| 1. |
- Kahl, Sören, et al.
(författare)
-
Tensile, Fatigue and Creep Properties of Aluminum Heat Exhanger Tube Alloys for Temperatures from 293 K to 573 K (20°C to 300°C)
- 2014
-
Ingår i: Metallurgical and Materials Transactions. A. - : Springer. - 1073-5623 .- 1543-1940. ; 45A:2, s. 663-681
-
Tidskriftsartikel (refereegranskat)abstract
- Since automotive heat exchangers are operated at varying temperatures and under varying pressures, both static and dynamic mechanical properties should be known at different temperatures. Tubes are the most critical part of the most heat exchangers made from aluminum brazing sheet. We present tensile test, stress amplitude-fatigue life, and creep–rupture data of six AA3XXX series tube alloys after simulated brazing for temperatures ranging from 293 K to 573 K (20 °C to 300 °C). While correlations between several mechanical properties are strong, ranking of alloys according to one property cannot be safely deduced from the known ranking according to another property. The relative reduction in creep strength with increasing temperature is very similar for all six alloys, but the general trends are also strong with respect to tensile and fatigue properties; an exception is one alloy that exhibits strong Mg-Si precipitation activity during fatigue testing at elevated temperatures. Interrupted fatigue tests indicated that the crack growth time is negligible compared to the crack initiation time. Fatigue lifetimes are reduced by creep processes for temperatures above approximately 423 K (150 °C). When mechanical properties were measured at several temperatures, interpolation to other temperatures within the same temperature range was possible in most cases, using simple and well-established equations.
|
|
| 2. |
|
|
| 3. |
- Ryen, Øyvind, et al.
(författare)
-
Strengthening mechanisms in solid solution aluminum alloys
- 2006
-
Ingår i: Metallurgical and Materials Transactions. A. - : Springer Science and Business Media LLC. - 1073-5623 .- 1543-1940. ; 37A:6, s. 1999-2006
-
Tidskriftsartikel (refereegranskat)abstract
- A number of commercial and high-purity non-heat-treatable aluminum alloys are investigated in this work. It is found that both magnesium and manganese in solid solution give a nearly linear concentration dependence of the strength at a given strain for commercial alloys. This deviates from high-purity AlMg binary alloys, where a parabolic concentration dependence is found. Mn in solid solution is found to give a considerably higher strengthening effect per atom than Mg, both in terms of yield stress and initial work hardening rate. This strengthening effect is stronger comparing commercial grades to high-purity alloys. This enhanced strengthening is believed to be a synergy or clustering effect caused by interaction between Mn atoms and trace elements, probably silicon, in solid solution.
|
|
| 4. |
|
|
| 5. |
- Svechnikov, S., et al.
(författare)
-
Spiral antenna nbn hot-electron bolometer mixer at submm requencies
- 1997
-
Ingår i: IEEE Transactions on Applied Superconductivity. - : Institute of Electrical and Electronics Engineers (IEEE). - 1558-2515 .- 1051-8223. ; 7:2, s. 3395-3398
-
Tidskriftsartikel (refereegranskat)abstract
- We have studied the phonon-cooled hot-electron bolometer (HEB) as a quasioptical mixer based on a spiral antenna designed for the 0.3-1 THz frequency band and fabricated on sapphire and high resistivity silicon substrates. HEB devices were produced from superconducting 3.5-5 nm thick NbN films with a critical temperature 10-12 K and a critical current density of approximately 10/sup 7/ A/cm/sup 2/ at 4.2 K. For these devices we reached a DSB receiver noise temperature below 1500 K, a total conversion loss of L/sub t/=16 dB in the 500-700 GHz frequency range, an IF bandwidth of 3-4 GHz and an optimal LO absorbed power of /spl sime/4 /spl mu/W. We experimentally analyzed various contributions to the conversion loss and obtained an RF coupling factor of about 5 dB, internal mixer loss of 10 dB and IF mismatch of 1 dB.
|
|
| 6. |
- Ekström, Hans, 1964
(författare)
-
Antenna Integrated Superconducting Mixers
- 1995
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- This thesis investigates the prospects of some different superconducting mixers integrated with planar antennas for the millimeter and submillimeter regime. Two kinds of Superconductor/Insulator/Superconductor (SIS) tunnel junctions for use in mixers have been fabricated; Nb/PbBi edge junctions and Nb trilayer junctions. One of the very high quality trilayer mixers is currently operating in a 350 GHz radio-telescope heterodyne-receiver. The reduced sensitivity of SIS mixers for frequencies above the gap frequency (?700 GHz) of the superconductors has directed the interest towards another type of superconducting mixer device, the superconducting Hot Electron Bolometer (HEB). Various types of this device have been studied; Nb devices for scale-measurements at 20 GHz to more easily verify some of the theoretical background of the HEB, NbN waveguide devices for 100 GHz, and NbN devices integrated with planar antennas for a quasi-optical mixer at 350 GHz. Two types of planar antennas have been used; the endfire "Broken" Linearly Tapered Slotline Antenna (BLTSA) on a thin dielectric membrane, and the double dipole antenna on a quartz substrate lens. The beam pattern of the BLTSA has been examined theoretically and measured at 40 GHz with antennas supported by Kapton foil, and at 350 and 800 GHz with antennas on thin dielectric SiOxNy membranes. Measurements of the 20 GHz Nb HEB show a mixer conversion loss close to 0 dB for IF frequencies below 40 MHz. The maximum IF bandwidth given by the electron temperature relaxation time corresponds to a frequency of about 80 MHz. A DSB mixer noise temperature of only a few hundred Kelvin has been measured. Corresponding measurements of NbN devices at 100 and 350 GHz give a mixer conversion loss of about 6-10 dB and an IF bandwidth of about 700 to 1000 MHz. The output noise is found to be dominated by electron temperature fluctuations with an equivalent noise temperature of about 100 K, and a frequency dependence equal to that of the IF signal. Phenomenological expressions for conversion loss, noise, and IF impedance have been compared measurements and shows good agreement. The quasioptical NbN HEB mixers are still under development with respect to film quality and coupling to radiation, why the mixer performance of these is expected to improve.
|
|
