| 1. |
- Poley, L., et al.
(författare)
-
The ABC130 barrel module prototyping programme for the ATLAS strip tracker
- 2020
-
Ingår i: Journal of Instrumentation. - : IOP PUBLISHING LTD. - 1748-0221 .- 1748-0221. ; 15:9
-
Tidskriftsartikel (refereegranskat)abstract
- For the Phase-II Upgrade of the ATLAS Detector [1], its Inner Detector, consisting of silicon pixel, silicon strip and transition radiation sub-detectors, will be replaced with an all new 100% silicon tracker, composed of a pixel tracker at inner radii and a strip tracker at outer radii. The future ATLAS strip tracker will include 11,000 silicon sensor modules in the central region (barrel) and 7,000 modules in the forward region (end-caps), which are foreseen to be constructed over a period of 3.5 years. The construction of each module consists of a series of assembly and quality control steps, which were engineered to be identical for all production sites. In order to develop the tooling and procedures for assembly and testing of these modules, two series of major prototyping programs were conducted: an early program using readout chips designed using a 250 nm fabrication process (ABCN-250) [2, 3] and a subsequent program using a follow-up chip set made using 130 nm processing (ABC130 and HCC130 chips). This second generation of readout chips was used for an extensive prototyping program that produced around 100 barrel-type modules and contributed significantly to the development of the final module layout. This paper gives an overview of the components used in ABC130 barrel modules, their assembly procedure and findings resulting from their tests.
|
|
| 2. |
- Aliev, M., et al.
(författare)
-
A forward silicon strip system for the ATLAS HL-LHC upgrade
- 2013
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 730, s. 210-214
-
Tidskriftsartikel (refereegranskat)abstract
- In the year 2022 an upgrade of the Large Hadron Collider (LHC) is planned to increase the luminosity such that an integrated luminosity of L-int similar to 3000 fb(-1) can be accumulated by 2030 [1]. The radiation damage of the present inner tracker at this date and the high track density of the High Luminosity LHC (HL-LHC) require an upgrade of the inner tracker of the ATLAS (A Toroidal LHC ApparatuS) experiment. A new integration concept will be used: the readout electronics is directly glued on the strip surface of the silicon sensors and the sensors are glued to a support structure. For the barrel region this structure is referred to as a Stave and for the end-cap region it is referred to as a Petal. For tests a smaller version, the Petalet, will be build with two design concepts. In this article the construction method is explained and first hybrid test results for one Petalet sensor are presented.
|
|
| 3. |
- Broman, Lars Mikael, et al.
(författare)
-
Pressure and flow properties of cannulae for extracorporeal membrane oxygenation I : return (arterial) cannulae
- 2019
-
Ingår i: Perfusion. - : SAGE PUBLICATIONS LTD. - 0267-6591 .- 1477-111X. ; 34, s. 58-64
-
Tidskriftsartikel (refereegranskat)abstract
- Adequate extracorporeal membrane oxygenation support in the adult requires cannulae permitting blood flows up to 6-8 L/minute. In accordance with Poiseuille's law, flow is proportional to the fourth power of cannula inner diameter and inversely proportional to its length. Poiseuille's law can be applied to obtain the pressure drop of an incompressible, Newtonian fluid (such as water) flowing in a cylindrical tube. However, as blood is a pseudoplastic non-Newtonian fluid, the validity of Poiseuille's law is questionable for prediction of cannula properties in clinical practice. Pressure-flow charts with non-Newtonian fluids, such as blood, are typically not provided by the manufacturers. A standardized laboratory test of return (arterial) cannulae for extracorporeal membrane oxygenation was performed. The aim was to determine pressure-flow data with human whole blood in addition to manufacturers' water tests to facilitate an appropriate choice of cannula for the desired flow range. In total, 14 cannulae from three manufacturers were tested. Data concerning design, characteristics, and performance were graphically presented for each tested cannula. Measured blood flows were in most cases 3-21% lower than those provided by manufacturers. This was most pronounced in the narrow cannulae (15-17 Fr) where the reduction ranged from 27% to 40% at low flows and 5-15% in the upper flow range. These differences were less apparent with increasing cannula diameter. There was a marked disparity between manufacturers. Based on the measured results, testing of cannulae including whole blood flows in a standardized bench test would be recommended.
|
|
| 4. |
- Broman, L. M., et al.
