, using both conventional methods and synchrotron radiation at grazing incidence. Solution-cast films orient with the side chains preferably normal to the film surface, whereas spin-cast films of nonstereoregular material orient with both the main and the side chains in the film plane. For thick (10-50 µm) solution-cast films, the degree of orientation depends strongly on the solvent used for casting, and on the stereoregularity of the polymer, films of stereoregular materials being more oriented than those of nonregular materials. The most oriented nonregular films are those cast from mixtures of chloroform and tetrahydrofuran. Thin (50-500 nm) solution-cast films are more oriented than the thicker ones, and the effects of different stereoregularity or different casting solvents are small. For spin-cast films, the degree of orientation is independent of substrate and solvent. Spin-cast films of stereoregular material have two different phases: One with the side chains normal to the substrate, and another where they are parallel to the substrate. The diffraction peaks of spin-cast poly(octylthiophene) narrow considerably upon heating.
|
|
| 4. |
- LELAY, G, et al.
(författare)
-
STM AND SYNCHROTRON-RADIATION STUDIES OF PROTOTYPICAL METAL-SEMICONDUCTOR SYSTEMS
- 1994
-
Ingår i: Surface Science. - : Elsevier BV. - 0039-6028 .- 1879-2758. ; 307, s. 280-294
-
Tidskriftsartikel (refereegranskat)abstract
- Since the origin of surface science noble metal/elemental semiconductor couples have been considered as ''prototypical'' systems. After three decades of research their structural and electronic properties remain an intriguing maze despite recent advances made, especially thanks to the development of the near-field microscopies and the ''tensive use of synchrotron radiation in surface crystallography and in high-resolution photoelectron spectroscopy. In the last few years, lead, as a replacement inert metal, has nearly gained the pole position in the display of exotic behaviour. This paper gives a flavour of this mystery story and highlights some puzzling questions.
|
|
| 5. |
- Pingel, Jessica, et al.
(författare)
-
Injection of high dose botulinum-toxin A leads to impaired skeletal muscle function and damage of the fibrilar and non-fibrilar structures
- 2017
-
Ingår i: Scientific Reports. - : Springer Science and Business Media LLC. - 2045-2322. ; 7:1
-
Tidskriftsartikel (refereegranskat)abstract
- Botulinum-toxin A (BoNT/A) is used for a wide range of conditions. Intramuscular administration of BoNT/A inhibits the release of acetylcholine at the neuromuscular junction from presynaptic motor neurons causing muscle-paralysis. The aim of the present study was to investigate the effect of high dose intramuscular BoNT/A injections (6 UI = 60 pg) on muscle tissue. The gait pattern of the rats was significantly affected 3 weeks after BoNT/A injection. The ankle joint rotated externally, the rats became flat footed, and the stride length decreased after BoNT/A injection. Additionally, there was clear evidence of microstructural changes on the tissue level by as evidenced by 3D imaging of the muscles by Synchrotron Radiation X-ray Tomographic Microscopy (SRXTM). Both the fibrillar and the non-fibrillar tissues were affected. The volume fraction of fibrillary tissue was reduced significantly and the non-fibrillar tissue increased. This was accompanied by a loss of the linear structure of the muscle tissue. Furthermore, gene expression analysis showed a significant upregulation of COL1A1, MMP-2, TGF-b1, IL-6, MHCIIA and MHCIIx in the BoNT/A injected leg, while MHVIIB was significantly downregulated. In conclusion: The present study reveals that high dose intramuscular BoNT/A injections cause microstructural damage of the muscle tissue, which contributes to impaired gait.
|
|
| 6. |
- Thomsen, M., et al.
(författare)
-
Prediction of beam hardening artefacts in computed tomography using Monte Carlo simulations
- 2015
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms. - : Elsevier BV. - 0168-583X. ; 342, s. 314-320
-
Tidskriftsartikel (refereegranskat)abstract
- We show how radiological images of both single and multi material samples can be simulated using the Monte Carlo simulation tool McXtrace and how these images can be used to make a three dimensional reconstruction. Good numerical agreement between the X-ray attenuation coefficient in experimental and simulated data can be obtained, which allows us to use simulated projections in the linearisation procedure for single material samples and in that way reduce beam hardening artefacts. The simulations can be used to predict beam hardening artefacts in multi material samples with complex geometry, illustrated with an example. Linearisation requires knowledge about the X-ray transmission at varying sample thickness, but in some cases homogeneous calibration phantoms are hard to manufacture, which affects the accuracy of the calibration. Using simulated data overcomes the manufacturing problems and in that way improves the calibration. (C) 2014 Elsevier B.V. All rights reserved.
|
|
| 7. |
- Thomsen, M., et al.
(författare)
-
Visualization of subcutaneous insulin injections by x-ray computed tomography
- 2012
-
Ingår i: Physics in Medicine and Biology. - : IOP Publishing. - 1361-6560 .- 0031-9155. ; 57:21, s. 7191-7203
-
Tidskriftsartikel (refereegranskat)abstract
- We report how the three-dimensional structure of subcutaneous injections of soluble insulin can be visualized by x-ray computed tomography using an iodine based contrast agent. The injections investigated are performed ex vivo in porcine adipose tissue. Full tomography scans carried out at a laboratory x-ray source with a total acquisition time of about 1 min yield CT-images with an effective pixel size of 109 x 109 mu m(2). The depots are segmented using a modified Chan-Vese algorithm and we are able to observe differences in the shape of the injection depot and the position of the depot in the skin among equally performed injections. To overcome the beam hardening artefacts, which affect the quantitative prediction of the volume injected, we additionally present results concerning the visualization of two injections using synchrotron radiation. The spatial concentration distribution of iodine is calculated to show the dilution of the insulin drug inside the depot. Characterisation of the shape of the depot and the spatial concentration profile of the injected fluid is important knowledge when improving the clinical formulation of an insulin drug, the performance of injection devices and when predicting the effect of the drug through biomedical simulations.
|
|
