| 1. |
- Dang, Dongfeng, 1988, et al.
(författare)
-
Fluorine substitution enhanced photovoltaic performance of a D-A 1-D-A2 copolymer
- 2013
-
Ingår i: Chemical Communications. - : Royal Society of Chemistry (RSC). - 1364-548X .- 1359-7345. ; 49:81, s. 9335-9337
-
Tidskriftsartikel (refereegranskat)abstract
- A new alternating donor-acceptor (D-A1-D-A2) copolymer containing two electron-deficient moieties, isoindigo and quinoxaline, was synthesized. The photovoltaic performance of this polymer could be improved by incorporating fluorine atoms into the quinoxaline units, resulting in an efficiency of 6.32%. This result highlights the attractive promise of D-A 1-D-A2 copolymers for high-performance bulk heterojunction solar cells. © 2013 The Royal Society of Chemistry.
|
|
| 2. |
- Aguilar, J. A., et al.
(författare)
-
Triboelectric backgrounds to radio-based polar ultra-high energy neutrino (UHEN) experiments
- 2023
-
Ingår i: Astroparticle physics. - : Elsevier. - 0927-6505 .- 1873-2852. ; 145
-
Tidskriftsartikel (refereegranskat)abstract
- In the hopes of observing the highest-energy neutrinos (E> 1 EeV) populating the Universe, both past (RICE, AURA, ANITA) and current (RNO-G, ARIANNA, ARA and TAROGE-M) polar-sited experiments exploit the impulsive radio emission produced by neutrino interactions. In such experiments, rare single event candidates must be unambiguously identified above backgrounds. Background rejection strategies to date primarily target thermal noise fluctuations and also impulsive radio-frequency signals of anthropogenic origin. In this paper, we consider the possibility that 'fake' neutrino signals may also be generated naturally via the `triboelectric effect' This broadly describes any process in which force applied at a boundary layer results in displacement of surface charge, leading to the production of an electrostatic potential difference AV. Wind blowing over granular surfaces such as snow can induce such a potential difference, with subsequent coronal discharge. Discharges over timescales as short as nanoseconds can then lead to radio-frequency emissions at characteristic MHz-GHz frequencies. Using data from various past (RICE, AURA, SATRA, ANITA) and current (RNO G, ARIANNA and ARA) neutrino experiments, we find evidence for such backgrounds, which are generally characterized by: (a) a threshold wind velocity which likely depends on the experimental trigger criteria and layout; for the experiments considered herein, this value is typically O(10 m/s), (b) frequency spectra generally shifted to the low-end of the frequency regime to which current radio experiments are typically sensitive (100-200 MHz), (c) for the strongest background signals, an apparent preference for discharges from above-surface structures, although the presence of more isotropic, lower amplitude triboelectric discharges cannot be excluded.
|
|
| 3. |
- Alkadir Abdulahi, Birhan, 1985, et al.
(författare)
-
Open-Circuit Voltage Modulations on All-Polymer Solar Cells by Side Chain Engineering on 4,8-Di(thiophen-2-yl)benzo[1,2- b:4,5- b′]dithiophene-Based Donor Polymers
- 2018
-
Ingår i: ACS Applied Energy Materials. - : American Chemical Society (ACS). - 2574-0962. ; 1:6, s. 2918-2926
-
Tidskriftsartikel (refereegranskat)abstract
- In recent years, all-polymer solar cells (all-PSCs), incorporating active layers based on blends of electron-donor (D) and acceptor (A) polymers, have drawn attention because of the advantages they hold in the flexibility of choosing the D:A combinations to modulate their energy levels and to improve their overall open-circuit voltages (V oc ) and power conversion efficiencies (PCE)s. V oc is one of the key parameters for the determination of the PCEs of PSCs. In this work, we synthesized six donor polymers with three different side chains appended to the 4,8-di(thiophen-2-yl)benzo[1,2-b:4,5-b′]dithiophene (BDT) units. By substituting carbon with sulfur and silicon atoms at the 5-position of the thiophenes attached to the BDT units, the highest occupied molecular orbital (HOMO) levels of the donor polymers could be successfully lowered. As anticipated, the V oc values of the resulting all-PSCs increased along with the lowering of the HOMO levels of the donor polymers. Among the six all-PSCs, the PBDT-BDD:PNDI-T10 all-PSC realized a balance between the photovoltage and photocurrent, where a decent PCE of 5.6% was obtained with a V oc of 0.9 V and a photocurrent of 10.5 mA/cm 2 .
|
|
| 4. |
|
|
| 5. |
- Aasmundtveit, K.E., et al.