(författare)
-
Pressure and flow properties of dual-lumen cannulae for extracorporeal membrane oxygenation
- 2020
-
Ingår i: Perfusion. - : SAGE Publications Ltd. - 0267-6591 .- 1477-111X.
-
Tidskriftsartikel (refereegranskat)abstract
- Introduction: In the last decade, dual-lumen cannulae have been increasingly applied in patients undergoing extracorporeal life support. Well-performing vascular access is crucial for efficient extracorporeal membrane oxygenation support; thus, guidance for proper cannulae size is required. Pressure–flow charts provided by manufacturers are often based on tests performed using water, rarely blood. However, blood is a shear-thinning and viscoelastic fluid characterized by different flow properties than water. Methods: We performed a study evaluating pressure–flow curves during standardized conditions using human whole blood in two commonly available dual-lumen cannulae used in neonates, pediatric, and adult patients. Results were merged and compared with the manufacturer’s corresponding curves obtained from the public domain. Results: The results showed that using blood as compared with water predominantly influenced drainage flow. A 10-80% higher pressure-drop was needed to obtain same drainage flow (hematocrit of 26%) compared with manufacturer’s water charts in 13-31 Fr bi-caval dual-lumen cannulae. The same net difference was found in cavo-atrial cannulae (16-32 Fr), where a lower drainage pressure was required (Hct of 26%) compared with the manufacturer’s test using blood with an Hct of 33%. Return pressure–flow data were similar, independent whether pumping blood or water, to the data reported by manufacturers. Conclusion: Non-standardized testing of pressure–flow properties of extracorporeal membrane oxygenation dual-lumen cannulae prevents an adequate prediction of pressure–flow results when these cannulae are used in patients. Properties of dual-lumen cannulae may vary between sizes within same cannula family, in particular concerning the drainage flow.
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- van Wyk, Stevin, et al.
(författare)
-
Non-Newtonian perspectives on pulsatile blood-analog flows in a 180 degrees curved artery model
- 2015
-
Ingår i: Physics of fluids. - : AIP Publishing. - 1070-6631 .- 1089-7666. ; 27:7
-
Tidskriftsartikel (refereegranskat)abstract
- Complex, unsteady fluid flow phenomena in the arteries arise due to the pulsations of the heart that intermittently pumps the blood to the extremities of the body. The many different flow waveform variations observed throughout the arterial network are a result of this process and a function of the vessel properties. Large scale secondary flow structures are generated throughout the aortic arch and larger branches of the arteries. An experimental 180. curved artery test section with physiological inflow conditions was used to validate the computational methods implemented in this study. Good agreement of the secondary flow structures is obtained between experimental and numerical studies of a Newtonian blood-analog fluid under steady-state and pulsatile, carotid artery flow rate waveforms. Multiple vortical structures, some of opposite rotational sense to Dean vortices, similar to Lyne-type vortices, were observed to form during the systolic portion of the pulse. Computational tools were used to assess the effect of blood-analog fluid rheology ( i.e., Newtonian versus non-Newtonian). It is demonstrated that non-Newtonian, blood-analog fluid rheology results in shear layer instabilities that alter the formation of vortical structures during the systolic deceleration and onwards during diastole. Additional vortices not observed in the Newtonian cases appear at the inside and outside of the bend at various times during the pulsation. The influence of blood-analog shear-thinning viscosity decreases mean pressure losses in contrast to the Newtonian blood analog fluid.
|
|
