| 1. |
- Pumpanen, J, et al.
(författare)
-
Comparison of different chamber techniques for measuring soil CO2 efflux
- 2004
-
Ingår i: Agricultural and Forest Meteorology. - : Elsevier BV. - 1873-2240 .- 0168-1923. ; 123:3-4, s. 159-176
-
Tidskriftsartikel (refereegranskat)abstract
- Twenty chambers for measurement of soil CO2 efflux were compared against known CO2 fluxes ranging from 0.32 to 10.01 mumol CO2 m(-2) s(-1) and generated by a specially developed calibration tank. Chambers were tested on fine and coarse homogeneous quartz sand with particle sizes of 0.05-0.2 and 0.6 mm, respectively. The effect of soil moisture on chamber measurements was tested by wetting the fine quartz sand to about 25% volumetric water content. Non-steady-state through-flow chambers either underestimated or overestimated fluxes from -21 to +33% depending on the type of chamber and the method of mixing air within the chamber's headspace. However, when results of all systems tested were averaged, fluxes were within 4% of references. Non-steady-state non-through-flow chambers underestimated or overestimated fluxes from -35 to +6%. On average, the underestimation was about 13-14% on fine sand and 4% on coarse sand. When the length of the measurement period was increased, the underestimation increased due to the rising concentration within the chamber headspace, which reduced the diffusion gradient within the soil. Steady-state through-flow chambers worked almost equally well in all sand types used in this study. They overestimated the fluxes on average by 2-4%. Overall, the reliability of the chambers was not related to the measurement principle per se. Even the same chambers, with different collar designs, showed highly variable results. The mixing of air within the chamber can be a major source of error. Excessive turbulence inside the chamber can cause mass flow of CO2 from the soil into the chamber. The chamber headspace concentration also affects the flux by altering the concentration gradient between the soil and the chamber.
|
|
| 2. |
- Ziegler, K., et al.
(författare)
-
The synthesis of matrices of embedded semiconducting nanowires
- 2004
-
Ingår i: Faraday discussions. - : Royal Society of Chemistry (RSC). - 1359-6640 .- 1364-5498. ; 125, s. 311-326
-
Tidskriftsartikel (refereegranskat)abstract
- In this work we report how single crystal nanowires can be assembled into regular arrays using mesoporous thin films to define the architecture. Mesoporous thin films were prepared by a sol-gel method. These provide films of very regular structure and dimensions. The films produced in this way have almost single crystal like structures and can also exhibit strong epitaxy to the underlying silicon substrate. The films are subjected to a supercritical fluid (SCF) environment in which a precursor is decomposed to yield nanowires of metals, semiconductors or oxides. Using these SCF conditions, pore filling is complete and the products are nanowires which are single crystals and structurally aligned in one direction. The growth mechanism of the nanowires is described and size effects discussed.
|
|
| 3. |
|
|
| 4. |
- Crowley, T.A., et al.
(författare)
-
Synthesis of metal and metal oxide nanowires and nanotube arrays within a mesoporous silica template
- 2003
-
Ingår i: Chemistry of Materials. - : American Chemical Society (ACS). - 0897-4756 .- 1520-5002. ; 15:18, s. 3518-3522
-
Tidskriftsartikel (refereegranskat)abstract
- Metallic nanowires of cobalt, copper, and iron oxide magnetite (Fe3O4) have been synthesized within the pores of mesoporous silica using a supercritical fluid inclusion technique. The mesoporous matrix provides a means of producing a high density of stable, hexagonally ordered arrays of highly crystalline nanowires. The formation of the metal and metal oxide nanowires within the silica mesopores was confirmed by transmission electron microscopy (TEM), N2 adsorption experiments, and powder X-ray diffraction (PXRD). The mechanism of nanowire formation within the mesopores appears to occur through the initial binding and coating of the pore walls with the metal atoms to form tubelike structures within the mesoporous template. The thickness of these tubes subsequently increases with further metal deposition until nanowires are formed. Additionally, the crystal structure of the cobalt nanowires formed within the mesoporous template can be readily changed by manipulating the density of the supercritical fluid phase.
|
|
| 5. |
|
|
