| 1. |
- Abata, E., et al.
(författare)
-
Study of energy response and resolution of the ATLAS barrel calorimeter to hadrons of energies from 20 to 350 GeV
- 2010
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier. - 0168-9002 .- 1872-9576 .- 0167-5087. ; 621:1-3, s. 134-150
-
Tidskriftsartikel (refereegranskat)abstract
- A fully instrumented slice of the ATLAS detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. In this paper, the results of the measurements of the response of the barrel calorimeter to hadrons with energies in the range 20-350 GeV and beam impact points and angles corresponding to pseudo-rapidity values in the range 0.2-0.65 are reported. The results are compared to the predictions of a simulation program using the Geant 4 toolkit. (C) 2010 Published by Elsevier B.V.
|
|
| 2. |
- Aad, G., et al.
(författare)
-
Readiness of the ATLAS Tile Calorimeter for LHC collisions
- 2010
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 70:4, s. 1193-1236
-
Tidskriftsartikel (refereegranskat)abstract
- The Tile hadronic calorimeter of the ATLAS detector has undergone extensive testing in the experimental hall since its installation in late 2005. The readout, control and calibration systems have been fully operational since 2007 and the detector has successfully collected data from the LHC single beams in 2008 and first collisions in 2009. This paper gives an overview of the Tile Calorimeter performance as measured using random triggers, calibration data, data from cosmic ray muons and single beam data. The detector operation status, noise characteristics and performance of the calibration systems are presented, as well as the validation of the timing and energy calibration carried out with minimum ionising cosmic ray muons data. The calibration systems' precision is well below the design value of 1%. The determination of the global energy scale was performed with an uncertainty of 4%.
|
|
| 3. |
- Aad, G, et al.
(författare)
-
- 2014
-
Ingår i: Physical Review Letters. - 1079-7114 .- 0031-9007. ; 113:17
-
Tidskriftsartikel (refereegranskat)
|
|
| 4. |
- Abulaiti, Yiming, et al.
(författare)
-
Technical Design Report for the Phase-II Upgrade of the ATLAS Tile Calorimeter
- 2018
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- This Technical Design Report describes the project to upgrade the ATLAS Tile Calorimeter for the operation at the High Luminosity LHC. The High Luminosity LHC is planned to begin operation in 2026 and to deliver more than ten times the integrated luminosity (up to 4000 fb"^{-1}" of the LHC Runs 1-3 combined. To achieve this integrated luminosity in a reasonable amount of time, an instantaneous luminosity of up to "7.5\times 10^{34} cm^{-2}s^{-1}" is required, corresponding to up to 200 simultaneous pp interactions per bunch crossing. The large luminosity offers the opportunity for a wealth of physics measurements but presents significant challenges to the detector as well as to the trigger and data acquisition systems in the form of increased trigger rates and detector occupancy. This document summarises the requirements and motivations for the Tile Calorimeter upgrade and gives a detailed technical description of the different components. It describes the beam tests with the prototypes in recent years and the plans for the assembly, quality assurance and the integration of the final system. The document also presents the key aspects of project management with an overview of the organisation, the schedule and the cost.
|
|
| 5. |
- Milstead, David A., et al.
(författare)
-
Study of the material of the ATLAS inner detector for Run 2 of the LHC
- 2017
-
Ingår i: Journal of Instrumentation. - : Institute of Physics (IOP). - 1748-0221. ; 12:12
-
Tidskriftsartikel (refereegranskat)abstract
- The ATLAS inner detector comprises three different sub-detectors: the pixel detector, the silicon strip tracker, and the transition-radiation drift-tube tracker. The Insertable B-Layer, a new innermost pixel layer, was installed during the shutdown period in 2014, together with modifications to the layout of the cables and support structures of the existing pixel detector. The material in the inner detector is studied with several methods, using a low-luminosity s=13 TeV pp collision sample corresponding to around 2.0 nb-1 collected in 2015 with the ATLAS experiment at the LHC. In this paper, the material within the innermost barrel region is studied using reconstructed hadronic interaction and photon conversion vertices. For the forward rapidity region, the material is probed by a measurement of the efficiency with which single tracks reconstructed from pixel detector hits alone can be extended with hits on the track in the strip layers. The results of these studies have been taken into account in an improved description of the material in the ATLAS inner detector simulation, resulting in a reduction in the uncertainties associated with the charged-particle reconstruction efficiency determined from simulation. © 2017 CERN.
|
|
| 6. |
- Aad, G., et al.
