| 1. |
|
|
| 2. |
- Yaneva, A., et al.
(författare)
-
FAST-TIMING MEASUREMENT IN 96Pd: IMPROVED ACCURACY FOR THE LIFETIME OF THE 4+1 STATE
- 2023
-
Ingår i: Acta Physica Polonica B, Proceedings Supplement. - : Jagiellonian University. - 1899-2358 .- 2082-7865. ; , s. 1-1
-
Konferensbidrag (refereegranskat)abstract
- Direct lifetime measurements via γ–γ coincidences using the FATIMA fast-timing LaBr3(Ce) array were performed for the excited states below previously reported isomers. In the N = 50 semi-magic 96Pd nucleus, lifetimes below the Iπ = 8+ seniority isomer were addressed as a benchmark for further analysis. The results for the Iπ = 2+ and 4+ states confirm the published values. Increased accuracy for the lifetime value was achieved for the 4+ state.
|
|
| 3. |
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Rabih, A. A. S., et al.
(författare)
-
MetalMUMPs resonator for acetone vapor sensing
- 2017
-
Ingår i: Proceedings of the 2017 IEEE regional symposium on micro and nanoelectronics (RSM). - : IEEE. - 9781509040292 ; , s. 5-9
-
Konferensbidrag (refereegranskat)abstract
- Acetone vapor monitoring is essential in workplace for human health and safety, where exposure to acetone concentration more than 176 parts per million (ppm) can cause damage to eyes, liver, kidneys and central nervous system. In addition, acetone in exhaled breath is known to be good biomarker for non-invasive screening of diabetes. The most common used acetone vapor sensors are based on metal oxide semiconductor sensors, which work at higher temperatures, and hence consume more power. This paper reports MetalMUMPs device for acetone vapor sensing for environmental monitoring. The device is based on electrothermal actuation and capacitive sensing using differential capacitance measurement technique. MS3110 universal capacitive readout circuit was used to readout the small change of the static capacitance when the device is actuated using 0.71 Vrms with a driving frequency range of 0.5 kHz-8 kHz. The output signal of the circuit is given as a voltage and it can be directly related to the capacitance change. The output voltage change was found to increase linearly with increasing the acetone vapor concentration from 100 ppm to 500 ppm with a concentration sensitivity of 0.65 mV/ppm.
|
|
| 8. |
|
|
| 9. |
- Ahmed, Kazi Main Uddin, 1989-, et al.
(författare)
-
Characterizing Failure and Repair Time of Servers in a Hyper-scale Data Center
- 2020
-
Ingår i: Proceedings of 2020 IEEE PES Innovative Smart Grid Technologies Europe (ISGT-Europe) 26-28 October, 2020. - : IEEE. ; , s. 660-664
-
Konferensbidrag (refereegranskat)abstract
- Hyper-scale data centers are used to host cloud computing interfaces to support the increasing demand for storage and computational resources. For achieving specific service level agreements (SLA), this infrastructure demands highly available cloud computing systems. It is necessary to analyze the server failure incidents to determine the way of improving the reliability of the system since the computational interruption causes financial losses for the data center owners. Regarding the reliability analysis, it is important to characterize the time to failure and time to repair of the servers. In this paper, a publicly available data set from Google cloud-cluster data center will be analyzed to find the distribution function for the time to failure and the time to repair for the servers in a cloud based data centers.
|
|
| 10. |
- Ahmed, Kazi Main Uddin, 1989-, et al.
(författare)
-
The Impacts of Voltage Disturbances Due to Faults In the Power Supply System of A Data Center
- 2022
-
Ingår i: 2022 20th International Conference on Harmonics & Quality of Power (ICHQP) Proceedings. - : IEEE.
-
Konferensbidrag (refereegranskat)abstract
- The internal power condition system (IPCS) in data centers is prone to have cable faults that cause voltage dips and swells. The voltage dips and swells impact the power supply units (PSUs) with the servers. The servers connected with the PUSs restart or turn-off when the input voltage comes out of the voltage-tolerance range. This paper analyses the impact of such voltage disturbances on server outages due to a single-phase fault in the IPCS. The voltage-tolerance range of the PSUs is considered according to the guideline of the Information Technology Industry Council (ITIC). The voltage dip propagates to the healthy load sections from the fault location, while voltage swells are also observed due to sudden load reduction. Moreover, the current limitation mode of the inverter in the uninterrupted power supply (UPS) is identified as a cause of voltage dip to almost zero experienced by the PSUs. The reliability of the data center considering the outage probability of the servers are finally quantified to show the impacts of the voltage dips and swells in the IPCS.
|
|
