| 51. |
- Roldin, Pontus, et al.
(författare)
-
Aerosol ageing in an urban plume - implication for climate
- 2011
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7324. ; 11:12, s. 5897-5915
-
Tidskriftsartikel (refereegranskat)abstract
- The climate effects downwind of an urban area resulting from gaseous and particulate emissions within the city are as yet inadequately quantified. The aim of this work was to estimate these effects for Malmo city in southern Sweden (population 280 000). The chemical and physical particle properties were simulated with a model for Aerosol Dynamics, gas phase CHEMistry and radiative transfer calculations (ADCHEM) following the trajectory movement from upwind of Malmo, through the urban background environment and finally tens and hundreds of kilometers downwind of Malmo. The model results were evaluated using measurements of the particle number size distribution and chemical composition. The total particle number concentration 50 km (similar to 3 h) downwind, in the center of the Malmo plume, is about 3700 cm(-3) of which the Malmo contribution is roughly 30%. Condensation of nitric acid, ammonium and to a smaller extent oxidized organic compounds formed from the emissions in Malmo increases the secondary aerosol formation with a maximum of 0.7-0.8 mu gm(-3) 6 to 18 h downwind of Malmo. The secondary mass contribution dominates over the primary soot contribution from Malmo already 3 to 4 h downwind of the emission sources and contributes to an enhanced total surface direct or indirect aerosol shortwave radiative forcing in the center of the urban plume ranging from -0.3 to -3.3 Wm(-2) depending on the distance from Malmo, and the specific cloud properties.
|
|
| 52. |
|
|
| 53. |
|
|
| 54. |
- Roldin, Pontus, et al.
(författare)
-
Development and evaluation of the aerosol dynamics and gas phase chemistry model ADCHEM
- 2011
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7324. ; 11:12, s. 5867-5896
-
Tidskriftsartikel (refereegranskat)abstract
- The aim of this work was to develop a model suited for detailed studies of aerosol dynamics, gas and particle phase chemistry within urban plumes, from local scale (1x1 km(2)) to regional scale. This article describes and evaluates the trajectory model for Aerosol Dynamics, gas and particle phase CHEMistry and radiative transfer (AD-CHEM). The model treats both vertical and horizontal dispersion perpendicular to an air mass trajectory (2-space dimensions). The Lagrangian approach enables a more detailed representation of the aerosol dynamics, gas and particle phase chemistry and a finer spatial and temporal resolution compared to that of available regional 3D-CTMs. These features make it among others well suited for urban plume studies. The aerosol dynamics model includes Brownian coagulation, dry deposition, wet deposition, in-cloud processing, condensation, evaporation, primary particle emissions and homogeneous nucleation. The organic mass partitioning was either modeled with a 2-dimensional volatility basis set (2D-VBS) or with the traditional two-product model approach. In ADCHEM these models consider the diffusion limited and particle size dependent condensation and evaporation of 110 and 40 different organic compounds respectively. The gas phase chemistry model calculates the gas phase concentrations of 61 different species, using 130 different chemical reactions. Daily isoprene and monoterpene emissions from European forests were simulated separately with the vegetation model LPJ-GUESS, and included as in-put to ADCHEM. ADCHEM was used to simulate the ageing of the urban plumes from the city of Malmo in southern Sweden (280 000 inhabitants). Several sensitivity tests were performed concerning the number of size bins, size structure method, aerosol dynamic processes, vertical and horizontal mixing, coupled or uncoupled condensation and the secondary organic aerosol formation. The simulations show that the full-stationary size structure gives accurate results with little numerical diffusion when more than 50 size bins are used between 1.5 and 2500 nm, while the moving-center method is preferable when only a few size bins are selected. The particle number size distribution in the center of the urban plume from Malmo was mainly affected by dry deposition, coagulation and vertical dilution. The modeled PM2.5 mass was dominated by organic material, nitrate, sulfate and ammonium. If the condensation of HNO3 and NH3 was treated as a coupled process (pH independent) the model gave lower nitrate PM2.5 mass than if considering uncoupled condensation. Although the time of ageing from that SOA precursors are emitted until condensable products are formed is substantially different with the 2D-VBS and two product model, the models gave similar total organic mass concentrations.
|
|
| 55. |
- Roldin, Pontus, et al.
