| 1. |
- Kakanakova-Georgieva, Anelia, 1970-, et al.
(författare)
-
Incorporation of Magnesium into GaN Regulated by Intentionally Large Amounts of Hydrogen during Growth by MOCVD
- 2022
-
Ingår i: Physica Status Solidi (B) Basic Research. - : Wiley. - 0370-1972 .- 1521-3951. ; 259:10
-
Tidskriftsartikel (refereegranskat)abstract
- Herein, metal–organic chemical vapor deposition (MOCVD) of GaN layers doped with Mg atoms to the recognized optimum level of [Mg] ≈2 × 1019 cm−3 is performed. In a sequence of MOCVD runs, operational conditions, including temperature and flow rate of precursors, are maintained except for intentionally larger flows of hydrogen carrier gas fed into the reactor. By employing the largest hydrogen flow of 25 slm in this study, the performance of the as-grown Mg-doped GaN layers is certified by a room-temperature hole concentration of p ≈2 × 1017 cm−3 in the absence of any thermal activation treatment. Experimental evidence is delivered that the large amounts of hydrogen during the MOCVD growth can regulate the incorporation of the Mg atoms into GaN in a significant way so that MgH complex can coexist with a dominant and evidently electrically active isolated MgGa acceptor.
|
|
| 2. |
|
|
| 3. |
- Beshkova, Milena, et al.
(författare)
-
Low-pressure sublimation epitaxy of AlN films - growth and characterization
- 2004
-
Ingår i: Vacuum. - : Elsevier BV. - 0042-207X .- 1879-2715. ; 76, s. 143-146
-
Tidskriftsartikel (refereegranskat)abstract
- Epitaxial layers of aluminum nitride have been grown at temperatures 1900-2400degreesC on 10 x 10 mm(2) 4H-SiC substrate via sublimation recondensation in an RF heated graphite furnace. The source material was polycrystalline sintered AlN. A maximum growth rate of about 100 mum/h was achieved at 2400degreesC and seed to source distance of 1 mm. The surface morphology reflects the hexagonal symmetry of the seed suggesting an epitaxial growth. This was confirmed by X-ray diffraction (XRD). The spectra showed very strong and well-defined (0002) reflection position at around 36.04degrees in symmetric Theta-2Thetascans for all samples. Micro-Raman spectroscopy reveals that the films have a wurtzite structure. It is evidenced by the appearance of the A(1) (TO) (at 601 cm(-1)) and E-2((2)) (at 651 cm(-1)) lines in the spectra. Secondary-ion mass spectroscopy (SIMS) results showed a low concentration of carbon incorporation in the AlN films. A correlation between the growth conditions and properties of the AlN layers was established.
|
|
| 4. |
- Beshkova, Milena, et al.
(författare)
-
Properties of AlN layers grown by sublimation epitaxy
- 2003
-
Ingår i: Materials Science Forum, Vols. 433-436. ; , s. 995-998
-
Konferensbidrag (refereegranskat)abstract
- Epitaxial layers of aluminum nitride (AlN)less than or equal to 80 mum thick have been grown at the temperatures 1900 and 2100 degreesC on 10x10mm(2) 4H-SiC substrates via sublimation recondensation in a RF heated graphite furnace. The source material was polyerystalline sintered AlN. A maximum growth rate of 80 mum/h was achieved at 2100degreesC and seed to source separation of I mm. The surface morphology reflects the hexagonal symmetry of the seed that suggesting an epitaxial growth. All crystals show strong and well defined single crystalline XRD patterns. Only the (002) reflection positioned at around 36.04 was observed in symmetric Theta-2Theta scan. The rocking curves FWHM (full width half maximum) and peak positions arc reported.
|
|
| 5. |
- Beshkova, Milena, et al.