(författare)
-
Structural ordering in phenyl-substituted polythiophenes
- 2000
-
Ingår i: Macromolecules. - : American Chemical Society (ACS). - 0024-9297 .- 1520-5835. ; 33:15, s. 5481-5489
-
Tidskriftsartikel (refereegranskat)abstract
- Various substituted poly(phenylthiophene)s have been studied by X-ray diffraction. They are semicrystalline, with very different degrees of crystallinity. Those with para-substituted phenyl groups have a low degree of crystallinity, whereas those with ortho-substituted phenyl groups are more crystalline. The most crystalline materials in this study have two equally long substituents on the phenyl ring, one at the ortho position and the other at the ortho or meta position on the opposite side of the phenyl ring. Poly(3-(2,5-dioctylphenyl)thiophene) (PDOPT) was most thoroughly studied, and a structural model is proposed. The structure of PDOPT is quite different from previously studied substituted polythiophenes in that the octyl side chains are directed normal to the thiophene planes. In this way, the conjugated polymer chains are kept separated from each other. Solution-cast and spin-cast PDOPT films are anisotropic, with the octyl side chains oriented normal to the film surface in both cases. This is contrary to the situation for poly(3-alkylthiophene)s, where solution-cast and spin-cast films orient in different ways.
|
|
| 6. |
|
|
| 7. |
- Alkadir Abdulahi, Birhan, 1985, et al.
(författare)
-
Structural engineering of pyrrolo[3,4-: F] benzotriazole-5,7(2 H,6 H)-dione-based polymers for non-fullerene organic solar cells with an efficiency over 12%
- 2019
-
Ingår i: Journal of Materials Chemistry A. - : Royal Society of Chemistry (RSC). - 2050-7488 .- 2050-7496. ; 7:33, s. 19522-19530
-
Tidskriftsartikel (refereegranskat)abstract
- In this work, we have synthesized two wide band gap donor polymers based on benzo[1,2-b:4,5-b′]dithiophene (BDT) and pyrrolo[3,4-f]benzotriazole-5,7(2H,6H)-dione (TzBI), namely, PBDT-TzBI and PBDT-F-TzBI and studied their photovoltaic properties by blending them with ITIC as an acceptor. Polymer solar cell devices made from PBDT-TzBI:ITIC and PBDT-F-TzBI:ITIC exhibited power conversion efficiencies (PCEs) of 9.22% and 11.02% and while annealing at 160 °C, improved the device performances to 10.24% and 11.98%, respectively. Upon solvent annealing with diphenyl ether (DPE) (0.5%) and chlorobenzene (CB), the PCE of the PBDT-F-TzBI-based device increased to 12.12%. The introduction of the fluorinated benzodithiophene (BDT-F) moiety on the backbone of PBDT-F-TzBI improved the open circuit voltage, short circuit current and fill factor simultaneously. The high PCEs of the PBDT-F-TzBI:ITIC-based devices were supported by comparison and analysis of the optical and electronic properties, the charge carrier mobilities, exciton dissociation probabilities, and charge recombination behaviors of the devices.
|
|
| 8. |
- Bian, Qingzhen, et al.
(författare)
-
Reduced Nonradiative Voltage Loss in Terpolymer Solar Cells
- 2020
-
Ingår i: Journal of Physical Chemistry Letters. - : American Chemical Society (ACS). - 1948-7185. ; 11:10, s. 3796-3802
-
Tidskriftsartikel (refereegranskat)abstract
- The dissociation of hybrid local exciton and charge transfer excitons (LE-CT) in efficient bulk-heterojunction nonfullerene solar cells contributes to reduced nonradiative photovoltage loss, a mechanism that still remains unclear. Herein we studied the energetic and entropic contribution in the hybrid LE-CT exciton dissociation in devices based on a conjugated terpolymer. Compared with reference devices based on ternary blends, the terpolymer devices demonstrated a significant reduction in the nonradiative photovoltage loss, regardless of the acceptor molecule, be it fullerene or nonfullerene. Fourier transform photocurrent spectroscopy revealed a significant LE-CT character in the terpolymer-based solar cells. Temperature-dependent hole mobility and photovoltage confirm that entropic and energetic effects contribute to the efficient LE-CT dissociation. The energetic disorder value measured in the fullerene- or nonfullerene-based terpolymer devices suggested that this entropic contribution came from the terpolymer, a signature of higher disorder in copolymers with multiple aromatic groups. This gives new insight into the fundamental physics of efficient LE-CT exciton dissociation with smaller nonradiative recombination loss.
|
|
| 9. |
- Chvojka, Petr, et al.
