| 1. |
|
|
| 2. |
- Boström, Cecilia, et al.
(författare)
-
Design proposal of electrical system for linear generator wave power plants
- 2009
-
Ingår i: 35TH ANNUAL CONFERENCE OF IEEE INDUSTRIAL ELECTRONICS. - : IEEE. - 9781424446483 - 9781424446506 ; , s. 4180-4185
-
Konferensbidrag (refereegranskat)abstract
- This paper describes an electrical system layout for a wave power plant connecting linear generators to the grid. The electrical power out from the wave energy converters must be converted before they can be connected to the grid. The conversion is carried out in marine substations that will be placed on the seabed.The paper presents experimental power data from a wave energy converter that has been in operation at the Lysekil research site since March 2006. Moreover, results and analyses from experiments and simulations from tests with the generator connected to a rectifier and filter are presented. A simulation is made to show the difference between having the generator connected to a linear load and a nonlinear load, which would be the case when the generator is connected to the grid.
|
|
| 3. |
- Boström, Cecilia, et al.
(författare)
-
Study of aWave Energy Converter Connected to a Nonlinear Load
- 2009
-
Ingår i: IEEE Journal of Oceanic Engineering. - 0364-9059 .- 1558-1691. ; 34:2, s. 123-127
-
Tidskriftsartikel (refereegranskat)abstract
- This paper presents experimental results from a wave energy converter (WEC) that is based on a linear generator connected to a rectifier and filter components. The converter-filter system is installed onshore, while the linear wave generator operates offshore a few kilometers from the Swedish west coast. The power from the generator has been rectified with a diode bridge and then filtered using a capacitive filter. Performance of the whole conversion system was studied using resistive loads connected across the filter. The aim was to investigate the operational characteristics of the generator while supplying a nonlinear load. By changing the value of the resistive component of the load, the speed of the translator can be changed and so also the damping of the generator. The power absorbed by the generator was studied at different sea states as well. The observations presented in this paper could be beneficial for the design of efficient wave energy conversion systems.
|
|
| 4. |
- Boström, Cecilia, et al.
(författare)
-
Temperature measurements in a linear generator and marine substation for wave power
- 2010
-
Ingår i: PROCEEDINGS OF THE ASME 29TH INTERNATIONAL CONFERENCE ON OCEAN, OFFSHORE AND ARCTIC ENGINEERING 2010, VOL 3. - 9780791849118 ; , s. 545-552
-
Konferensbidrag (refereegranskat)abstract
- This paper analyzes temperature measurements acquired in offshore operation of a wave energy converter array. The three directly driven wave energy converters have linear generators and are connected to a marine substation placed on the seabed. The highly irregular individual linear generator voltages are rectified and added on a common DC-link and inverted to 50 Hz to facilitate future grid-connection. The electrical power is transmitted to shore and converted to heat in a measuring station. First results of temperature measurements on substation components and on the stator of one of the linear generators are presented from operation in linear and in non-linear damping. Results indicate that there might be some convective heat transport in the substation vessel. If high power levels are extracted from the waves, this has to be considered when placing components in the substation vessel to avoid heating from neighbouring components. The results also indicate that the temperature increase in the linear generator stator is very small. Failure due to excessive heating of the stator winding PVC cable insulation is unlikely to occur even in very energetic sea states. Should this conclusion be incorrect, the thermal conductivity between the stator and the hull of the WEC could be enhanced. Another suggested alteration would be to lower the resistive losses by reducing the linear generator current density.
|
|
| 5. |
- Boström, Cecilia, et al.
(författare)
-
Temperature measurements in a linear generator and marine substation for wave power
- 2012
-
Ingår i: Journal of Offshore Mechanics and Arctic Engineering-Transactions of The Asme. - : ASME International. - 0892-7219 .- 1528-896X. ; 134:2, s. 021901-
-
Tidskriftsartikel (refereegranskat)abstract
- This paper analyzes temperature measurements acquired in the offshore operation of a wave energy converter array. The three directly driven wave energy converters have linear generators and are connected to a marine substation placed on the seabed. The highly irregular individual linear generator voltages are rectified and added on a common dc-link and inverted to 50 Hz to facilitate future grid-connection. The electrical power is transmitted to shore and converted to heat in a measuring station. The first results of temperature measurements on substation components and on the stator of one of the linear generators are presented based on operation in linear and in nonlinear damping. The results indicate that there might be some convective heat transfer in the substation vessel. If high power levels are extracted from the waves, this has to be considered when placing components in the substation vessel in order to avoid heating from neighboring components. The results also indicate that the temperature increase in the linear generator stator is very small. Failure due to excessive heating of the stator winding polyvinyl chloride cable insulation is unlikely to occur even in very energetic sea states. Should this conclusion be incorrect, the thermal conductivity between the stator and the hull of the wave energy converter could be enhanced. Another suggested alteration is to lower the resistive losses by reducing the linear generator current density.
|
|
| 6. |
|
|
| 7. |
- Castellucci, Valeria, et al.
(författare)
-
Sea level variability in the Swedish Exclusive Economic Zone and adjacent seawaters : influence on a point absorbing wave energy converter
- 2019
-
Ingår i: Ocean Science. - : Copernicus GmbH. - 1812-0784 .- 1812-0792. ; 15, s. 1517-1529
-
Tidskriftsartikel (refereegranskat)abstract
- Low-frequency sea level variability can be a critical factor for several wave energy converter (WEC) systems, for instance, linear systems with a limited stroke length. Consequently, when investigating suitable areas for deployment of those WEC systems, sea level variability should be taken into account. In order to facilitate wave energy developers finding the most suitable areas for wave energy park installations, this paper describes a study that gives them additional information by exploring the annual and monthly variability of the sea level in the Baltic Sea and adjacent seawaters, with a focus on the Swedish Exclusive Economic Zone. Overall, 10 years of reanalysis data from the Copernicus project have been used to conduct this investigation. The results are presented by means of maps showing the maximum range and the standard deviation of the sea level with a horizontal spatial resolution of about 1 km. A case study illustrates how the results can be used by the WEC developers to limit the energy absorption loss of their devices due to sea level variation. Depending on the WEC technology one wants to examine, the results lead to different conclusions. For the Uppsala point absorber L12 and the sea state considered in the case study, the most suitable sites where to deploy WEC parks from a sea level variation viewpoint are found in the Gotland basins and in the Bothnian Sea, where the energy loss due to sea level variations is negligible.
|
|
| 8. |
- Engström, Jens, et al.
(författare)
-
Energy absorption from parks of point-absorbing wave energy converters in the Swedish exclusive economic zone
- 2020
-
Ingår i: Energy Science & Engineering. - : John Wiley & Sons. - 2050-0505. ; 8:1, s. 38-49
-
Tidskriftsartikel (refereegranskat)abstract
- In a future energy system based on renewable energy sources, wave energy will most likely play a role due to its high energy potential and low intermittency. The power production from parks of wave energy converters of point absorber type has been extensively studied. This is also the case for the wave energy resource at many coastal areas around the globe. Wave energy has not yet reached a commercial level, and a large variety of technologies exist; therefore, an established method to calculate the technical potential for wave energy has still not been established. To estimate the technical potential of wave energy conversion, some approximations inevitably need to be taken due to the systems high complexity. In this study, a detailed mapping of the wave climate and simulation of large arrays of hydrodynamically cross‐coupled wave energy converters are combined to calculate the technical potential for wave energy conversion in the Swedish exclusive economic zone. A 16‐year wave data set distributed in a 1.1 km × 1.1 km grid is used to calculate the absorbed energy from a park of 200 generic point absorbers. The areas with best potential have an average annual energy absorption of 16 GWh for the selected wave energy park adapted to 1 km2 when using a constant damping, while the theoretical upper bound is 63 GWh for the same area.
|
|
| 9. |
|
|
| 10. |
|
|