(författare)
-
Modelling non-equilibrium secondary organic aerosol formation and evaporation with the aerosol dynamics, gas- and particle-phase chemistry kinetic multilayer model ADCHAM
- 2014
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7324. ; 14:15, s. 7953-7993
-
Tidskriftsartikel (refereegranskat)abstract
- We have developed the novel Aerosol Dynamics, gas- and particle-phase chemistry model for laboratory CHAMber studies (ADCHAM). The model combines the detailed gas-phase Master Chemical Mechanism version 3.2 (MCMv3.2), an aerosol dynamics and particle-phase chemistry module (which considers acid-catalysed oligomerization, heterogeneous oxidation reactions in the particle phase and non-ideal interactions between organic compounds, water and inorganic ions) and a kinetic multilayer module for diffusion-limited transport of compounds between the gas phase, particle surface and particle bulk phase. In this article we describe and use ADCHAM to study (1) the evaporation of liquid dioctyl phthalate (DOP) particles, (2) the slow and almost particle-size-independent evaporation of alpha-pinene ozonolysis secondary organic aerosol (SOA) particles, (3) the mass-transfer-limited uptake of ammonia (NH3) and formation of organic salts between ammonium (NH4+) and carboxylic acids (RCOOH), and (4) the influence of chamber wall effects on the observed SOA formation in smog chambers. ADCHAM is able to capture the observed alpha-pinene SOA mass increase in the presence of NH3(g). Organic salts of ammonium and carboxylic acids predominantly form during the early stage of SOA formation. In the smog chamber experiments, these salts contribute substantially to the initial growth of the homogeneously nucleated particles. The model simulations of evaporating alpha-pinene SOA particles support the recent experimental findings that these particles have a semi-solid tar-like amorphous-phase state. ADCHAM is able to reproduce the main features of the observed slow evaporation rates if the concentration of low-volatility and viscous oligomerized SOA material at the particle surface increases upon evaporation. The evaporation rate is mainly governed by the reversible decomposition of oligomers back to monomers. Finally, we demonstrate that the mass-transfer-limited uptake of condensable organic compounds onto wall-deposited particles or directly onto the Teflon chamber walls of smog chambers can have a profound influence on the observed SOA formation. During the early stage of the SOA formation the wall-deposited particles and walls themselves serve as an SOA sink from the air to the walls. However, at the end of smog chamber experiments the semi-volatile SOA material may start to evaporate from the chamber walls. With these four model applications, we demonstrate that several poorly quantified processes (i.e. mass transport limitations within the particle phase, oligomerization, heterogeneous oxidation, organic salt formation, and chamber wall effects) can have a substantial influence on the SOA formation, lifetime, chemical and physical particle properties, and their evolution. In order to constrain the uncertainties related to these processes, future experiments are needed in which as many of the influential variables as possible are varied. ADCHAM can be a valuable model tool in the design and analysis of such experiments.
|
|
| 56. |
|
|
| 57. |
- Roldin, Pontus, et al.
(författare)
-
Modelling the contribution of biogenic volatile organic compounds to new particle formation in the Julich plant atmosphere chamber
- 2015
-
Ingår i: Atmospheric Chemistry and Physics. - : Copernicus GmbH. - 1680-7324. ; 15:18, s. 10777-10798
-
Tidskriftsartikel (refereegranskat)abstract
- We used the Aerosol Dynamics gas- and particle-phase chemistry model for laboratory CHAMber studies (ADCHAM) to simulate the contribution of BVOC plant emissions to the observed new particle formation during photooxidation experiments performed in the Julich Plant-Atmosphere Chamber and to evaluate how well smog chamber experiments can mimic the atmospheric conditions during new particle formation events. ADCHAM couples the detailed gas-phase chemistry from Master Chemical Mechanism with a novel aerosol dynamics and particle phase chemistry module. Our model simulations reveal that the observed particle growth may have either been controlled by the formation rate of semi- and low-volatility organic compounds in the gas phase or by acid catalysed heterogeneous reactions between semi-volatility organic compounds in the particle surface layer (e.g. peroxyhemiacetal dimer formation). The contribution of extremely low-volatility organic gas-phase compounds to the particle formation and growth was suppressed because of their rapid and irreversible wall losses, which decreased their contribution to the nano-CN formation and growth compared to the atmospheric situation. The best agreement between the modelled and measured total particle number concentration (R-2 > 0.95) was achieved if the nano-CN was formed by kinetic nucleation involving both sulphuric acid and organic compounds formed from OH oxidation of BVOCs.
