| 1. |
- Jiang, Zheshun, et al.
(författare)
-
Hexavalent chromium still a concern in Sweden : Evidence from a cross-sectional study within the SafeChrom project
- 2024
-
Ingår i: International journal of hygiene and environmental health. - : Elsevier. - 1438-4639 .- 1618-131X. ; 256
-
Tidskriftsartikel (refereegranskat)abstract
- ObjectivesHexavalent chromium (Cr(VI)) is classified as a human carcinogen. Occupational Cr(VI) exposure can occur during different work processes, but the current exposure to Cr(VI) at Swedish workplaces is unknown.MethodsThis cross-sectional study (SafeChrom) recruited non-smoking men and women from 14 companies with potential Cr(VI) exposure (n = 113) and controls from 6 companies without Cr(VI) exposure (n = 72). Inhalable Cr(VI) was measured by personal air sampling (outside of respiratory protection) in exposed workers. Total Cr was measured in urine (pre- and post-shift, density-adjusted) and red blood cells (RBC) (reflecting Cr(VI)) in exposed workers and controls. The Bayesian tool Expostats was used to assess risk and evaluate occupational exposure limit (OEL) compliance.ResultsThe exposed workers performed processing of metal products, steel production, welding, plating, and various chemical processes. The geometric mean concentration of inhalable Cr(VI) in exposed workers was 0.15 μg/m3 (95% confidence interval: 0.11–0.21). Eight of the 113 exposed workers (7%) exceeded the Swedish OEL of 5 μg/m3, and the Bayesian analysis estimated the share of OEL exceedances up to 19.6% for stainless steel welders. Median post-shift urinary (0.60 μg/L, 5th-95th percentile 0.10–3.20) and RBC concentrations (0.73 μg/L, 0.51–2.33) of Cr were significantly higher in the exposed group compared with the controls (urinary 0.10 μg/L, 0.06–0.56 and RBC 0.53 μg/L, 0.42–0.72). Inhalable Cr(VI) correlated with urinary Cr (rS = 0.64) and RBC-Cr (rS = 0.53). Workers within steel production showed the highest concentrations of inhalable, urinary and RBC Cr. Workers with inferred non-acceptable local exhaustion ventilation showed significantly higher inhalable Cr(VI), urinary and RBC Cr concentrations compared with those with inferred acceptable ventilation. Furthermore, workers with inferred correct use of respiratory protection were exposed to significantly higher concentrations of Cr(VI) in air and had higher levels of Cr in urine and RBC than those assessed with incorrect or no use. Based on the Swedish job-exposure-matrix, approximately 17 900 workers were estimated to be occupationally exposed to Cr(VI) today.ConclusionsOur study demonstrates that some workers in Sweden are exposed to high levels of the non-threshold carcinogen Cr(VI). Employers and workers seem aware of Cr(VI) exposure, but more efficient exposure control strategies are required. National strategies aligned with the European strategies are needed in order to eliminate this cause of occupational cancer.
|
|
| 2. |
- Dierschke, Katrin, et al.
(författare)
-
Acute respiratory effects and biomarkers of inflammation due to welding-derived nanoparticle aggregates
- 2017
-
Ingår i: International Archives of Occupational and Environmental Health. - : Springer Science and Business Media LLC. - 0340-0131 .- 1432-1246. ; 90:5, s. 451-463
-
Tidskriftsartikel (refereegranskat)abstract
- Welders are exposed to airborne particles from the welding environment and often develop symptoms work-related from the airways. A large fraction of the particles from welding are in the nano-size range. In this study we investigate if the welders' airways are affected by exposure to particles derived from gas metal arc welding in mild steel in levels corresponding to a normal welding day. In an exposure chamber, 11 welders with and 10 welders without work-related symptoms from the lower airways and 11 non-welders without symptoms, were exposed to welding fumes (1 mg/m(3)) and to filtered air, respectively, in a double-blind manner. Symptoms from eyes and upper and lower airways and lung function were registered. Blood and nasal lavage (NL) were sampled before, immediately after and the morning after exposure for analysis of markers of oxidative stress. Exhaled breath condensate (EBC) for analysis of leukotriene B4 (LT-B4) was sampled before, during and immediately after exposure. No adverse effects of welding exposure were found regarding symptoms and lung function. However, EBC LT-B4 decreased significantly in all participants after welding exposure compared to filtered air. NL IL-6 increased immediately after exposure in the two non-symptomatic groups and blood neutrophils tended to increase in the symptomatic welder group. The morning after, neutrophils and serum IL-8 had decreased in all three groups after welding exposure. Remarkably, the symptomatic welder group had a tenfold higher level of EBC LT-B4 compared to the two groups without symptoms. Despite no clinical adverse effects at welding, changes in inflammatory markers may indicate subclinical effects even at exposure below the present Swedish threshold limit (8 h TWA respirable dust).
