| 7611. |
- Kesteloot, N., et al.
(författare)
-
Deformation and mixing of coexisting shapes in neutron-deficient polonium isotopes
- 2015
-
Ingår i: Physical Review C (Nuclear Physics). - 0556-2813. ; 92:5
-
Tidskriftsartikel (refereegranskat)abstract
- Coulomb-excitation experiments are performed with postaccelerated beams of neutron-deficient Po-196,Po-198,Po-200,Po-202 isotopes at the REX-ISOLDE facility. A set of matrix elements, coupling the low-lying states in these isotopes, is extracted. In the two heaviest isotopes, Po-196,Po-198, the transitional and diagonal matrix elements of the 2(1)(+) state are determined. In Po-196,Po-198 multistep Coulomb excitation is observed, populating the 4(1)(+), 0(2)(+), and 2(2)(+) states. The experimental results are compared to the results from the measurement of mean-square charge radii in polonium isotopes, confirming the onset of deformation from Po-196 onwards. Three model descriptions are used to compare to the data. Calculations with the beyond-mean-field model, the interacting boson model, and the general Bohr Hamiltonian model show partial agreement with the experimental data. Finally, calculations with a phenomenological two-level mixing model hint at the mixing of a spherical structure with a weakly deformed rotational structure.
|
|
| 7612. |
- Kester, O., et al.
(författare)
-
Accelerated radioactive beams from REX-ISOLDE
- 2003
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section B: Beam Interactions with Materials and Atoms. - 0168-583X. ; 204, s. 20-20
-
Konferensbidrag (refereegranskat)abstract
- In 2001 the linear accelerator of the Radioactive beam EXperiment (REX-ISOLDE) delivered for the first time accelerated radioactive ion beams, at a beam energy of 2 MeV/u. REX-ISOLDE uses the method of charge-state breeding, in order to enhance the charge state of the ions before injection into the LINAC. Radioactive singly-charged ions from the on-line mass separator ISOLDE are first accumulated in a Penning trap, then charge bred to an A/q
|
|
| 7613. |
- Ketzel, Matthias
(författare)
-
Dispersion and Transformation of Traffic Exhaust Particles in the Urban Atmosphere
- 2004
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Ultrafine particles, their sources and fate in the atmosphere are currently key issues in atmospheric research owing to concern about their effects on human health and global climate. Traffic emissions are a dominating source of ultrafine particles, especially in urban areas. After release into the atmosphere, the particles are subjected to complex dilution and transformation processes that are often treated in aerosol dynamics and dispersion models to better understand observations and to make predictions or scenario calculations for future situations. This thesis contributes to the validation and the refinement of existing urban dispersion models and their extension towards a prediction of particle size distributions. By analysing measurements of particle and gaseous pollutants and by application of various dispersion and aerosol dynamics models, the work aims at identifying and exploring the relevant processes that should be included in practical air pollution models for particles. The relevance of the turbulence produced by the vehicle movements for the dispersion inside a street canyon has been shown in field data and a method to incorporate this effect into results from numerical models and wind tunnel measurements has been developed. Dispersion models of different complexity are applied to real-world situations and compared with field measurements and wind tunnel experiments. Measurements of ultrafine particle size distribution at kerbside, urban, near-city and rural locations in the Copenhagen area are analysed. They document the temporal and spatial variation of the particle number and mass concentration and can clearly separate the different contributions from the local street traffic, the urban and regional sources. Particle number emission factors per average vehicle and kilometer driven were estimated for typical urban conditions in Denmark. This thesis further investigates the time scales of various dynamic processes during the evolution of the particle size distribution from its emission from a vehicle exhaust pipe through its dilution at kerbside and urban level. We identify the spatial or temporal scales under which the discussed processes are important. The Multi-plume Aerosol dynamics and Transport (MAT) model has been developed to study the dynamics of the particle size distribution in an urban environment. The model used a new vertical dispersion scheme that is coupled to an existing aerosol dynamics model. The model was tested and applied to measurements in the Copenhagen area.
|
|
| 7614. |
- Ketzel, M, et al.
