| 1. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 2. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
- van Vollenhoven, R, et al.
(författare)
-
A framework for remission in SLE: consensus findings from a large international task force on definitions of remission in SLE (DORIS)
- 2017
-
Ingår i: Annals of the rheumatic diseases. - : BMJ. - 1468-2060 .- 0003-4967. ; 76:3, s. 554-561
-
Tidskriftsartikel (refereegranskat)abstract
- Treat-to-target recommendations have identified ‘remission’ as a target in systemic lupus erythematosus (SLE), but recognise that there is no universally accepted definition for this. Therefore, we initiated a process to achieve consensus on potential definitions for remission in SLE.MethodsAn international task force of 60 specialists and patient representatives participated in preparatory exercises, a face-to-face meeting and follow-up electronic voting. The level for agreement was set at 90%.ResultsThe task force agreed on eight key statements regarding remission in SLE and three principles to guide the further development of remission definitions:1. Definitions of remission will be worded as follows: remission in SLE is a durable state characterised by …………………. (reference to symptoms, signs, routine labs).2. For defining remission, a validated index must be used, for example, clinical systemic lupus erythematosus disease activity index (SLEDAI)=0, British Isles lupus assessment group (BILAG) 2004 D/E only, clinical European consensus lupus outcome measure (ECLAM)=0; with routine laboratory assessments included, and supplemented with physician's global assessment.3. Distinction is made between remission off and on therapy: remission off therapy requires the patient to be on no other treatment for SLE than maintenance antimalarials; and remission on therapy allows patients to be on stable maintenance antimalarials, low-dose corticosteroids (prednisone ≤5 mg/day), maintenance immunosuppressives and/or maintenance biologics.The task force also agreed that the most appropriate outcomes (dependent variables) for testing the prognostic value (construct validity) of potential remission definitions are: death, damage, flares and measures of health-related quality of life.ConclusionsThe work of this international task force provides a framework for testing different definitions of remission against long-term outcomes.
|
|
| 6. |
- Mereaux, JL, et al.
(författare)
-
Increasing involvement of CAPN1 variants in spastic ataxias and phenotype-genotype correlations
- 2021
-
Ingår i: Neurogenetics. - : Springer Science and Business Media LLC. - 1364-6753 .- 1364-6745. ; 22:1, s. 71-79
-
Tidskriftsartikel (refereegranskat)abstract
- Spastic ataxias are rare neurogenetic disorders involving spinocerebellar and pyramidal tracts. Many genes are involved. Among them, CAPN1, when mutated, is responsible for a complex inherited form of spastic paraplegia (SPG76). We report the largest published series of 21 novel patients with nine new CAPN1 disease-causing variants and their clinical characteristics from two European university hospitals (Paris and Stockholm). After a formal clinical examination, causative variants were identified by next-generation sequencing and confirmed by Sanger sequencing. CAPN1 variants are a rare cause (~ 1.4%) of young-adult-onset spastic ataxia; however, together with all published cases, they allowed us to better describe the clinical and genetic spectra of this form. Truncating variants are the most frequent, and missense variants lead to earlier age at onset in favor of an additional deleterious effect. Cerebellar ataxia with cerebellar atrophy, dysarthria and lower limb weakness are often associated with spasticity. We also suggest that cognitive impairment and depression should be assessed specifically in the follow-up of SPG76 cases.
|
|
| 7. |
- Nguyen, Yann, et al.