|
|
| 3. |
- Gren, Louise, et al.
(författare)
-
Lung function and self-rated symptoms in healthy volunteers after exposure to hydrotreated vegetable oil (HVO) exhaust with and without particles
- 2022
-
Ingår i: Particle and Fibre Toxicology. - : Springer Science and Business Media LLC. - 1743-8977. ; 19:1
-
Tidskriftsartikel (refereegranskat)abstract
- Background: Diesel engine exhaust causes adverse health effects. Meanwhile, the impact of renewable diesel exhaust, such as hydrotreated vegetable oil (HVO), on human health is less known. Nineteen healthy volunteers were exposed to HVO exhaust for 3 h in a chamber with a double-blind, randomized setup. Exposure scenarios comprised of HVO exhaust from two modern non-road vehicles with 1) no aftertreatment system ('HVOPM+NOx' PM1: 93 mu g-m(-3), EC: 54 mu g-m(-3), NO: 3.4 ppm, -NO2: 0.6 ppm), 2) an aftertreatment system containing a diesel oxidation catalyst and a diesel particulate filter ('HVONOx' PM1: similar to 1 mu g-m(-3), NO: 2.0 ppm, -NO2: 0.7 ppm) and 3) filtered air (FA) as control. The exposure concentrations were in line with current EU occupational exposure limits (OELs) of NO, -NO2, formaldehyde, polycyclic aromatic hydrocarbons (PAHs), and the future OEL (2023) of elemental carbon (EC). The effect on nasal patency, pulmonary function, and self-rated symptoms were assessed. Calculated predicted lung deposition of HVO exhaust particles was compared to data from an earlier diesel exhaust study. Results: The average total respiratory tract deposition of PM1 during -HVO(PM+ NO)x was 27 mu g-h(-1). The estimated deposition fraction of HVO PM1 was 40-50% higher compared to diesel exhaust PM1 from an older vehicle (earlier study), due to smaller particle sizes of the -HVOPM+ NOx exhaust. Compared to FA, exposure to -HVOPM+ NOx and -HVONOx caused higher incidence of self-reported symptoms (78%, 63%, respectively, vs. 28% for FA, p < 0.03). Especially, exposure to -HVOPM+ NOx showed 40-50% higher eye and throat irritation symptoms. Compared to FA, a decrement in nasal patency was found for the -HVONOx exposures (- 18.1, 95% CI: - 27.3 to - 8.8 L-min(-1), p < 0.001), and for the -HVOPM+ NOx (- 7.4 (- 15.6 to 0.8) L -min(-1), p = 0.08). Overall, no clinically significant change was indicated in the pulmonary function tests (spirometry, peak expiratory flow, forced oscillation technique). Conclusion: Short-term exposure to HVO exhaust concentrations corresponding to EU OELs for one workday did not cause adverse pulmonary function changes in healthy subjects. However, an increase in self-rated mild irritation symptoms, and mild decrease in nasal patency after both HVO exposures, may indicate irritative effects from exposure to HVO exhaust from modern non-road vehicles, with and without aftertreatment systems.
|
|
| 4. |
- Lovén, Karin, et al.
