| 1. |
- Dini, Hoda, 1984-, et al.
(författare)
-
Optimization and validation of a dislocation density based constitutive model for as-cast Mg-9%Al-1%Zn
- 2018
-
Ingår i: Materials Science & Engineering. - : Elsevier. - 0921-5093 .- 1873-4936. ; 710, s. 17-26
-
Tidskriftsartikel (refereegranskat)abstract
- A dislocation density-based constitutive model, including effects of microstructure scale and temperature, was calibrated to predict flow stress of an as-cast AZ91D (Mg-9%Al-1%Zn) alloy. Tensile stress-strain data, for strain rates from 10-4 up to 10-1 s-1 and temperatures from room temperature up to 190 °C were used for model calibration. The used model accounts for the interaction of various microstructure features with dislocations and thereby on the plastic properties. It was shown that the Secondary Dendrite Arm Spacing (SDAS) size was appropriate as an initial characteristic microstructural scale input to the model. However, as strain increased the influence of subcells size and total dislocation density dominated the flow stress. The calibrated temperature-dependent parameters were validated through a correlation between microstructure and the physics of the deforming alloy. The model was validated by comparison with dislocation density obtained by using Electron Backscattered Diffraction (EBSD) technique.
|
|
| 2. |
- Zamani, Mohammadreza, et al.
(författare)
-
A dislocation density based constitutive model for as-cast Al-Si alloys : Effect of temperature and microstructure
- 2017
-
Ingår i: International Journal of Mechanical Sciences. - : Elsevier. - 0020-7403 .- 1879-2162. ; 121, s. 164-170
-
Tidskriftsartikel (refereegranskat)abstract
- The flow stress of an as-cast Al-Si based alloy was modeled using a dislocation density based model. The developed dislocation density-based constitutive model describes the flow curve of the alloy with various microstructures at quite wide temperature range. Experimental data in the form of stress-strain curves for different strain rates ranging from 10−4 to 10−1 s−1 and temperatures ranging from ambient temperature up to 400 °C were used for model calibration. In order to model precisely the hardening and recovery process at elevated temperature, the interaction between vacancies and dissolved Si was included. The calibrated temperature dependent parameters for different microstructure were correlated to the metallurgical event of the material and validated. For the first time, a dislocation density based model was successfully developed for Al-Si cast alloys. The findings of this work expanded the knowledge on short strain tensile deformation behaviour of these type of alloys at different temperature, which is a critical element for conducting a reliable microstructural FE-simulation.
|
|
