| 1. |
- Sepehri, Sobhan, 1986, et al.
(författare)
-
Volume-amplified magnetic bioassay integrated with microfluidic sample handling and high-Tc SQUID magnetic readout
- 2018
-
Ingår i: APL Bioengineering. - : AIP Publishing. - 2473-2877. ; 2:1
-
Tidskriftsartikel (refereegranskat)abstract
- A bioassay based on a high-Tc superconducting quantum interference device (SQUID) reading out functionalized magnetic nanoparticles (fMNPs) in a prototype microfluidic platform is presented. The target molecule recognition is based on volume amplification using padlock-probe-ligation followed by rolling circle amplification (RCA). The MNPs are functionalized with single-stranded oligonucleotides, which give a specific binding of the MNPs to the large RCA coil product, resulting in a large change in the amplitude of the imaginary part of the ac magnetic susceptibility. The RCA products from amplification of synthetic Vibrio cholera target DNA were investigated using our SQUID ac susceptibility system in microfluidic channel with an equivalent sample volume of 3 μl. From extrapolation of the linear dependence of the SQUID signal versus concentration of the RCA coils, it is found that the projected limit of detection for our system is about 1.0 e5 RCA coils (0.2e−18 mol), which is equivalent to 66 fM in the 3 μl sample volume. This ultra-high magnetic sensitivity and integration with microfluidic sample handling are critical steps towards magnetic bioassays for rapid detection of DNA and RNA targets at the point of care.
|
|
| 2. |
- Öhman, Sebastian, 1991-, et al.
(författare)
-
Selective kinetic growth and role of local coordination in forming Al2TiO5-based coatings at lower temperatures
- 2021
-
Ingår i: Materials Advances. - : Royal Society of Chemistry. - 2633-5409. ; 2:17, s. 5737-5751
-
Tidskriftsartikel (refereegranskat)abstract
- Negative thermal expansion is an elusive property found among certain materials, whose potential applications have remained limited due to the many challenges faced in their synthesis. Herein, we report the successful formation of aluminium titanate-based coatings (Al2TiO5), a material renowned for its low-to-negative thermal expansion, by the co-deposition of aluminium-isopropoxide and titanium-isopropoxide in a hot-wall chemical vapour deposition instrument. While coatings grown at 450 °C were amorphous as-deposited, a short-range order into the Al2TiO5-phase was found and analysed by using Raman spectroscopy. Upon subsequent annealing at 700 °C for 3 hours, crystalline coatings were achieved without forming any binary phases. The selective synthesis of the Al2TiO5 phase is ascribed to the precursors’ inherent chemical similarities, resulting in a kinetic targeting of this phase and a short-range homogeneity, entailing its preferred crystallisation. The role of local coordination is expressed by demonstrating the formation of intergrowth phases ascribed to lower coordinating interstices in the compound. Both the formation and crystallisation temperatures reported herein, as well as the timescales needed for the synthesises, are considerably lower than any conventional adopted solid-state techniques used so far to attain the Al2TiO5 phase.
|
|
| 3. |
- Hägglund, Carl, 1975, et al.
(författare)
-
Plasmonic Near-Field Absorbers for Ultrathin Solar Cells
- 2012
-
Ingår i: Journal of Physical Chemistry Letters. - : American Chemical Society (ACS). - 1948-7185. ; 3:10, s. 1275-1285
-
Forskningsöversikt (refereegranskat)abstract
- If the active layer of efficient solar cells could be made 100 times thinner than in today's thin film devices, their economic competitiveness would greatly benefit. However, conventional solar cell materials do not have the optical capability to allow for such thickness reductions without a substantial loss of light absorption. To address this challenge, the use of plasmon resonances in metal nanostructures to trap light and create charge carriers in a nearby semiconductor material is an interesting opportunity. In this Perspective, recent progress with regards to ultrathin (similar to 10 nm) plasmonic nanocomposites is reviewed. Their optimal internal geometry for plasmon near-field induced absorption is discussed, and a zero thickness effective medium representation is used to optimize stacks including an Al back reflector for photovoltaics. This shows that high conversion efficiencies (>20%) are possible even when taking surface scattering effects and thin passivating layers inserted between the metal and semiconductor into account.
|
|
| 4. |
- Halvarsson, Björn, et al.