(författare)
-
Particle size distribution and particle mass measurements at urban, near-city and rural level in the Copenhagen area and Southern Sweden
- 2004
-
Ingår i: Atmospheric Chemistry and Physics. - 1680-7324. ; 4, s. 281-292
-
Tidskriftsartikel (refereegranskat)abstract
- Particle size distribution (size-range 3-900 nm) and PM10 was measured simultaneously at an urban background station in Copenhagen, a near-city background and a rural location during a period in September-November 2002. The study investigates the contribution from urban versus regional sources of particle number and mass concentration. The total particle number (ToN) and NOx are well correlated at the urban and near-city level and show a distinct diurnal variation, indicating the common traffic source. The average ToN at the three stations differs by a factor of 3. The observed concentrations are 2500# cm(-3), 4500# cm(-3) and 7700# cm(-3) at rural, near-city and urban level, respectively. PM10 and total particle volume (ToV) are well correlated between the three different stations and show similar concentration levels, in average within 30% relative difference, indicating a common source from long-range transport that dominates the concentrations at all locations. Measures to reduce the local urban emissions of NOx and ToN are likely to affect both the street level and urban background concentrations, while for PM10 and ToV only measurable effects at the street level are probable. Taking into account the supposed stronger health effects of ultrafine particles reduction measures should address particle number emissions. The traffic source contributes strongest in the 10-200 nm particle size range. The maximum of the size distribution shifts from about 20-30 nm at kerbside to 50-60 nm at rural level. Particle formation events were observed in the 3-20 nm size range at rural location in the afternoon hours, mainly under conditions with low concentrations of preexisting aerosol particles. The maximum in the size distribution of the "traffic contribution" seems to be shifted to about 28 nm in the urban location compared to 22 nm at kerbside. Assuming NOx as an inert tracer on urban scale allows to estimate that ToN at urban level is reduced by 15-30% compared to kerbside. Particle removal processes, e. g. deposition and coagulation, which are most efficient for smallest particle sizes (<20 nm) and condensational growth are likely mechanisms for the loss of particle number and the shift in particle size.
|
|
| 7615. |
|
|
| 7616. |
- Khalil, Shaaban, et al.
(författare)
-
A combined approach to the analysis of space and ground experimental data within a simplified E6SSM
- 2022
-
Ingår i: European Physical Journal C. - : Springer. - 1434-6044 .- 1434-6052. ; 82:11
-
Tidskriftsartikel (refereegranskat)abstract
- Within the Exceptional Supersymmetric Standard Model (E6SSM), we investigate signatures at the Large Hadron Collider (LHC) for a long-lived charged inert higgsino, which is degenerate with the inert neutralino at tree level and a small mass splitting is generated at the loop level, resulting in a lifetime O(0.02) nanoseconds. We focus on the most sensitive search for long-lived charged inert higgsino decays to the lightest neutral inert higgsino dark matter and very soft charged leptons, which are eventually stopped in the detector resulting in a disappearing-track signal. Furthermore, we study the displaced vertex signature of the inert chargino in the case where it is produced via the Z' portal. We illustrate how difficult it is to construct displaced vertices in this class of models, though some evidence could be gained at the High Luminosity LHC. Finally, we compare the spin independent and spin dependent cross sections of the lightest inert higgsino DM to those of current direct detection experiments, proving that it is possible to gain sensitivity to the active DM component of this scenario in the near future. The combination of these signatures with the one emerging from Z' production and decay via Drell-Yan, which can be characterised as belonging to the E6SSM via both the cross section and Forward-Backward Asymmetry, could point uniquely to this non-minimal realisation of Supersymmetry.
|
|
| 7617. |
- Khaplanov, Anton, et al.
(författare)
-
A gamma-ray polarimeter based on a single segmented planar HPGe detector
- 2008
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 593:3, s. 459-465
-
Tidskriftsartikel (refereegranskat)abstract
- The polarization sensitivity of a segmented planar HPGe detector has been measured. For this purpose 662 keV photons from a Cs-137 source which were Compton scattered at approximate to 90 degrees in a coaxial germanium detector were utilized as a source of partially linearly polarized gamma radiation of the energy; approximate to 288 keV. The detector has a 50 x 50 x 21 mm sensitive volume and 5 x 5 electrical segmentation of the cathode contact. The degree of linear polarization is determined through the analysis of the directions of Compton scatterings inside the detector. The locations of the Compton scattering interactions and of the subsequent photo-absorption interactions have been determined with the help of pulse shape analysis (PSA), provided that these interactions are in two different segments of the planar detector. A comparison with a polarization analysis using the position resolution defined by the physical segmentation (without the use of PSA) was also performed. It is demonstrated that the use of PSA enables a much higher polarization sensitivity for events where the 288 keV photons scatter between adjacent pixels. Such events constitute 90% of the data for the 288 keV photons and are even more important for gamma-rays of lower energies.
