| 1. |
|
|
| 2. |
- Xu, Peng, et al.
(författare)
-
D-A-D-Typed Hole Transport Materials for Efficient Perovskite Solar Cells : Tuning Photovoltaic Properties via the Acceptor Group
- 2018
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society (ACS). - 1944-8244 .- 1944-8252. ; 10:23, s. 19697-19703
-
Tidskriftsartikel (refereegranskat)abstract
- Two D-A-D-structured hole-transport materials (YN1 and YN2) have been synthesized and used in perovskite solar cells. The two HTMs have low-lying HOMO levels and impressive mobility. Perovskite-based solar cells (PSCs) fabricated with YN2 showed a power conversion efficiency (PCE) value of 19.27% in ambient air, which is significantly higher than that of Spiro-OMeTAD (17.80%). PSCs based on YN1 showed an inferior PCE of 16.03%. We found that the incorporation of the stronger electron-withdrawing group in the HTM YN2 improves the PCE of PSCs. Furthermore, the YN2-based PSCs exhibit good long-term stability retaining 91.3% of its initial efficiency, whereas PSCs based on Spiro-OMeTAD retained only 42.2% after 1000 h lifetime (dark conditions). These promising results can provide a new strategy for the design of D-A-D HTMs for PSC applications in future.
|
|
| 3. |
- Bi, D., et al.
(författare)
-
Facile synthesized organic hole transporting material for perovskite solar cell with efficiency of 19.8%
- 2016
-
Ingår i: Nano Energy. - : Elsevier. - 2211-2855. ; 23, s. 138-144
-
Tidskriftsartikel (refereegranskat)abstract
- The exploration of alternative molecular hole-transporting materials (HTMs) specifically for high performance perovskite solar cells (PSCs) is a relatively recent research area. Aiming for further increasing the 'efficiency-cost ratio' of PSCs, we developed a spiro[fluorene-9,9'-xanthene] based HTM (X59) via two-step synthesis from commercial precursors for perovskite solar cells (PSCs) that works as effectively as the well-known HTM-Spiro-OMeTAD-based device under the same conditions. The molecular structure was analyzed by X-ray crystallography indicating a similar packing regime as for Spiro-OMeTAD. An impressive PCE of 19.8% was achieved by using X59 as HTM in PSC, which can compete with the record PCE of 20.8% by using the state-of-the-art-HTM Spiro-OMeTAD (Tress et al., 2016) [1]. The optimized devices employing X59 as HTM exhibited minimized hysteresis, excellent reproducibility and reasonable stability under dark and dry conditions. The present finding highlights the potential of spiro-type HTM for high performance PSCs and paves the way to a much deceased fabrication cost for potential commercialization of perovskite solar panels.
|
|
| 4. |
- Bo, Xu
(författare)
-
Advanced Organic Hole Transport Materials for Solution-Processed Photovoltaic Devices
- 2015
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Solution-processable photovoltaic devices (PVs), such as perovskite solar cells (PSCs) and solid-state dye-sensitized solar cells (sDSCs) show great potential to replace the conventional silicon-based solar cells for achieving low-cost and large-area solar electrical energy generation in the near future, due to their easy manufacture and high efficiency. Organic hole transport materials (HTMs) play important roles in both PSCs and sDSCs, and thereby can well facilitate the hole separation and transportation, for obtaining high performance solar cells.The studies in this thesis aimed to develop advanced small-molecule organic HTMs with low-cost, high hole mobility and conductivity for the achievement of highly efficient, stable and reproducible sDSCs and PSCs. In order to achieve these objectives, two different strategies were utilized in this thesis: the development of new generation HTMs with simple synthetic routes and the introduction of cost-effective p-type dopants to control the charge transport properties of HTMs.In Chapter 1 and Chapter 2, a general introduction of the solution-processed sDSCs and PSCs, as well as the characterization methods that are used in this thesis were presented.In Chapter 3 and Chapter 4, a series of novel triphenylamine- and carbazole- based HTMs with different oxidation potential, hole mobility, conductivity and molecular size were designed and synthesized, and then systematically applied and investigated in sDSCs and PSCs.In Chapter 5, two low-cost and colorless p-type dopants AgTFSI and TeCA were introduced for the organic HTM-Spiro-OMeTAD, which can significantly increase the conductivity of the Spiro-OMeTAD films. The doping effects on the influence of sDSC and PSC device performances were also systematically investigated.
|
|
| 5. |
- Chen, Cheng, et al.
