| 1. |
- Andersson, Viktor, 1983, et al.
(författare)
-
Efficient Utilization of Industrial Excess Heat for Post-combustion CO2 Capture: An Oil Refinery Sector Case Study
- 2014
-
Ingår i: Energy Procedia. - : Elsevier BV. - 1876-6102. ; 63, s. 6548-6556
-
Konferensbidrag (refereegranskat)abstract
- A key issue in post-combustion carbon capture is the choice of absorbent. In this paper two different absorbents, monoethanolamine (MEA) and ammonia (NH3), have been modeled in Aspen Plus at different temperatures for possible implementation at an oil refinery. The focus of investigation is the possibilities of heat integration between the oil refinery and the carbon capture process and how these possibilities could change in a future situation where energy efficiency measures have been implemented.The results show that if only using excess heat from the refinery for heating of the carbon capture process, the MEA process can capture more CO2 than the NH3 process. It is shown that the configuration requiring least supplementary heat when applying carbon capture to all flue gases is MEA at 120 °C.The temperature profile of the excess heat from the refinery suits the MEA and NH3 processes differently. The NH3 process would benefit from a flat section above 100 °C to better integrate the heat needed to reduce slip, while the MEA process only needs heat at stripper temperature.
|
|
| 2. |
- Andersson, Viktor, 1983, et al.
(författare)
-
Industrial excess heat driven post-combustion CCS: The effect of stripper temperature level
- 2014
-
Ingår i: International Journal of Greenhouse Gas Control. - : Elsevier BV. - 1750-5836. ; 21, s. 1-10
-
Tidskriftsartikel (refereegranskat)abstract
- The implementation of post-combustion CCS provides an opportunity for the oil refining sector to drastically decrease its CO2 emissions. Previous studies have shown that the largest cost is the heat supply to the stripper reboiler. When performing CCS at an oil refinery it could therefore prove economically beneficial to utilize the excess heat from refinery processes to meet this demand for heat. The present study investigates the heat demand in a stripper reboiler at different temperature levels from 120 degrees C down to 90 degrees C. At temperatures lower than 120 degrees C the heat demand increases, but the availability of excess heat also increases. A case study that connects heat demand results with data from an oil refinery shows that if only excess heat is utilized as a heat source, the amount of CO2 that can be separated is largest when the temperature in the stripper reboiler is 90 degrees C. If, however, CCS with a capture rate of 85% were applied to the four largest chimneys at the refinery, the external heat demand would be the lowest for the standard temperature of 120 degrees C. (C) 2013 Elsevier Ltd. All rights reserved.
|
|
| 3. |
- Andersson, Viktor, 1983, et al.
(författare)
-
Techno-economic analysis of excess heat driven post-combustion CCS at an oil refinery
- 2016
-
Ingår i: International Journal of Greenhouse Gas Control. - : Elsevier BV. - 1750-5836. ; 45, s. 130-138
-
Tidskriftsartikel (refereegranskat)abstract
- Carbon capture and storage may, as a bridging technology, rapidly decrease CO2 emissions in the industrial sector. In this paper, a techno-economic study of a future MEA carbon capture plant implemented at a case study oil refinery is presented. Costs are calculated for six setups of carbon capture at the refinery. Excess heat from the refinery processes is used in the capture plant for regeneration of the absorption fluid, and the stripper reboiler temperature is varied to increase the extractable of excess heat. Supplementary heating is carried out with a heat pump. The number of chimneys to be included in the capture process is also varied, resulting in different CO2 concentrations and amounts of CO2 at the inlet of the capture plant. Results show that the specific cost for carbon capture increases as the amount of captured carbon increases due to the need for heat pumps. The costs are in the range of 41-57(sic)/t for the low-temperature cases (T-Reb =90 degrees C) and 39-44(sic)/t for the high-temperature cases (T-Reb = 120 degrees C).
|
|
| 4. |
- Andersson, Viktor, 1983, et al.
(författare)
-
Temperature Dependence of Heat Integration Possibilities of an MEA Scrubber Plant at a Refinery
- 2013
-
Ingår i: Energy Procedia. - : Elsevier BV. - 1876-6102. ; 37, s. 7205-7213
-
Konferensbidrag (refereegranskat)abstract
- A study has been conducted in order to investigate how the specific heat requirements in the stripper reboiler of a MEA capture plant changes with changing temperature. It was found that the increase in heat demand is dramatic when lowering the temperature, approximately 40% when the temperature changes from 120 to 90° C. Heat integration with a refinery was also studied, and showed that even if the heat demand was larger for the lower temperature the heat integration possibilities were also larger for the base case.
|
|
