SwePub
Sök i SwePub databas

  Utökad sökning

Träfflista för sökning "WFRF:(Al Ahmad M) ;lar1:(kth)"

Sökning: WFRF:(Al Ahmad M) > Kungliga Tekniska Högskolan

  • Resultat 1-5 av 5
Sortera/gruppera träfflistan
   
NumreringReferensOmslagsbildHitta
1.
  • Abat, E., et al. (författare)
  • Photon reconstruction in the ATLAS Inner Detector and Liquid Argon Barrel Calorimeter at the 2004 Combined Test Beam
  • 2011
  • Ingår i: Journal of Instrumentation. - 1748-0221. ; 6
  • Tidskriftsartikel (refereegranskat)abstract
    • The reconstruction of photons in the ATLAS detector is studied with data taken during the 2004 Combined Test Beam, where a full slice of the ATLAS detector was exposed to beams of particles of known energy at the CERN SPS. The results presented show significant differences in the longitudinal development of the electromagnetic shower between converted and unconverted photons as well as in the total measured energy. The potential to use the reconstructed converted photons as a means to precisely map the material of the tracker in front of the electromagnetic calorimeter is also considered. All results obtained are compared with a detailed Monte-Carlo simulation of the test-beam setup which is based on the same simulation and reconstruction tools as those used for the ATLAS detector itself.
  •  
2.
  • Abat, E., et al. (författare)
  • Study of the response of the ATLAS central calorimeter to pions of energies from 3 to 9 GeV
  • 2009
  • Ingår i: Nuclear Instruments & Methods in Physics Research. Section A: Accelerators, Spectrometers, Detectors, and Associated Equipment. - : Elsevier BV. - 0167-5087 .- 0168-9002 .- 1872-9576. ; 607:2, s. 372-386
  • Tidskriftsartikel (refereegranskat)abstract
    • A fully instrumented slice of the ATLAS central detector was exposed to test beams from the SPS (Super Proton Synchrotron) at CERN in 2004. in this paper, the response of the central calorimeters to pions with energies in the range between 3 and 9 GeV is presented. The linearity and the resolution of the combined calorimetry (electromagnetic and hadronic calorimeters) was measured and compared to the prediction of a detector simulation program using the toolkit Geant 4. (C) 2009 Elsevier B.V. All rights reserved.
  •  
3.
  • Aad, G., et al. (författare)
  • The ATLAS Experiment at the CERN Large Hadron Collider
  • 2008
  • Ingår i: Journal of Instrumentation. - 1748-0221. ; 3:S08003
  • Forskningsöversikt (refereegranskat)abstract
    • The ATLAS detector as installed in its experimental cavern at point 1 at CERN is described in this paper. A brief overview of the expected performance of the detector when the Large Hadron Collider begins operation is also presented.
  •  
4.
  • Sharker, Bishal, et al. (författare)
  • Characterization of lignin and hemicellulose degrading bacteria isolated from cow rumen and forest soil : Unveiling a novel enzymatic model for rice straw deconstruction
  • 2023
  • Ingår i: Science of the Total Environment. - : Elsevier BV. - 0048-9697 .- 1879-1026. ; 904
  • Tidskriftsartikel (refereegranskat)abstract
    • Application of greener pretreatment technology using robust ligninolytic bacteria for short duration to deconstruct rice straw and enhance bioethanol production is currently lacking. The objective of this study is to characterize three bacterial strains isolated from the milieux of cow rumen and forest soil and explore their capabilities of breaking down lignocellulose – an essential process in bioethanol production. Using biochemical and genomic analyses these strains were identified as Bacillus sp. HSTU-bmb18, Bacillus sp. HSTU-bmb19, and Citrobacter sp. HSTU-bmb20. Genomic analysis of the strains unveiled validated model hemicellulases, multicopper oxidases, and pectate lyases. These enzymes exhibited interactions with distinct lignocellulose substrates, further affirmed by their stability in molecular dynamic simulations. A comprehensive expression of ligninolytic pathways, including β-ketoadipate, phenyl acetate, and benzoate, was observed within the HSTU-bmb20 genome. The strains secreted approximately 75–82 U/mL of cellulase, xylase, pectinase, and lignin peroxidase. FT-IR analysis of the bacterial treated rice straw fibers revealed that the intensity of lignin-related peaks decreased, while cellulose-related peaks sharpened. The values of crystallinity index for the untreated control and the treated rice straw with either HSTU-bmb18, or HSTU-bmb19, or HSTU-bmb20 were recorded to be 34.48, 28.49, 29.36, 31.75, respectively, which are much higher than that of 13.53 noted for those treated with the bacterial consortium. The ratio of fermentable cellulose in rice straw increased by 1.25-, 1.79-, 1.93- and 2.17-fold following treatments with HSTU-bmb18, HSTU-bmb20, HSTU-bmb19, and a mixed consortium of these three strains, respectively. These aggregative results suggested a novel model for rice straw deconstruction utilizing hydrolytic enzymes of the consortium, revealing superior efficacy compared to individual strains, and advancing cost-effective, affordable, and sustainable green technology.
  •  
5.
  • Moulavi, M. Amir, et al. (författare)
  • State-Space Feedback Control for Elastic Distributed Storage in a Cloud Environment
  • 2012
  • Ingår i: ICAS 2012. - St. Maarten, Netherlands Antilles. - 9781612081878 ; , s. 589-596
  • Konferensbidrag (refereegranskat)abstract
    • Elasticity in Cloud computing is an ability of asystem to scale up and down (request and release resources) in response to changes in its environment and workload. Elasticity can be achieved manually or automatically. Efforts arebeing made to automate elasticity in order to improve system performance under dynamic workloads. In this paper, we reportour experience in designing an elasticity controller for a key-value storage service deployed in a Cloud environment. To design our controller, we have adopted a control theoretic approach. Automation of elasticity is achieved by providing a feedback controller that automatically increases and decreases the number of nodes in order to meet service level objectives under high load and to reduce costs under low load. Every step in the building of a controller for elastic storage, includingsystem identification and controller design, is discussed. We have evaluated our approach by using simulation. We have developed a simulation framework EStoreSim in order to simulate anelastic key-value store in a Cloud environment and be able to experiment with different controllers. We have examined the implemented controller against specific service level objectives and evaluated the controller behavior in different scenarios. Our simulation experiments have shown the feasibility of our approach to automate elasticity of storage services using state-space feedback control.
  •  
Skapa referenser, mejla, bekava och länka
  • Resultat 1-5 av 5

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy