| 1. |
- Kopp, C., et al.
(författare)
-
Very compact FTTH Diplexer design using advanced wafer level fabrication methods
- 2008
-
Ingår i: MICRO-OPTICS 2008. - Strasbourg : SPIE.
-
Konferensbidrag (refereegranskat)abstract
- FTTH networks require implementing a diplexer at each user termination. According to most of the standards, this diplexer detects a download signal beam at 1.49ÎŒm and emits an upload signal beam at 1.31ÎŒm on the same single mode fibre. Both signals exhibit datarate speed below 2.5Gbps. Today, most of the diplexers are obtained by actively aligning a set of individual optoelectronic components and micro-optics. However, new manufacturing solutions satisfying very low cost and mass production capability requirements of this market would help to speed the massive spreading of this technology. In this paper, we present an original packaging design to manufacture Diplexer Optical Sub-Assembly for FTTH application. A dual photodiode is stacked over a VCSEL and detects both the download signal beam at 1.49ÎŒm passing through the laser and one part of the upload signal beam at 1.31ÎŒm for monitoring. To satisfy this approach, an innovative VCSEL has been designed to have a very high transmission at 1.49ÎŒm. All these components are mounted on a very small circuit board on glass including also integrated circuits such as transimpedance amplifier. So, the device combines advanced optoelectronic components and highly integrated Multi-Chip-Module on glass approach using collective wafer-level assembling technologies. For the single mode fibre optical coupling, active and passive alignment solutions are considered.
|
|
| 2. |
- Gustafsson, Oscar, et al.
(författare)
-
Long-wavelength infrared quantum-dot based interband photodetectors
- 2011
-
Ingår i: Infrared physics & technology. - : Elsevier BV. - 1350-4495 .- 1879-0275. ; 54:3, s. 287-291
-
Tidskriftsartikel (refereegranskat)abstract
- We report on the design and fabrication of (Al)GaAs(Sb)/InAs tensile strained quantum-dot (QD) based detector material for thermal infrared imaging applications in the long-wavelength infrared (LWIR) regime. The detection is based on transitions between confined dot states and continuum states in a type-II band lineup, and we therefore refer to it as a dot-to-bulk (D2B) infrared photodetector with expected benefits including long carrier lifetime due to the type-II band alignment, suppressed Shockley-Read-Hall generation-recombination due to the relatively large-bandgap matrix material, inhibited Auger recombination processes due to the tensile strain and epitaxial simplicity. Metal-organic vapor-phase epitaxy was used to grow multiple (Al)GaAs(Sb) QD layers on InAs substrates at different QD nominal thicknesses, compositions, doping conditions and multilayer periods, and the material was characterized using atomic force and transmission electron microscopy, and Fourier-transform infrared absorption spectroscopy. Dot densities up to 1 x 10(11) cm(-2), 1 x 10(12) cm(-2) and 3 x 10(10) cm(-2) were measured for GaAs, AlGaAs and GaAsSb QDs, respectively. Strong absorption in GaAs, AlGaAs and GaAsSb multilayer QD samples was observed in the wavelength range 6-12 mu m. From the wavelength shift in the spectral absorption for samples with varying QD thickness and composition it is believed that the absorption is due to an intra- valance band transition. From this it is possible to estimate the type-II inter-band transition wavelength, thereby suggesting that (Al)GaAs(Sb) QD/InAs heterostructures are suitable candidates for LWIR detection and imaging.
|
|
| 3. |
|
|
| 4. |
- Hoglund, L, et al.
(författare)
-
Selective optical doping to predict the performance and reveal the origin of photocurrent peaks in quantum dots-in-a-well infrared photodetectors
- 2009
-
Ingår i: INFRARED PHYSICS and TECHNOLOGY. - Exeter : Elsevier BV. - 1350-4495 .- 1879-0275. ; 52:6, s. 272-275
-
Tidskriftsartikel (refereegranskat)abstract
- Resonant optical pumping across the band gap was used as artificial doping in InAs/In0.15Ga0.85As/GaAs quantum dots-in-a-well infrared photodetectors. Through efficient filling of the quantum dot energy levels by simultaneous optical pumping into the ground states and the excited states of the quantum dots, the response was increased by a factor of 10. Low temperature photocurrent peaks observed at 120 and 148 meV were identified as intersubband transitions emanating from the quantum dot ground state and the quantum dot excited state, respectively by a selective increase of the electron population in the different quantum dot energy levels.
|
|
| 5. |
- Höglund, Linda, 1974-, et al.
(författare)
-
Bias and temperature dependence of the escape processes in quantum dots-in-a-well infrared photodetectors
- 2008
-
Ingår i: Applied Physics Letters. - New York : American Institute of Physics (AIP). - 0003-6951 .- 1077-3118. ; 93:10, s. 103501-
-
Tidskriftsartikel (refereegranskat)abstract
- The performance of quantum dots-in-a-well infrared photodetectors (DWELL IPs) has been studied by means of interband and intersubband photocurrent measurements as well as dark current measurements. Using interband photocurrent measurements, substantial escape of electrons from lower lying states in the DWELL structure at large biases was revealed. Furthermore, a significant variation in the escape probability from energy states in the DWELL structure with applied bias was observed. These facts can explain the strong temperature and bias dependence of both photocurrent and dark currents in DWELL IPs.
|
|
| 6. |
- Höglund, Linda, 1974-, et al.
(författare)
-
Bias mediated tuning of the detection wavelength in asymmetrical quantum dots-in-a-well infrared photodetectors
- 2008
-
Ingår i: Applied Physics Letters. - New York : AIP Publishing. - 0003-6951 .- 1077-3118. ; 93:20
-
Tidskriftsartikel (refereegranskat)abstract
- Bias-mediated tuning of the detection wavelength within the infrared wavelength region is demonstrated for quantum dots-in-a-well and dots-on-a-well infrared photodetectors. By positioning the InAs quantum dot layer asymmetrically in an 8 nm wide In0.15Ga0.85As/GaAs quantum well, a shift in the peak detection wavelength from 8.4 to 10.3 mu m was observed when reversing the polarity of the applied bias. For a dots-on-a-well structure, the peak detection wavelength was tuned from 5.4 to 8 mu m with small changes in the applied bias. These tuning properties could be essential for applications such as modulators and dual-color infrared detection.
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
|
|
