1. |
- Abbas, Ghazanfar, et al.
(författare)
-
Preparation and characterization of nanocomposite calcium doped ceria electrolyte with alkali carbonates (NK-CDC) for SOFC
- 2010
-
Ingår i: ASME 2010 8th International Conference on Fuel Cell Science, Engineering and Technology, FUELCELL 2010. - : ASME Press. - 9780791844052 ; , s. 427-432
-
Konferensbidrag (refereegranskat)abstract
- The entire world's challenge is to find out the renewable energy sources due to rapid depletion of fossil fuels because of their high consumption. Solid Oxide Fuel Cells (SOFCs) are believed to be the best alternative source which converts chemical energy into electricity without combustion. Nanostructured study is required to develop highly ionic conductive electrolyte for SOFCs. In this work, the calcium doped ceria (Ce0.8Ca0.2O 1.9) coated with 20% molar ratio of two alkali carbonates (CDC-M: MCO3, where M= Na and K) electrolyte was prepared by co-precipitation method in this study. Ni based electrode was used to fabricate the cell by dry pressing technique. The crystal structure and surface morphology was characterized by X-Ray Diffractometer (XRD), Scanning Electron Microscopy (SEM) and High Resolution Transmission Electron Microscopy (HRTEM). The particle size was calculated in the range of 10-20nm by Scherrer's formula and compared with SEM and TEM results. The ionic conductivity was measured by using AC Electrochemical Impedance Spectroscopy (EIS) method. The activation energy was also evaluated. The performance of the cell was measured 0.567W/cm2 at temperature 550°C with hydrogen as a fuel.
|
|
2. |
- Raza, Rizwan, et al.
(författare)
-
GDC-Y2O3 Oxide Based Two Phase Nanocomposite Electrolytes
- 2010
-
Ingår i: PROCEEDINGS OF THE ASME 8TH INTERNATIONAL CONFERENCE ON FUEL CELL SCIENCE, ENGINEERING, AND TECHNOLOGY 2010, VOL 1. - NEW YORK : AMER SOC MECHANICAL ENGINEERS. - 9780791844045 ; , s. 365-370
-
Konferensbidrag (refereegranskat)abstract
- An oxide based two phase nanocomposite electrolyte (Ce0.9Gd0.1O2) was synthesized by a co-precipitation method and coated with Yttrium oxide (Y2O3). The nanocomposite electrolyte showed the significant performance of power density 750mW/cm(2) and higher conductivities at relatively low temperature 550 degrees C. Ionic conductivities were measured with electrochemical impedance spectroscopy (EIS) and DC (4 probe method). The structural and morphological properties of the prepared electrolyte were investigated by means of High Resolution Scanning Electron Microscopy (HRSEM). The thermal stability was determined with Differential Scanning Calorimetry (DSC). The particle size was calculated with Scherrer formula and compare with SEM results, 15-20 nm is in a good agreement with the SEM and X-ray diffraction (XRD) results. The purpose of the study to introduce the functional nanocomposite materials, for advanced fuel cell technology (NANOCOFC) to meet the challenges of solid oxide fuel cell (SOFC).
|
|