(författare)
-
Molecular Engineering of Triphenylamine-Based Non-Fullerene Electron-Transport Materials for Efficient Rigid and Flexible Perovskite Solar Cells
- 2018
-
Ingår i: ACS Applied Materials and Interfaces. - : AMER CHEMICAL SOC. - 1944-8244 .- 1944-8252. ; 10:45, s. 38970-38977
-
Tidskriftsartikel (refereegranskat)abstract
- There has been a growing interest in the design and synthesis of non-fullerene electron transport materials (ETMs) for perovskite solar cells (PSCs), which may overcome the drawbacks of traditional fullerene derivatives. In this work, a novel donor-acceptor (D-A) structured ETM termed TPA-3CN is presented by molecular engineering of triphenylamine (TPA) as the donor group and (3-cyano-4,5,5-trimethyl-2(5H)-furanylidene) malononitrile as the acceptor group. To further improve the electron mobility and conductivity and achieve excellent photovoltaic performance, a solution processable n-type dopant is introduced during the ETM spin-coating step. After device optimization, PSCs based on the doped TPA-3CN exhibit an impressive power conversion efficiency (PCE) of 19.2% with a negligible hysteresis. Benefitting from the low temperature and good solution processability of ETM TPA-3CN, it was further applied in flexible inverted PSCs and an impressive PCE of 13.2% was achieved, which is among the highest values reported for inverted flexible fullerene-free PSCs.
|
|
| 6. |
- Cheng, Ming, et al.
(författare)
-
A novel phenoxazine-based hole transport material for efficient perovskite solar cell
- 2015
-
Ingår i: Journal of Energy Challenges and Mechanics. - : Elsevier. - 2056-9386. ; 24:6, s. 698-706
-
Tidskriftsartikel (refereegranskat)abstract
- Based on the previous research work in our laboratory, we have designed and synthesized a small-molecule, hole transport material (HTM) POZ6-2 using phenoxazine (POZ) as central unit and dicyanovinyl units as electron-withdrawing terminal groups. Through the introduction of a 2-ethyl-hexyl bulky chain into the POZ core unit, POZ6-2 exhibits good solubility in organic solvents. In addition, POZ6-2 possesses appropriate energy levels in combination with a high hole mobility and conductivity in its pristine form. Therefore, it can readily be used as a dopant-free HTM in perovskite solar cells (PSCs) and a conversion efficiency of 10.3% was obtained. The conductivity of the POZ6-2 layer can be markedly enhanced via doping in combination with typical additives, such as 4-tert-butylpyridine (TBP) and lithium bis(trifluoromethanesulfonyl) imide (LiTFSI). Correspondingly, the efficiency of the PSCs was further improved to 12.3% using doping strategies. Under the same conditions, reference devices based on the well-known HTM Spiro-OMeTAD show an efficiency of 12.8%.
|
|
| 7. |
- Cheng, Ming, et al.
(författare)
-
Novel Small Molecular Materials Based on Phenoxazine Core Unit for Efficient Bulk Heterojunction Organic Solar Cells and Perovskite Solar Cells
- 2015
-
Ingår i: Chemistry of Materials. - : American Chemical Society (ACS). - 0897-4756 .- 1520-5002. ; 27:5, s. 1808-1814
-
Tidskriftsartikel (refereegranskat)abstract
- Two novel Acceptor-Donor-Acceptor (A-D-A) structured small molecular (SM-) materials POZ2 and POZ3 using an electron-rich phenoxazine (POZ) unit as a core building block were designed and synthesized. Their unique characteristics, such as suitable energy levels, strong optical absorption in the visible region, high hole mobility, and high conductivity, prompted us to use them both as p-type donor materials (DMs) in SM-bulk heterojunction organic solar cells (BHJ OSCs) and as hole transport materials (HTMs) in CH3NH3PbI3-based perovskite solar cells (PSCs). The POZ(2)-based devices yielded promising power conversion efficiencies (PCEs) of 7.44% and 12.8% in BHJ OSCs and PSCs, respectively, which were higher than the PCEs of 6.73% (BHJ-OSCs) and 11.5% (PSCs) obtained with the POZ3-based devices. Moreover, our results demonstrated that the POZ2 employing the electron-deficient benzothiazole (BTZ) as linker exhibited higher hole mobility and conductivity than that of the POZ3 using thiophene as linker, leading to better device performance both in BHJ-OSCs and PSCs. These results also provide guidance for the molecular design of high charge carrier mobility SM-materials for highly efficient BHJ OSCs and PSCs in the future.
|
|
| 8. |
- Cheng, Ming, et al.