(författare)
-
Expanded Multiband Super-Nyquist CAP Modulation for Highly Bandlimited Organic Visible Light Communications
- 2020
-
Ingår i: IEEE Systems Journal. - 1932-8184 .- 1937-9234. ; 14:2, s. 2544-2550
-
Tidskriftsartikel (refereegranskat)abstract
- In this article, we experimentally demonstrate a novel expanded nonorthogonal multiband super-Nyquist carrier-less amplitude and phase (m-ESCAP) modulation for bandlimited organic visible light communication (VLC) systems. The proposed scheme has the same bandwidth requirement as the conventional m-CAP while breaking the orthogonality between subcarriers by purposely overlapping them. We compare m-ESCAP with the conventional m-CAP and a compressed nonorthogonal version of m-CAP (m-SCAP) in terms of measured bit error rate (BER) performance, bit rates, and spectral efficiencies. We show that the m-ESCAP system offers improvement in the bit rate of $\sim$10% and 20% compared to the m-CAP and m-SCAP, respectively, and in the spectral efficiency of $\sim$20% compared to m-CAP. These gains are achieved at the cost of increased BER, which, however, remains below the 7% forward error correction limit.
|
|
| 10. |
- Filate, Tadele Tamenu, 1994, et al.
(författare)
-
Aqueous Processed All-Polymer Solar Cells with High Open-Circuit Voltage Based on Low-Cost Thiophene-Quinoxaline Polymers
- 2024
-
Ingår i: ACS Applied Materials & Interfaces. - : American Chemical Society (ACS). - 1944-8252 .- 1944-8244. ; 16:10, s. 12886-12896
-
Tidskriftsartikel (refereegranskat)abstract
- Eco-friendly solution processing and the low-cost synthesis of photoactive materials are important requirements for the commercialization of organic solar cells (OSCs). Although varieties of aqueous-soluble acceptors have been developed, the availability of aqueous-processable polymer donors remains quite limited. In particular, the generally shallow highest occupied molecular orbital (HOMO) energy levels of existing polymer donors limit further increases in the power conversion efficiency (PCE). Here, we design and synthesize two water/alcohol-processable polymer donors, poly[(thiophene-2,5-diyl)-alt-(2-((13-(2,5,8,11-tetraoxadodecyl)-2,5,8,11-tetraoxatetradecan-14-yl)oxy)-6,7-difluoroquinoxaline-5,8-diyl)] (P(Qx8O-T)) and poly[(selenophene-2,5-diyl)-alt-(2-((13-(2,5,8,11-tetraoxadodecyl)-2,5,8,11-tetraoxatetradecan-14-yl)oxy)-6,7-difluoroquinoxaline-5,8-diyl)] (P(Qx8O-Se)) with oligo(ethylene glycol) (OEG) side chains, having deep HOMO energy levels (∼−5.4 eV). The synthesis of the polymers is achieved in a few synthetic and purification steps at reduced cost. The theoretical calculations uncover that the dielectric environmental variations are responsible for the observed band gap lowering in OEG-based polymers compared to their alkylated counterparts. Notably, the aqueous-processed all-polymer solar cells (aq-APSCs) based on P(Qx8O-T) and poly[(N,N′-bis(3-(2-(2-(2-methoxyethoxy)-ethoxy)ethoxy)-2-((2-(2-(2-methoxyethoxy)ethoxy)ethoxy)-methyl)propyl)naphthalene-1,4,5,8-bis(dicarboximide)-2,6-diyl)-alt-(2,5-thiophene)] (P(NDIDEG-T)) active layer exhibit a PCE of 2.27% and high open-circuit voltage (VOC) approaching 0.8 V, which are among the highest values for aq-APSCs reported to date. This study provides important clues for the design of low-cost, aqueous-processable polymer donors and the fabrication of aqueous-processable OSCs with high VOC
|
|