(författare)
-
Sublimation epitaxy of AIN layers on 4H-SiC depending on the type of crucible
- 2003
-
Ingår i: Journal of materials science. Materials in electronics. - 0957-4522 .- 1573-482X. ; 14:10-12, s. 767-768
-
Tidskriftsartikel (refereegranskat)abstract
- Epitaxial layers of aluminum nitride less than or equal to335 mum thick have been grown attemperatures of 1900 and 2100degreesC on 10 x 10 mm(2) (0001)-oriented alpha(4H) silicon carbide (SiC), with growth times of 1 and 4h, via sublimation-recondensation in a RF-heated graphite furnace. The source material was polycrystalline AIN. The sublimation process was performed in three types of graphite (C) crucible: C-1, C-2 with inner diameters of 35 and 51 mm, respectively, and C-3 with the same inner diameter as C-1, but coated with a layer of TaC. The surface morphology reflects the hexagonal symmetry of the substrate, suggesting an epitaxial growth for samples grown in C-1 and C-3 crucibles for all growth conditions. The same symmetry is observed for AIN layers grown in the C-2 crucible, but only at 2100degreesC. X-ray diffraction analyses confirm the epitaxial growth of AIN samples with the expected hexagonal symmetry. A high-resolution X-ray diffractometer was used to assess the quality of the single crystals. A full width at half maximum of 242 arcsec was achieved for an AIN layer grown in the crucible coated with TaC. (C) 2003 Kluwer Academic Publishers.
|
|
| 6. |
- Ciechonski, Rafal, et al.
(författare)
-
Effect of boron on the resistivity of compensated 4H-SiC
- 2003
-
Ingår i: Journal of electronic materials. - : Springer Science and Business Media LLC. - 0361-5235 .- 1543-186X. ; 32:5, s. 452-457
-
Tidskriftsartikel (refereegranskat)abstract
- High-resistivity 4H-SiC samples grown by sublimation with a high growth rate are studied. The measurements show resistivity values up to a high of 104 Ωcm. The secondary ion mass spectroscopy (SIMS) results revealed a presence of only common trace impurities such as nitrogen, aluminum, and boron. To understand the compensation mechanism in these samples, capacitance deep-level transient spectroscopy (DLTS) on the p-type epilayers has been performed. By correlation between the growth conditions and SIMS results, we apply a model in which it is proposed that an isolated carbon vacancy donorlike level is a possible candidate responsible for compensation of the shallow acceptors in p-type 4H-SiC. A relation between cathodoluminescence (CL) and DLTS data is taken into account to support the model.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
- Fagerlind, Martin, 1980, et al.
(författare)
-
Investigation of the interface between silicon nitride passivations and AlGaN/AlN/GaN heterostructures by C(V) characterization of metal-insulator-semiconductor-heterostructure capacitors
- 2010
-
Ingår i: Journal of Applied Physics. - : AIP Publishing. - 0021-8979 .- 1089-7550. ; 108:1
-
Tidskriftsartikel (refereegranskat)abstract
- Capacitance-voltage [C(V)] measurements of metal-insulator-semiconductor-heterostructure capacitors are used to investigate the interface between silicon nitride passivation and AlGaN/AlN/GaN heterostructure material. AlGaN/AlN/GaN samples having different silicon nitride passivating layers, deposited using three different deposition techniques, are evaluated. Different interface state distributions result in large differences in the C(V) characteristics. A method to extract fixed charge as well as traps from the C(V) characteristics is presented. Rough estimates of the emission time constants of the traps can be extracted by careful analysis of the C(V) characteristics. The fixed charge is positive for all samples, with a density varying between 1.3 x 10(12) and 7.1 x 10(12) cm(-2). For the traps, the peak density of interface states is varying between 16 x 10(12) and 31 x 10(12) cm(-2) eV(-1) for the three samples. It is concluded that, of the deposition methods investigated in this report, the low pressure chemical vapor deposited silicon nitride passivation shows the most promising results with regards to low densities of interface states. (C) 2010 American Institute of Physics. [doi:10.1063/1.3428442]
|
|
| 10. |
|
|