(författare)
-
A New Input/Output Pairing Strategy based on Linear Quadratic Gaussian Control
- 2009
-
Ingår i: Proc. 7th IEEE International Conference on Control and Automation, Dec. 9-11, Christchurch, New Zealand. - Piscataway, NJ : IEEE. - 9781424447060 ; , s. 978-982
-
Konferensbidrag (refereegranskat)abstract
- In this paper a new input/output pairing strategy based on linear quadratic Gaussian control (LQG) is suggested. The strategy is used to compare the expected performance of decentralized control structures in some illustrative examples. The pairing suggestions are compared with the recommendations previously obtained using other interaction measures such as the Relative Gain Array (RGA). The new strategy gives suitable pairing recommendations and is easy to interpret.
|
|
| 5. |
- Jeong, Seung Hee, 1978-, et al.
(författare)
-
Stretchable Thermoelectric Generators Metallized with Liquid Alloy
- 2017
-
Ingår i: ACS Applied Materials & Interfaces. - : American Chemical Society (ACS). - 1944-8252 .- 1944-8244. ; 9:18, s. 15791-15797
-
Tidskriftsartikel (refereegranskat)abstract
- Conventional thermoelectric generators (TEGs) are normally hard, rigid, and flat. However, most objects have curvy surfaces, which require soft and even stretchable TEGs for maximizing efficiency of thermal energy harvesting. Here, soft and stretchable TEGs using conventional rigid Bi2Te3 pellets metallized with a liquid alloy is reported. The fabrication is implemented by means of a tailored layer-by-layer fabrication process. The STEGs exhibit an output power density of 40.6 ?W/cm2 at room temperature. The STEGs are operational after being mechanically stretched-and-released more than 1000 times, thanks to the compliant contact between the liquid alloy interconnects and the rigid pellets. The demonstrated interconnect scheme will provide a new route to the development of soft and stretchable energy-harvesting avenues for a variety of emerging electronic applications.
|
|
| 6. |
- Mazzotta, Francesco, 1985, et al.
(författare)
-
Nanoplasmonic biosensing with on-chip electrical detection
- 2010
-
Ingår i: Biosensors and Bioelectronics. - : Elsevier BV. - 0956-5663 .- 1873-4235. ; 26:4, s. 1131-1136
-
Konferensbidrag (refereegranskat)abstract
- A nanoplasmonic biosensor chip with integrated electrical detection is presented. The concept is based on the local refractive index sensitivity of nanoplasmonic gold nanodisks (110 nm in diameter and 20 nm in height) that are fabricated, through a parallel method, directly on an array of silicon solar cells or photoactive diodes. The nanoplasmonic properties of the sensor chip were investigated both optically and electrically, with excellent agreement between the two. We show that local changes in the refractive index of the surrounding environment gives changes in the nanoplasmonic properties of the gold nanodisks, which induce corresponding changes in the photocurrent at single wavelengths of the nanoplasmonic solar cells. With a simple light-emitting diode as light source, and together with a material-specific modification protocol, the photocurrent output of the nanoplasmonic sensor chip was successfully used to monitor a specific biorecognition reaction in real-time.
|
|
| 7. |
- Al Nahas, Beshr, 1985, et al.
(författare)
-
Low-power listening goes multi-channel
- 2014
-
Ingår i: Proceedings - IEEE International Conference on Distributed Computing in Sensor Systems, DCOSS 2014. ; , s. 2-9
-
Konferensbidrag (refereegranskat)abstract
- Exploiting multiple radio channels for communication has been long known as a practical way to mitigate interference in wireless settings. In Wireless Sensor Networks, however, multi-channel solutions have not reached their full potential: the MAC layers included in TinyOS or the Contiki OS for example are mostly single-channel. The literature offers a number of interesting solutions, but experimental results were often too few to build confidence. We propose a practical extension of low-power listening, MiCMAC, that performs channel hopping, operates in a distributed way, and is independent of upper layers of the protocol stack. The above properties make it easy to deploy in a variety of scenarios, without any extra configuration/scheduling/channel selection hassle. We implement our solution in Contiki and evaluate it in a 97-node~testbed while running a complete, out-of-the-box low-power IPv6 communication stack (UDP/RPL/6LoWPAN). Our experimental results demonstrate increased resilience to emulated WiFi interference (e.g., data yield kept above 90% when Contiki MAC drops in the 40% range). In noiseless environments, MiCMAC keeps the overhead low in comparison to Contiki MAC, achieving performance as high as 99% data yield along with sub-percent duty cycle and sub-second latency for a 1-minute inter-packet interval data collection. © 2014 IEEE.
|
|
| 8. |
- Eklund, Petter, 1989-, et al.