(författare)
-
Phenoxazine-based small molecule material for efficient perovskite solar cells and bulk heterojunction organic solar cells
- 2015
-
Ingår i: Advanced Energy Materials. - : Wiley. - 1614-6832 .- 1614-6840. ; 5:8
-
Tidskriftsartikel (refereegranskat)abstract
- The phenoxazine-based acceptor-donor-acceptor structured small-molecule material M1 is used either as a hole-transport material in (CH3NH3)PbI3-perovskite-based solar cells or as photoactive donor material in bulk heterojunction organic solar cells. Excellent power conversion efficiencies of 13.2% and 6.9% are achieved in these two types of photovoltaic devices, respectively.
|
|
| 9. |
- Chng, Kern Rei, et al.
(författare)
-
Cartography of opportunistic pathogens and antibiotic resistance genes in a tertiary hospital environment
- 2020
-
Ingår i: Nature Medicine. - : Springer Science and Business Media LLC. - 1078-8956 .- 1546-170X. ; 26, s. 941-951
-
Tidskriftsartikel (refereegranskat)abstract
- Although disinfection is key to infection control, the colonization patterns and resistomes of hospital-environment microbes remain underexplored. We report the first extensive genomic characterization of microbiomes, pathogens and antibiotic resistance cassettes in a tertiary-care hospital, from repeated sampling (up to 1.5 years apart) of 179 sites associated with 45 beds. Deep shotgun metagenomics unveiled distinct ecological niches of microbes and antibiotic resistance genes characterized by biofilm-forming and human-microbiome-influenced environments with corresponding patterns of spatiotemporal divergence. Quasi-metagenomics with nanopore sequencing provided thousands of high-contiguity genomes, phage and plasmid sequences (>60% novel), enabling characterization of resistome and mobilome diversity and dynamic architectures in hospital environments. Phylogenetics identified multidrug-resistant strains as being widely distributed and stably colonizing across sites. Comparisons with clinical isolates indicated that such microbes can persist in hospitals for extended periods (>8 years), to opportunistically infect patients. These findings highlight the importance of characterizing antibiotic resistance reservoirs in hospitals and establish the feasibility of systematic surveys to target resources for preventing infections. Spatiotemporal characterization of microbial diversity and antibiotic resistance in a tertiary-care hospital reveals broad distribution and persistence of antibiotic-resistant organisms that could cause opportunistic infections in a healthcare setting.
|
|
| 10. |
- Du, Jian, et al.
(författare)
-
Iron carbonate hydroxide templated binary metal-organic frameworks for highly efficient electrochemical water oxidation
- 2019
-
Ingår i: Chemical Communications. - : Royal Society of Chemistry. - 1359-7345 .- 1364-548X. ; 55:98, s. 14773-14776
-
Tidskriftsartikel (refereegranskat)abstract
- Metal-organic frameworks (MOFs) are promising catalysts for electrochemical reactions. Herein, self-supported NiFe-MOF nanoplates grown on Ni foam (NF) were prepared with iron carbonate hydroxide nanosheets (FeCH NSs) as a semisacrificial template and evaluated for the electrocatalytic oxygen evolution reaction (OER). In this approach, the porous FeCH NSs not only serve as the iron source of NiFe-MOF, but also slow down the leaching of Ni ions from the substrate, thus playing a unique role in regulating the morphology of NiFe-MOF with reduced thickness and sizes, enabling rapid electron transfer and mass transport. The resultant NiFe-MOF/FeCH-NF electrode showed higher activity than FeCH template-free electrodes and superior OER performance over other MOF based binder-free OER electrodes. A current density of 10 mA cm(-2) was obtained at a low overpotential of 200 mV with excellent durability in alkaline solution. Raman and TEM measurements reveal the partial transformation of NiFe-MOF to hydroxide during water oxidation.
|
|
