SwePub
Tyck till om SwePub Sök här!
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Alarcon GS) "

Sökning: WFRF:(Alarcon GS)

  • Resultat 21-30 av 48
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
21.
  • Niemi, MEK, et al. (författare)
  • 2021
  • swepub:Mat__t
  •  
22.
  • Abel, I, et al. (författare)
  • Overview of the JET results with the ITER-like wall
  • 2013
  • Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
  • Tidskriftsartikel (refereegranskat)abstract
    • Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
  •  
23.
  •  
24.
  •  
25.
  •  
26.
  •  
27.
  • Choi, MY, et al. (författare)
  • The prevalence and determinants of anti-DFS70 autoantibodies in an international inception cohort of systemic lupus erythematosus patients
  • 2017
  • Ingår i: Lupus. - : SAGE Publications. - 1477-0962 .- 0961-2033. ; 26:10, s. 1051-1059
  • Tidskriftsartikel (refereegranskat)abstract
    • Autoantibodies to dense fine speckles 70 (DFS70) are purported to rule out the diagnosis of SLE when they occur in the absence of other SLE-related autoantibodies. This study is the first to report the prevalence of anti-DFS70 in an early, multinational inception SLE cohort and examine demographic, clinical, and autoantibody associations. Patients were enrolled in the Systemic Lupus International Collaborating Clinics (SLICC) inception cohort within 15 months of diagnosis. The association between anti-DFS70 and multiple parameters in 1137 patients was assessed using univariate and multivariate logistic regression. The frequency of anti-DFS70 was 7.1% (95% CI: 5.7–8.8%), while only 1.1% (95% CI: 0.6–1.9%) were monospecific for anti-DFS70. In multivariate analysis, patients with musculoskeletal activity (Odds Ratio (OR) 1.24 [95% CI: 1.10, 1.41]) or with anti-β2 glycoprotein 1 (OR 2.17 [95% CI: 1.22, 3.87]) were more likely and patients with anti-dsDNA (OR 0.53 [95% CI: 0.31, 0.92]) or anti-SSB/La (OR 0.25 [95% CI: 0.08, 0.81]) were less likely to have anti-DFS70. In this study, the prevalence of anti-DFS70 was higher than the range previously published for adult SLE (7.1 versus 0–2.8%) and was associated with musculoskeletal activity and anti-β2 glycoprotein 1 autoantibodies. However, ‘monospecific’ anti-DFS70 autoantibodies were rare (1.1%) and therefore may be helpful to discriminate between ANA-positive healthy individuals and SLE.
  •  
28.
  •  
29.
  •  
30.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 21-30 av 48

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy