| 1. |
- Castro, J. M., et al.
(författare)
-
Investigation of 60 Gb/s 4-PAM Using an 850 nm VCSEL and Multimode Fiber
- 2016
-
Ingår i: Journal of Lightwave Technology. - : Institute of Electrical and Electronics Engineers (IEEE). - 0733-8724 .- 1558-2213. ; 34:16, s. 3825-3836
-
Tidskriftsartikel (refereegranskat)abstract
- We investigate 4-pulse-amplitude modulation (PAM) at data rates in the range of 50-60 Gb/s using a directly modulated 850 nm VCSEL and multimode fiber links up to 200 m. The channel conditions in which 4-PAM has performance advantages over traditional ON-OFF keying are evaluated followed by experimental results at data rates of 56.7 Gb/s over distances up to 200 m using equalization and FEC, with a post-FEC bit error rate of 10(-12). The reported analysis is applicable to future Ethernet and Fibre Channel applications requiring 50 Gb/s serial data rates per lane over multimode fibers.
|
|
| 2. |
- Chen, Jingjing, 1982, et al.
(författare)
-
An Energy Efficient 56 Gbps PAM-4 VCSEL Transmitter Enabled by a 100 Gbps Driver in 0.25 µm InP DHBT Technology
- 2016
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 34:21, s. 954-4964
-
Tidskriftsartikel (refereegranskat)abstract
- Datacenters demand higher speed VCSEL-based optical interconnects at low power consumption. As a potential technology enabler, this paper presents a wide bandwidth and energy efficient multilevel PAM VCSEL driver implemented in an InP 0.25 μm double heterojunction bipolar transistor (DHBT) technology. The operational bandwidth of the driver is verified and error-free electrical data transmission up to 56 Gbps PAM-2 and 100 Gbps PAM-4 is demonstrated at a driver energy consumption less than 2 pJ/bit. The driver is integrated and tested with an in-house fabricated 850 nm VCSEL. Error-free 56 Gbps PAM-4 optical transmission at a transmitter energy consumption of 3.7 pJ/bit is demonstrated without equalization. This is the highest data rate reported for an integrated PAM-4 modulated VCSEL transmitter, while being the most energy efficient above 40 Gbps operation. Moreover, the VCSEL driver offers a pre-emphasis feature at PAM-2 operation for improved link throughput and receiver sensitivity.
|
|
| 3. |
- Lengyel, Tamas, 1986, et al.
(författare)
-
Impact of Damping on 50 Gbps 4-PAM Modulation of 25G Class VCSELs
- 2017
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 35:19, s. 4203-4209
-
Tidskriftsartikel (refereegranskat)abstract
- We present an investigation into the effects of photon lifetime and the associated damping of the modulation response on 50 Gbps 4-PAM signal generation with directly modulated 25G class VCSELs. While 4-PAM benefits from higher slope efficiency and output power, it is shown that the greater impact of intensity noise and dynamic nonlinearities implies that a VCSEL with a longer photon lifetime and more damped response is needed when transitioning from existing 25 Gbps OOK to 50 Gbps 4-PAM using the 25G VCSEL technology.
|
|
| 4. |
- Lengyel, Tamas, 1986, et al.
(författare)
-
Sensitivity Improvements in an 850 nm VCSEL-based Link using a Two-tap Pre-emphasis Electronic Filter
- 2016
-
Ingår i: Journal of Lightwave Technology. - : Institute of Electrical and Electronics Engineers (IEEE). - 0733-8724 .- 1558-2213. ; 35:9, s. 1633-1639
-
Tidskriftsartikel (refereegranskat)abstract
- We present an investigation of an ISI penalty reduction for On-Off Keying in an 850 nm VCSEL-based short optical link using a two-tap electronic pre-emphasis filter and quantify the improvement relative to an equivalent link without pre-emphasis. Error-free operation is demonstrated at bit rates above the −3 dB modulation bandwidth of the link. Sensitivity improvement up to 9 dB compared to non-emphasized signaling is shown. A maximum error-free bit rate achievable in the link is increased to 57 Gbps, compared to 52 Gbps without the pre-emphasis.
|
|
| 5. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
Effect of VCSEL Characteristics on Ultra-High Speed Sigma-Delta-Over-Fiber Communication Links
- 2019
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 37:9, s. 2109-2119
-
Tidskriftsartikel (refereegranskat)abstract
- State-of-the-art high-speed multi-mode vertical-cavity surface-emitting-lasers (VCSELs) have a 3-dB analog bandwidth of ∼25 GHz and can operate up to 55 Gbps error-free, without need of equalization electronics. This makes them strong candidates as optical sources for ultra-high speed sigma-delta-over-fiber (SDoF) communication links. This paper examines the effects of VCSEL characteristics on a 32-Gbps SDoF communication link with a 50 m, OM4, multimode optical fiber. Three high-speed, 850-nm-wavelength VCSELs with oxide aperture sizes of 8.3, 6.6, and 4.6 μm were tested. The effects of different modulation voltage amplitudes and bias currents were also investigated. The link performance and VCSEL power consumption were used as figures-of-merits. By avoiding sub-laser threshold modulation for the VCSEL, each of three VCSELs could provide similar link performance. We show that, compared to conventional datacom links, eased bit-error-rate requirements enabled by bi-level nature of sigma-delta modulation makes it possible to use significantly lower VCSEL bias currents. This in turn enables a reduced VCSEL power consumption (50% lower heat-to-bit ratio) and a potential longer VCSEL lifespan. For a SDoF modulated, 160-Mbaud, QAM64 signal centered at 12 GHz an error vector magnitude of -28 dB was achieved with the VCSEL having oxide aperture size of 4.6 μm operating at only 2 mA bias current and 0.25 V modulation amplitude. This results in a heat-to-bit ratio of only 0.1 mW/Gb/s (or equivalently 0.1 pJ/b), and a current density in the VCSEL that is less than 10 kA/cm2.
|
|