(författare)
-
Effects of cleaning spray use on eyes, airways, and ergonomic load
- 2023
-
Ingår i: BMC Public Health. - : Springer Science and Business Media LLC. - 1471-2458. ; 23:1
-
Tidskriftsartikel (refereegranskat)abstract
- BackgroundCleaning workers are exposed to chemicals and high physical workload, commonly resulting in airway problems and pain. In this study the response in the upper airways and the physical workload following airborne and ergonomic exposure of cleaning spray was investigated.MethodsA survey was answered by professional cleaning workers to investigate their use of cleaning sprays and the perceived effects on eyes, airways and musculoskeletal pain. A human chamber exposure study was then conducted with 11 professional cleaning workers and 8 non-professional cleaning workers to investigate the airborne exposure, acute effects on eyes and airways, and physical load during cleaning with sprays, foam application and microfiber cloths premoistened with water. All cleaning products used were bleach, chlorine, and ammonia free. The medical assessment included eye and airway parameters, inflammatory markers in blood and nasal lavage, as well as technical recordings of the physical workload.ResultsA high frequency of spray use (77%) was found among the 225 professional cleaning workers that answered the survey. Based on the survey, there was an eight times higher risk (p < 0.001) of self-experienced symptoms (including symptoms in the nose, eyes and throat, coughing or difficulty breathing) when they used sprays compared to when they cleaned with other methods. During the chamber study, when switching from spray to foam, the airborne particle and volatile organic compound (VOC) concentrations showed a decrease by 7 and 2.5 times, respectively. For the whole group, the peak nasal inspiratory flow decreased (-10.9 L/min, p = 0.01) during spray use compared to using only water-premoistened microfiber cloths. These effects were lower during foam use (-4.7 L/min, p = 0.19). The technical recordings showed a high physical workload regardless of cleaning with spray or with water.ConclusionSwitching from a spraying to a foaming nozzle decreases the exposure of both airborne particles and VOCs, and thereby reduces eye and airway effects, and does not increase the ergonomic load. If the use of cleaning products tested in this study, i.e. bleach, chlorine, and ammonia free, cannot be avoided, foam application is preferable to spray application to improve the occupational environment.
|
|
| 5. |
- Taj, Tahir, et al.
(författare)
-
Effect of welding fumes on the cardiovascular system: a six-year longitudinal study
- 2021
-
Ingår i: Scandinavian Journal of Work Environment & Health. - : Scandinavian Journal of Work, Environment and Health. - 0355-3140 .- 1795-990X. ; 47:1, s. 52-61
-
Tidskriftsartikel (refereegranskat)abstract
- Objective This study investigated whether low-to-moderate exposure to welding fumes is associated with adverse effects on the cardiovascular system. Methods To test this, we performed a longitudinal analysis of 78 mild steel welders and 96 controls; these subjects were examined twice, six years apart (ie, timepoints 1 and 2). All subjects (male and non-smoking at recruitment) completed questionnaires describing their health, work history, and lifestyle. We measured their blood pressure, endothelial function (by EndoPAT), and risk markers for cardiovascular disease [low-density lio-protein (LDL), homocysteine, C-reactive protein]. Exposure to welding fumes was assessed from the responses to questionnaires and measurements of respirable dust in their breathing zones adjusted for use of respiratory protection equipment. Linear mixed-effect regression models were used for the longitudinal analysis. Results Median respirable dust concentrations, adjusted for respirable protection, of the welders were 0.7 (5-95 percentile range 0.2-4.2) and 0.5 (0.1-1.9) mg/m 3 at timepoints 1 and 2, respectively. Over the six-year period, welders showed a statistically significant increase in systolic [5.11 mm Hg, 95% confidence interval (CI) 1.92-8.31] and diastolic (3.12 mm Hg, 95% CI 0.74-5.5) blood pressure compared with controls (multi-variable adjusted mixed effect models). Diastolic blood pressure increased non-significantly by 0.22 mm Hg (95% CI-0.02-0.45) with every additional year of welding work. No consistent significant associations were found between exposure and endothelial function, LDL, homocysteine, or C-reactive protein. Conclusion Exposure to welding fumes at low-to-moderate levels is associated with increased blood pressure, suggesting that reducing the occupational exposure limit (2.5 mg/m(3) for inorganic respirable dust in Sweden) is needed to protect cardiovascular health of workers.
|
|