(författare)
-
Identification and energy calibration of hadronically decaying tau leptons with the ATLAS experiment in pp collisions at root s=8 TeV
- 2015
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 75:7
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes the trigger and offline reconstruction, identification and energy calibration algorithms for hadronic decays of tau leptons employed for the data collected from pp collisions in 2012 with the ATLAS detector at the LHC center-of-mass energy root s = 8 TeV. The performance of these algorithms is measured in most cases with Z decays to tau leptons using the full 2012 dataset, corresponding to an integrated luminosity of 20.3 fb(-1). An uncertainty on the offline reconstructed tau energy scale of 2-4%, depending on transverse energy and pseudorapidity, is achieved using two independent methods. The offline tau identification efficiency is measured with a precision of 2.5% for hadronically decaying tau leptons with one associated track, and of 4% for the case of three associated tracks, inclusive in pseudorapidity and for a visible transverse energy greater than 20 GeV. For hadronic tau lepton decays selected by offline algorithms, the tau trigger identification efficiency is measured with a precision of 2-8%, depending on the transverse energy. The performance of the tau algorithms, both offline and at the trigger level, is found to be stable with respect to the number of concurrent proton-proton interactions and has supported a variety of physics results using hadronically decaying tau leptons at ATLAS.
|
|
| 7. |
- Aad, G., et al.
(författare)
-
Measurement of the top quark pair production cross section with ATLAS in pp collisions at √s = 7 TeV in dilepton final states
- 2011
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- A measurement is presented of the production cross section of top quark pairs (σ_{\ttbar{}}) in proton-proton (pp) collisions at √s = 7 TeV recorded with the ATLAS detector at the CERN Large Hadron Collider. Using a data sample of 35 pb−1, candidate events are selected in the dilepton topology with large missing transverse energy, \met{}, and at least two jets.A baseline analysis employing kinematic properties of the candidate events to separate the signal from background and using data-driven techniques to determine the most important backgrounds, results in a measurement ofσ_{\ttbar{}} = 173 ± 22(stat.)+18 −16(syst.)+8 −7(lum.) pb,where the three uncertainties are from statistics, systematics and integrated luminosity, respectively.We also perform a cross section measurement requiring at least one b-tagged jet and a looser kinematic selection that increases the signal-to-background ratio, yieldingσ_{\ttbar{}} = 171 ± 22(stat.)+21 -16(syst.)+7 −6(lum.) pb.Additional studies are performed to corroborate these measurements; a technique that normalizes the \ttbar{} signal yield to the measured rate of Z decays, a two-dimensional template shape fit using the \met{} vs the number of jets to simultaneously measure the production cross sections of \ttbar{}, WW and Z → ττ final states, and a simultaneous measurement of σ_{\ttbar{}} and the b-tagging efficiency using the distribution of the number of tagged jets in each event.All the measurements are in good agreement with each other and the Standard Model prediction.
|
|
| 8. |
|
|
| 9. |
- Aad, G., et al.
(författare)
-
Studies of the performance of the ATLAS detector using cosmic-ray muons
- 2011
-
Ingår i: European Physical Journal C. Particles and Fields. - : Springer Science and Business Media LLC. - 1434-6044 .- 1434-6052. ; 71:3
-
Tidskriftsartikel (refereegranskat)abstract
- Muons from cosmic-ray interactions in the atmosphere provide a high-statistics source of particles that can be used to study the performance and calibration of the ATLAS detector. Cosmic-ray muons can penetrate to the cavern and deposit energy in all detector subsystems. Such events have played an important role in the commissioning of the detector since the start of the installation phase in 2005 and were particularly important for understanding the detector performance in the time prior to the arrival of the first LHC beams. Global cosmic-ray runs were undertaken in both 2008 and 2009 and these data have been used through to the early phases of collision data-taking as a tool for calibration, alignment and detector monitoring. These large datasets have also been used for detector performance studies, including investigations that rely on the combined performance of different subsystems. This paper presents the results of performance studies related to combined tracking, lepton identification and the reconstruction of jets and missing transverse energy. Results are compared to expectations based on a cosmic-ray event generator and a full simulation of the detector response.
|
|
| 10. |
- Aad, G., et al.
(författare)
-
The ATLAS Experiment at the CERN Large Hadron Collider
- 2008
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 3:S08003
-
Forskningsöversikt (refereegranskat)abstract
- The ATLAS detector as installed in its experimental cavern at point 1 at CERN is described in this paper. A brief overview of the expected performance of the detector when the Large Hadron Collider begins operation is also presented.
|
|