(författare)
-
Experimental Evaluation of a Rare Earth-Free Permanent Magnet Generator
- 2021
-
Ingår i: IEEE Transactions on Energy Conversion. - Piscataway : Institute of Electrical and Electronics Engineers (IEEE). - 1558-0059 .- 0885-8969. ; 36:1, s. 3-10
-
Tidskriftsartikel (refereegranskat)abstract
- Low speed, high torque machines are used in wind turbines where the turbine rotor is directly connected to the generator. A permanent magnet synchronous generator using high-energy rare-earth permanent magnets (PMs) is one common choice for this application, but rare-earth PMs have supply insecurities and cost risks. A rare-earth free 32-pole PM generator, using ferrite PMs in a spoke-type rotor, for use in a 12 kW experimental wind turbine is built and tested. Voltages and currents at load and no load are measured, as well as the magnetic field in the end regions of the machine. The generator can deliver the required power at nominal speed and has low harmonic content in the output. The electrical measurements are compared to two-dimensional finite element design calculations and the experimental results are lower than expected from simulations. The measured voltage is lower than expected, requiring a higher current than calculated for the rated power. Three-dimensional magnetic field simulations show that there are leakage flux paths in the end-regions that the two-dimensional design calculations overlook, explaining the discrepancy between simulations and measurements.
|
|
| 9. |
- Mühlig, Kerstin, et al.
(författare)
-
Nanometre-sized droplets from a gas dynamic virtual nozzle
- 2019
-
Ingår i: Journal of Applied Crystallography. - : INT UNION CRYSTALLOGRAPHY. - 1600-5767 .- 0021-8898. ; 52, s. 800-808
-
Tidskriftsartikel (refereegranskat)abstract
- This paper reports on improved techniques to create and characterize nanometre-sized droplets from dilute aqueous solutions by using a gas dynamic virtual nozzle (GDVN). It describes a method to measure the size distribution of uncharged droplets, using an environmental scanning electron microscope, and provides theoretical models for the droplet sizes created. The results show that droplet sizes can be tuned by adjusting the gas and liquid flow rates in the GDVN, and at the lowest liquid flow rates, the size of the water droplets peaks at about 120 nm. This droplet size is similar to droplet sizes produced by electrospray ionization but requires neither electrolytes nor charging of the solution. The results presented here identify a new operational regime for GDVNs and show that predictable droplet sizes, comparable to those obtained by electrospray ionization, can be produced by purely mechanical means in GDVNs.
|
|
| 10. |
- Ollas, Patrik, et al.
(författare)
-
Evaluating the role of solar photovoltaic and battery storage in supporting electric aviation and vehicle infrastructure at Visby Airport
- 2023
-
Ingår i: Applied Energy. - : Elsevier. - 0306-2619 .- 1872-9118. ; 352
-
Tidskriftsartikel (refereegranskat)abstract
- Following the societal electrification trend, airports face an inevitable transition of increased electric demand,driven by electric vehicles (EVs) and the potential rise of electric aviation (EA). For aviation, short-haul flightsare first in line for fuel exchange to electrified transportation. This work studies the airport of Visby, Sweden and the effect on the electrical power system from EA and EV charging. It uses the measured airport loaddemand from one year’s operation and simulated EA and EV charging profiles. Solar photovoltaic (PV) and electrical battery energy storage systems (BESS) are modelled to analyse the potential techno-economical gains.The BESS charge and discharge control are modelled in four ways, including a novel multi-objective (MO) dispatch to combine self-consumption (SC) enhancement and peak power shaving. Each model scenario iscompared for peak power shaving ability, SC rate and pay-back-period (PBP). The BESS controls are alsoevaluated for annual degradation and associated cost. The results show that the novel MO dispatch performswell for peak shaving and SC, effectively reducing the BESS’s idle periods. The MO dispatch also results in the battery controls’ lowest PBP (6.9 years) using the nominal economic parameters. Furthermore, a sensitivityanalysis for the PBP shows that the peak power tariff significantly influences the PBP for BESS investment.
|
|