|
|
| 58. |
- Roldin, Pontus
(författare)
-
Process based Modelling of Chemical and Physical Aerosol Properties Relevant for Climate and Health
- 2013
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Atmospheric aerosol particles have substantial influence on climate and air quality. However, the anthropogenic influence on the atmospheric aerosol is still poorly known. This limits the understanding of past and future climate changes. Additionally, both epidemiological and toxicological studies indicate adverse health effects of inhaled aerosol particles. In order to study the effect of atmospheric processes on the particle properties relevant for climate and health, two models were developed and implemented. The first is a 2D-Lagrangian model for Aerosol Dynamics, gas phase CHEMistry and radiative transfer (ADCHEM), which treats the dispersion in the vertical and horizontal direction perpendicular to air mass trajectories. The second model is a kinetic multilayer model for Aerosol Dynamics, gas and particle phase chemistry in laboratory CHAMber environments (ADCHAM). With ADCHAM it is possible to study process based formation and evaporation of secondary organic aerosol particles, and mass transfer limitations and reactions within the particle phase. ADCHEM was used to quantify the anthropogenic influence from the city of Malmö (280 000 inhabitants) in southern Sweden. In Malmö and a few tens of kilometres downwind, the primary particle emissions have a large influence on the particle number concentration. However, more than 2 hours downwind Malmö, the anthropogenic particle mass contribution is dominated by secondary ammonium nitrate. To quantify the direct and indirect climate impact of urban aerosol emissions, the secondary aerosol formation which changes the optical and hygroscopic properties of the primary soot particles, needs to be addressed in future measurements and process modelling. ADCHAM was used to simulate different laboratory chamber experiment, with focus on potential influential but poorly known processes for secondary organic aerosol properties, formation and evaporation rates in the atmosphere (i.e. oligomerization, organic salt formation, salting-out effects, oxidation of organic compounds in the particle phase and mass transfer limitations in the particle phase). The model results reveal that formation of small amounts of low-volatile and long lived oligomers, which accumulate in the particle surface layers, can effectively prevent the evaporation of more volatile compounds. This can significantly prolong the lifetime of SOA in the atmosphere.
|
|
| 59. |
|
|
| 60. |
- Roldin, Pontus, et al.
(författare)
-
The role of highly oxygenated organic molecules in the Boreal aerosol-cloud-climate system
- 2019
-
Ingår i: Nature Communications. - : Springer Science and Business Media LLC. - 2041-1723. ; 10, s. 1-15
-
Tidskriftsartikel (refereegranskat)abstract
- Over Boreal regions, monoterpenes emitted from the forest are the main precursors for secondary organic aerosol (SOA) formation and the primary driver of the growth of new aerosol particles to climatically important cloud condensation nuclei (CCN). Autoxidation of monoterpenes leads to rapid formation of Highly Oxygenated organic Molecules (HOM). We have developed the first model with near-explicit representation of atmospheric new particle formation (NPF) and HOM formation. The model can reproduce the observed NPF, HOM gas-phase composition and SOA formation over the Boreal forest. During the spring, HOM SOA formation increases the CCN concentration by ~10 % and causes a direct aerosol radiative forcing of −0.10 W/m2. In contrast, NPF reduces the number of CCN at updraft velocities < 0.2 m/s, and causes a direct aerosol radiative forcing of +0.15 W/m2. Hence, while HOM SOA contributes to climate cooling, NPF can result in climate warming over the Boreal forest.
|
|