(författare)
-
Association Between Severe Nonadherence to Hydroxychloroquine and Systemic Lupus Erythematosus Flares, Damage, and Mortality in 660 Patients From the SLICC Inception Cohort
- 2023
-
Ingår i: Arthritis and Rheumatology. - 2326-5191. ; 75:12, s. 2195-2206
-
Tidskriftsartikel (refereegranskat)abstract
- Objective: The goals of this study were to assess the associations of severe nonadherence to hydroxychloroquine (HCQ), objectively assessed by HCQ serum levels, and risks of systemic lupus erythematosus (SLE) flares, damage, and mortality rates over five years of follow-up. Methods: The Systemic Lupus International Collaborating Clinics (SLICC) Inception Cohort is an international multicenter initiative (33 centers throughout 11 countries). The serum of patients prescribed HCQ for at least three months at enrollment were analyzed. Severe nonadherence was defined by a serum HCQ level <106 ng/mL or <53 ng/mL for HCQ doses of 400 or 200 mg/day, respectively. Associations with the risk of a flare (defined as a Systemic Lupus Erythematosus Disease Activity Index 2000 increase ≥4 points, initiation of prednisone or immunosuppressive drugs, or new renal involvement) were studied with logistic regression, and associations with damage (first SLICC/American College of Rheumatology Damage Index [SDI] increase ≥1 point) and mortality with separate Cox proportional hazard models. Results: Of the 1,849 cohort participants, 660 patients (88% women) were included. Median (interquartile range) serum HCQ was 388 ng/mL (244–566); 48 patients (7.3%) had severe HCQ nonadherence. No covariates were clearly associated with severe nonadherence, which was, however, independently associated with both flare (odds ratio 3.38; 95% confidence interval [CI] 1.80–6.42) and an increase in the SDI within each of the first three years (hazard ratio [HR] 1.92 at three years; 95% CI 1.05–3.50). Eleven patients died within five years, including 3 with severe nonadherence (crude HR 5.41; 95% CI 1.43–20.39). Conclusion: Severe nonadherence was independently associated with the risks of an SLE flare in the following year, early damage, and five-year mortality. (Figure presented.).
|
|
| 8. |
- Rosanvallon, S., et al.
(författare)
-
Tritium related studies within the JET Fusion Technology work programme
- 2005
-
Ingår i: Fusion science and technology. - 1536-1055 .- 1943-7641. ; 48:1, s. 268-273
-
Tidskriftsartikel (refereegranskat)abstract
- The JET Fusion Technology (FT) work programme was launched in 2000, in the frame of the European Fusion Development Agreement, to address issues related to JET and ITER. In particular, there are four topics related to tritium being investigated Based on the experience gained on the existing tokamaks, first calculations indicate that in-vessel tritium retention could represent a burden for ITER operation. Therefore erosion/deposition studies are being performed in order to better understand the layer co-deposition and tritium retention processes in tokamaks. Moreover, testing of in-situ detritiation processes, in particular laser and flash lamp treatments, should assess detritiation techniques for in-vessel components in the ITER-relevant JET configuration. To reduce the constraints on waste disposal, dedicated procedures are being developed for detritiation Of metals, graphite, carbon-fibre composites, process and housekeeping waste. During the operational and decommissioning phases of a fusion reactor, many processes will produce tritiated water. Key components for an ITER relevant water detritiation facility are being studied experimentally with the aim of producing a complete design that could be implemented and tested at JET. This paper describes these topics of the FT-programme, the strategy developed and the results obtained so far.
|
|
| 9. |
- Rubel, Marek J., et al.
(författare)
-
An overview of a comprehensive First Mirror Test for ITER at JET
- 2009
-
Ingår i: Journal of Nuclear Materials. - Amsterdam : ELSEVIER SCIENCE BV. - 0022-3115 .- 1873-4820. ; 390-91, s. 1066-1069
-
Tidskriftsartikel (refereegranskat)abstract
- The test was performed with 32 stainless steel and molybdenum mirrors placed in pan-pipe shaped cassettes and exposed in JET in the divertor and on the main chamber wall for 127000 s including 97000 s of X-point operation. Surface composition and total reflectivity were determined afterwards All mirrors. from the divertor were coated with deuterated carbon deposits causing the reflectivity loss by a factor of 6-10 in the visible range. Flaking and exfoliation of deposits were observed in some cases On the main. chamber wall the deposition occurred mainly on mirrors located deep in cassette channels whereas mirrors close to the channels entrances were free from deposits and retained fair reflectivity (similar to 90% of initial value) especially in the infra-red range. No significant differences in behaviour of steel and molybdenum were noted. The need for development of methods for mirror cleaning and/or protection in a reactor-class device is addressed.
|
|
| 10. |
|
|
