| 1. |
- Bruzzi, M, et al.
(författare)
-
Radiation-hard semiconductor detectors for SuperLHC
- 2005
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002. ; 541:1-2, s. 189-201
-
Tidskriftsartikel (refereegranskat)abstract
- An option of increasing the luminosity of the Large Hadron Collider (LHC) at CERN to 1035 cm-2 s-1 has been envisaged to extend the physics reach of the machine. An efficient tracking down to a few centimetres from the interaction point will be required to exploit the physics potential of the upgraded LHC. As a consequence, the semiconductor detectors close to the interaction region will receive severe doses of fast hadron irradiation and the inner tracker detectors will need to survive fast hadron fluences of up to above 1016cm-2. The CERN-RD50 project "Development of Radiation Hard Semiconductor Devices for Very High Luminosity Colliders" has been established in 2002 to explore detector materials and technologies that will allow to operate devices up to, or beyond, this limit. The strategies followed by RD50 to enhance the radiation tolerance include the development of new or defect engineered detector materials (SiC, GaN, Czochralski and epitaxial silicon, oxygen enriched Float Zone silicon), the improvement of present detector designs and the understanding of the microscopic defects causing the degradation of the irradiated detectors. The latest advancements within the RD50 collaboration on radiation hard semiconductor detectors will be reviewed and discussed in this work.
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Li, Shunyi, et al.
(författare)
-
Intrinsic energy band alignment of functional oxides
- 2014
-
Ingår i: Physica Status Solidi - Rapid Research Letetrs. - : Wiley. - 1862-6254 .- 1862-6270. ; 8:6, s. 571-576
-
Tidskriftsartikel (refereegranskat)abstract
- The energy band alignment at interfaces between different materials is a key factor, which determines the function of electronic devices. While the energy band alignment of conventional semiconductors is quite well understood, systematic experimental studies on oxides are still missing. This work presents an extensive study on the intrinsic energy band alignment of a wide range of functional oxides using photoelectron spectroscopy with in-situ sample preparation. The studied materials have particular technological importance in diverse fields as solar cells, piezotronics, multiferroics, photoelectrochemistry and oxide electronics. Particular efforts have been made to verify the validity of transitivity, in order to confirm the intrinsic nature of the obtained band alignment and to understand the underlying principles. Valence band offsets up to 1.6 eV are observed. The large variation of valence band maximum energy can be explained by the different orbital contributions to the density of states in the valence band. The framework provided by this work enables the general understanding and prediction of energy band alignment at oxide interfaces, and furthermore the tailoring of energy level matching for charge transfer in functional oxides. (C) 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim
|
|
| 5. |
- Boisvert, V, et al.
(författare)
-
Characterization of oxygen dimer-enriched silicon detectors
- 2005
-
Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002. ; 552:1-2, s. 49-55
-
Tidskriftsartikel (refereegranskat)abstract
- Various types of silicon material and silicon p(+)n diodes have been treated to increase the concentration of the oxygen dimer (02) defect. This was done by exposing the bulk material and the diodes to 6 MeV electrons at a temperature of about 350 degrees C. FTIR spectroscopy has been performed on the processed material confirming the formation of oxygen dimer defects in Czochralski silicon pieces. We also show results from TSC characterization on processed diodes. Finally, we investigated the influence of the dimer enrichment process on the depletion voltage of silicon diodes and performed 24 GeV/c proton irradiations to study the evolution of the macroscopic diode characteristics as a function of fluence.
|
|
| 6. |
|
|
| 7. |
- Le Febvrier, Arnaud, et al.
(författare)
-
Effect of in-plane ordering on dielectric properties of highly {111}-oriented bismuth-zinc-niobate thin films
- 2017
-
Ingår i: Journal of Materials Science. - : SPRINGER. - 0022-2461 .- 1573-4803. ; 52:19, s. 11306-11313
-
Tidskriftsartikel (refereegranskat)abstract
- Bi1.5-xZn0.92-yNb1.5O6.92-delta (BZN) thin films were grown by pulsed laser deposition on two different Pt-covered substrates, namely textured {111} Pt/TiO2/SiO2/(100) Si substrate (Pt/Si) and epitaxial {111} Pt/R-plane sapphire substrate (Pt/sapphire). In both cases, the BZN films present {111} and {100} out-of-plane orientations, in relative ratios of 65: 35 on Pt/Si and 80: 20 on Pt/sapphire, respectively. The film grown on Pt/Si is textured, while the film deposited on Pt/sapphire presents epitaxial-like relationships with the substrate, for both out-of-plane orientations. Dielectric measurements were taken on both types of thin films, using Pt/BZN/Pt planar capacitor structures. The BZN/Pt/sapphire film presents higher dielectric constant (245 at 100 kHz) and higher tunability (12% at 600 kV/cm) than the BZN/Pt/Si film (200; 6%), while the dielectric losses values are nearly same (similar to 0.05).
|
|
| 8. |
- Tsao, Ming Sound, et al.
(författare)
-
PD-L1 Immunohistochemistry Comparability Study in Real-Life Clinical Samples : Results of Blueprint Phase 2 Project
- 2018
-
Ingår i: Journal of Thoracic Oncology. - : Elsevier BV. - 1556-0864 .- 1556-1380. ; 13:9, s. 1302-1311
-
Tidskriftsartikel (refereegranskat)abstract
- Objectives: The Blueprint (BP) Programmed Death Ligand 1 (PD-L1) Immunohistochemistry Comparability Project is a pivotal academic/professional society and industrial collaboration to assess the feasibility of harmonizing the clinical use of five independently developed commercial PD-L1 immunohistochemistry assays. The goal of BP phase 2 (BP2) was to validate the results obtained in BP phase 1 by using real-world clinical lung cancer samples.Methods: BP2 were conducted using 81 lung cancer specimens of various histological and sample types, stained with all five trial-validated PD-L1 assays (22C3, 28-8, SP142, SP263, and 73-10); the slides were evaluated by an international panel of pathologists. BP2 also assessed the reliability of PD-L1 scoring by using digital images, and samples prepared for cytological examination. PD-L1 expression was assessed for percentage (tumor proportional score) of tumor cell (TC) and immune cell areas showing PD-L1 staining, with TCs scored continuously or categorically with the cutoffs used in checkpoint inhibitor trials.Results: The BP2 results showed highly comparable staining by the 22C3, 28-8 and SP263 assays; less sensitivity with the SP142 assay; and higher sensitivity with the 73-10 assay to detect PD-L1 expression on TCs. Glass slide and digital image scorings were highly concordant (Pearson correlation >0.96). There was very strong reliability among pathologists in TC PD-L1 scoring with all assays (overall intraclass correlation coefficient [ICC] = 0.86–0.93), poor reliability in IC PD-L1 scoring (overall ICC = 0.18–0.19), and good agreement in assessing PD-L1 status on cytological cell block materials (ICC = 0.78–0.85).Conclusion: BP2 consolidates the analytical evidence for interchangeability of the 22C3, 28-8, and SP263 assays and lower sensitivity of the SP142 assay for determining tumor proportion score on TCs and demonstrates greater sensitivity of the 73-10 assay compared with that of the other assays.
|
|
