| 51. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
A low-absorption x-ray energy filter for small-scale applications
- 2009
-
Ingår i: Optics Express. - : The Optical Society. - 1094-4087. ; 17:14, s. 11388-11398
-
Tidskriftsartikel (refereegranskat)abstract
- We present an experimental and theoretical evaluation of an x-ray energy filter based on the chromatic properties of a prism-array lens (PAL). It is intended for small-scale applications such as medical imaging. The PAL approximates a Fresnel lens and allows for high efficiency compared to filters based on ordinary refractive lenses, however at the cost of a lower energy resolution. Geometrical optics was found to provide a good approximation for the performance of a flawless lens, but a field-propagation model was used for quantitative predictions. The model predicted a 0.29 ΔE/E energy resolution and an intensity gain of 6.5 for a silicon PAL at 23.5 keV. Measurements with an x-ray tube showed good agreement with the model in energy resolution and peak energy, but a blurred focal line contributed to a 29% gain reduction. We believe the blurring to be caused mainly by lens imperfections, in particular at the periphery of the lens.
|
|
| 52. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
A Tunable Energy Filter for Medical X-Ray Imaging
- 2008
-
Ingår i: X-Ray Optics and Instrumentation. - : Hindawi. - 1687-7632 .- 1687-7640. ; 2008
-
Tidskriftsartikel (refereegranskat)abstract
- A multiprism lens (MPL) is a refractive X-ray lens, and its chromatic properties can be employed in an energy filtering setup to obtain a narrow tunable X-ray spectrum. We present the first evaluation of such a filter for medical X-ray imaging. The experimental setup yields a 6.6 gain of flux at 20 keV, and we demonstrate tunability by altering the energy spectrum to center also around 17 and 23 keV. All measurements are found to agree well with ray-tracing and a proposed geometrical model. Compared to a model mammography system with absorption filtering, the experimental MPL filter reduces dose 13–25% for 3–7 cm breasts if the spectrum is centered around the optimal energy. Additionally, the resolution is improved 2.5 times for a 5 cm breast. The scan time is increased 3 times but can be reduced with a slightly decreased energy filtering and resolution.
|
|
| 53. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
Contrast-enhanced spectral mammography with a photon-counting detector
- 2010
-
Ingår i: Medical physics (Lancaster). - : Wiley. - 0094-2405. ; 37:5, s. 2017-2029
-
Tidskriftsartikel (refereegranskat)abstract
- Purpose: Spectral imaging is a method in medical x-ray imaging to extract information about the object constituents by the material-specific energy dependence of x-ray attenuation. In particular, the detectability of a contrast agent can be improved over a lumpy background. We have investigated a photon-counting spectral imaging system with two energy bins for contrast-enhanced mammography. System optimization and the potential benefit compared to conventional non-energy-resolved imaging was studied.Methods: A framework for system characterization was set up that included quantum and anatomical noise, and a theoretical model of the system was benchmarked to phantom measurements.Results: It was found that optimal combination of the energy-resolved images corresponded approximately to minimization of the anatomical noise, and an ideal-observer detectability index could be improved more than a factor of two compared to absorption imaging in the phantom study. In the clinical case, an improvement close to 80% was predicted for an average glandularity breast, and a factor of eight for dense breast tissue. Another 70% was found to be within reach for an optimized system.Conclusions: Contrast-enhanced spectral mammography is feasible and beneficial with the current system, and there is room for additional improvements.
|
|
| 54. |
- Fredenberg, Erik, PhD, 1979-, et al.
(författare)
-
Energy filtering with x-ray lenses: Optimization for photon-counting mammography
- 2010
-
Ingår i: Radiation Protection Dosimetry. - : Oxford University Press (OUP). - 0144-8420 .- 1742-3406. ; 139, s. 339-342
-
Tidskriftsartikel (refereegranskat)abstract
- Chromatic properties of the multi-prism and prism-array x-ray lenses (MPL and PAL) can potentially be utilized for efficient energy filtering and dose reduction in mammography. The line-shaped foci of the lenses are optimal for coupling to photon-counting silicon strip detectors in a scanning system. A theoretical model was developed and used to investigate the benefit of two lenses compared to an absorption-filtered reference system. The dose reduction of the MPL filter was 15% compared to the reference system at matching scan time, and the spatial resolution was higher. The dose of the PAL-filtered system was found to be 20% lower than for the reference system at equal scan time and resolution, and only 20% higher than for a monochromatic beam. An investigation of some practical issues remains, including the feasibility of brilliant-enough x-ray sources and manufacturing of a polymer PAL.
|
|
| 55. |
- Ribeiro, Luis, et al.
(författare)
-
Industrial Agents for the Fast Deployment of Evolvable Assembly Systems
- 2015. - 1st ed.