|
|
| 7618. |
- Khaplanov, Anton, 1980-
(författare)
-
Applications of Pulse Shape Analysis Techniques for Segmented Planar Germanium Detectors
- 2007
-
Licentiatavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The application of pulse shape analysis (PSA) and γ-ray tracking techniques has attracted a great deal of interest in the recent years in fields ranging from nuclear structure studies to medical imaging. These new data analysis methods add position sensitivity as well as directional information for the detected γ-rays to the excellent energy resolution of germanium detectors. This thesis focuses on the application of PSA on planar segmented germanium detectors, divided into three separate studies. The pulse shape analysis technique known as the matrix method was chosen due to its ability to treat events with arbitrary number and combinations of interactions within a single detector. It has been applied in two experiments with the 25-fold segmented planar pixel detector -- imaging and polarization measurements -- as well as in a simulation of upcoming detectors for DESPEC at NuSTAR/FAIR. In the first experiment, a point source of 137Cs was imaged. Events where the 662 keV γ-rays scattered once and were then absorbed in a different segment were treated by the PSA algorithm in order to find the locations of these interactions. The Compton scattering formula was then used to determine the direction to the source. The experiment has provided a robust test of the performance of the PSA algorithm on multiple interaction events, in particular those with interactions in adjacent segments, as well as allowed to estimate the realistically attainable position resolution. In the second experiment, the response of the detector to polarized photons of 288 keV was studied. The polarization of photons can be measured through the observation of the angular distribution of Compton-scattered photons, Hence the ability to resolve the interaction locations had once again proven useful. The third study is focused on the performance of the proposed planar germanium detectors for the DESPEC array. As these detectors have not yet been manufactured at the time of this writing, a set of data simulated in GEANT4 was used. The detector response was calculated for two of the possible segmentation patterns -- that with a single pixelated contact and one where both contacts are segmented into mutually orthogonal strips. In both cases, PSA was applied in order to reconstruct the interaction locations from this response. It was found that the double-sided strip detector can achieve an over-all better position resolution with a given number of readout channels. However, this comes at the expense of a small number of complex events where the reconstruction fails. These results have also been compared to the performance of the 25-fold pixelated detector.
|
|
| 7619. |
- Khaplanov, Anton, et al.
(författare)
-
Compton imager based on a single planar segmented HPGe detector
- 2007
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 580, s. 1075-1078
-
Tidskriftsartikel (refereegranskat)abstract
- A collimator-free Compton imaging system has been developed based on a single high-purity germanium detector and used to generate images of radioactive sources emitting gamma rays. The detector has a planar crystal with one pixellated contact with a total of 25 segments. Pulse shape analysis has been applied to achieve a 3D-position sensitivity of the detector. The first imaging results from this detector are presented, based on the reconstruction of events where a gamma ray is fully absorbed after scattering between adjacent segments.
|
|
| 7620. |
- Khaplanov, Anton, 1980-
(författare)
-
Position-sensitive germanium detectors for gamma-ray tracking, imaging and polarimetry
- 2010
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Modern germanium detectors are often manufactured with two-dimensionally segmented electrical contacts. Signals induced in each segment are read out simultaneously when a photon is detected. Detailed pulse shape analysis (PSA) of these signals allows to resolve positions of individual γ-ray interactions with a precision of at least a few mm. The track of a photon can then be reconstructed using γ-ray tracking. Using these techniques, highly efficient large-volume germanium detectors can replace detector systems where previously highly granulated detector arrays were required, and/or large fractions of photons had to be rejected. The ability to reconstruct the direction of an incoming photon and its scattering path makes it possible to use segmented detectors for γ-ray imaging and polarimetry. Doppler correction of photon energies in experiments where γ rays are emitted from fast ion beams can be greatly improved due to improved determination of the emission angle with respect to the beam. Furthermore, arrays of many detectors can be built without the need for conventional anticoincidence detectors for escape suppression. Instead, photons escaping a detector crystal can be tracked through neighbouring ones.In this work position reconstruction accuracy was evaluated for segmented detectors in a number of geometries in realistic applications. Particular emphasis has been put on the reconstruction of data sets containing events of arbitrary complexity in terms of the number of hit segments and interactions per segment. The imaging and polarization sensitivities of a single planar germanium pixel detector have been evaluated experimentally. In these measurements, photons absorbed in two, often adjacent, segments were reconstructed. Simulated interactions of γ-rays with the detectors of the proposed DESPEC germanium array were analysed yielding the position resolution obtainable in realistic experimental situations, as well as its dependence on photon energy, event complexity, noise and other sources of error.
|
|