-
Ingår i: Industrial Agents. - Amsterdam, Netherlands : Elsevier. - 9780128003411 ; , s. 301-321, s. 301-322
-
Bokkapitel (refereegranskat)abstract
- The current manufacturing scenario is characterized by high market unpredictability. Agility is therefore a central challenge for modern companies that need to understand and be proactive towards their product offer in respect to “what is offered, when it is offered, where, how and by whom” (Brown & Bessant 2003).The “what” and the “when” are particularly relevant to the research in emerging paradigms as they account for variety, customization and volume; and timing, speed and seasonality (Brown & Bessant 2003).In this scenario, several design approaches and models have been proposed in the last decade to enable re-configurability and subsequently enhance the companies’ ability to adjust their offer in nature and time.From a paradigmatic point of view research has concentrated on the organizational structure of the shop-floor and the associated controls aspects. Concepts like Reconfigurable Manufacturing Systems (RMS) (Koren & Shpitalni 2010) and Fractal Factories (FF) (Montreuil 1999) support the physical construction of production systems by regulating their layout and making a few assumptions on their logical organization. On the other hand, concepts like Bionic Manufacturing Systems (BMS)(Ueda 1992), Holonic Manufacturing Systems (HMS)(Van Brussel et al. 1998), Evolvable Assembly Systems (Ribeiro et al. 2010) essentially provide the theoretical guidelines for the logical/computational organization of the system (see (Tharumarajah 1996) for a comparison between BMS, HMS and FF and (Setchi & Lagos 2004) for the rationale supporting the shift from Dedicated Lines to Flexible Manufacturing System and finally RMS).While these paradigms provide the conceptual framework and the main design guidelines their actual interpretation and implementation has led to a wider set of architectures (Monostori, Váncza & Kumara 2006; Leitão 2009; Parunak 2000; Pěchouček & Mařík 2008).These architectures align the high-level principles with the technological offer and limitations while seeking to address the re-configurability requirements of (Mehrabi, Ulsoy & Koren 2000; Rösiö & Säfsten 2013):module mobility – modules are easy and quick to move and install;“diagnosability” – it is quick to identify the sources of quality and reliability problems;“integrability” – modules are easy to integrate into the rest of the system.“convertibility” – it is easy and quick to switch between existing products and it is easy to adapt the system to future products;scalability – it is easy to enlarge and downsize the production system;“automatibility” – a dynamic level of automation is enabled;modularity – all system elements are designed to be modular;customization – the capability and flexibility of the production system is designed according to the products to be produced in the system.Instant deployment, as addressed in the present chapter directly addresses mobility, “integrability”, “convertibility”, scalability and customization. Mechatronic modularity is a prerequisite and is enforced by the proposed architecture and the considered modular design. “Diagnosability” was not specifically tackled.In this context, the chapter analyses the agent-based architecture related with the Instantly Deployable Evolvable Assembly System (IDEAS) project that is inspired by the Evolvable Assembly System (EAS) paradigm (Ribeiro et al. 2010) as a mechanism to enable fast deployment of mechatronic modules. EAS advocates the use of process-oriented modules and envisions the production system as a collection of processes and the associated interacting agents.The architecture and the related test cases are used to draw the main lessons learned in respect to technological and conceptual implications.In this context, the remainder of this text is organized as follows: section 1.1 discusses the main deployment challenges, section 1.2 details the reference architecture and associated concepts, section 1.3 presents the principal implementation decisions, section 1.4 features the main lessons learned, sections 1.5 discusses the benefits of the proposed approach and finally section 1.6 reflects on the main conclusions.
|
|
| 56. |
- Forsberg, Lena, et al.
(författare)
-
Gender and entrepreneurship in the horse-related industry
- 2013
-
Ingår i: Journal of Business Diversity. - 2158-3889. ; 12:2, s. 75-93
-
Tidskriftsartikel (refereegranskat)abstract
- In this paper, we examine the horse-related industry in terms of entrepreneurship and gender. Based on reports of the industry, a mapping of the entire sector (N= 7504) and a questionnaire (N=520) we find that the industry is portrayed as female gendered, but dominated by men. However, we also find evidence that the industry is changing gender, as women dominate among younger entrepreneurs. The strongest motives for the horse-related entrepreneurs (regardless of gender) are realizing a dream and being able to combine interest with work. We also found that entrepreneurs in this industry mainly network inside the industry.
|
|
| 57. |
- De Goey, Heleen, et al.
(författare)
-
Design-driven innovation : Making meaning for whom
- 2017
-
Ingår i: The Design Journal. - : European Academy of Design. - 1460-6925 .- 1756-3062. ; 20:S1, s. S479-S491
-
Tidskriftsartikel (refereegranskat)abstract
- Design-driven innovation focuses on the innovation of product meanings. This innovation is enabled by integrating knowledge on needs, product language and technological development. So far, it has mostly been studied in contexts where the buyer is the assumed end user. There has been little research about design-driven innovation in other contexts, such as business-to-business and public contexts. Here, companies need to create value for multiple stakeholders. In this study, these are defined as users, buyers and influencers. The aim of this study is to explore how companies consider the different stakeholders in the innovation of product meanings. Two companies participated in a case study. The results demonstrate that both companies mainly focus on addressing needs. However, while one case company prioritizes the perspective from the user, the other focuses more on the buyer. The results illustrate the increased complexity that companies need to manage in design-driven innovation in these contexts.
|
|
| 58. |
-
Unraveling the logics of landscape
- 2014
-
Samlingsverk (redaktörskap) (övrigt vetenskapligt/konstnärligt)abstract
- Despite conceptual oscillations through times, the concept of landscape remains highly subjective, whereupon unraveling its 'logics' opens up to a plurality of interpretations. Accordingly, by focusing on the interconnections present in the non-haphazard production of landscape, this publication elaborates on how the rural landscape is valued, monitored, changed, harbored, used and misused, be it through actions, representations or metaphors. This book covers a broad range of topics, with contributions from scholars from more than 30 countries.
|
|
| 59. |
|
|
| 60. |
|
|
