| 1. |
- Fenstermacher, M.E., et al.
(författare)
-
DIII-D research advancing the physics basis for optimizing the tokamak approach to fusion energy
- 2022
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 62:4
-
Tidskriftsartikel (refereegranskat)abstract
- DIII-D physics research addresses critical challenges for the operation of ITER and the next generation of fusion energy devices. This is done through a focus on innovations to provide solutions for high performance long pulse operation, coupled with fundamental plasma physics understanding and model validation, to drive scenario development by integrating high performance core and boundary plasmas. Substantial increases in off-axis current drive efficiency from an innovative top launch system for EC power, and in pressure broadening for Alfven eigenmode control from a co-/counter-I p steerable off-axis neutral beam, all improve the prospects for optimization of future long pulse/steady state high performance tokamak operation. Fundamental studies into the modes that drive the evolution of the pedestal pressure profile and electron vs ion heat flux validate predictive models of pedestal recovery after ELMs. Understanding the physics mechanisms of ELM control and density pumpout by 3D magnetic perturbation fields leads to confident predictions for ITER and future devices. Validated modeling of high-Z shattered pellet injection for disruption mitigation, runaway electron dissipation, and techniques for disruption prediction and avoidance including machine learning, give confidence in handling disruptivity for future devices. For the non-nuclear phase of ITER, two actuators are identified to lower the L-H threshold power in hydrogen plasmas. With this physics understanding and suite of capabilities, a high poloidal beta optimized-core scenario with an internal transport barrier that projects nearly to Q = 10 in ITER at ∼8 MA was coupled to a detached divertor, and a near super H-mode optimized-pedestal scenario with co-I p beam injection was coupled to a radiative divertor. The hybrid core scenario was achieved directly, without the need for anomalous current diffusion, using off-axis current drive actuators. Also, a controller to assess proximity to stability limits and regulate β N in the ITER baseline scenario, based on plasma response to probing 3D fields, was demonstrated. Finally, innovative tokamak operation using a negative triangularity shape showed many attractive features for future pilot plant operation.
|
|
| 2. |
- Aartsen, M. G., et al.
(författare)
-
Very high-energy gamma-ray follow-up program using neutrino triggers from IceCube
- 2016
-
Ingår i: Journal of Instrumentation. - 1748-0221. ; 11
-
Tidskriftsartikel (refereegranskat)abstract
- We describe and report the status of a neutrino-triggered program in IceCube that generates real-time alerts for gamma-ray follow-up observations by atmospheric-Cherenkov telescopes (MAGIC and VERITAS). While IceCube is capable of monitoring the whole sky continuously, high-energy gamma-ray telescopes have restricted fields of view and in general are unlikely to be observing a potential neutrino-flaring source at the time such neutrinos are recorded. The use of neutrino-triggered alerts thus aims at increasing the availability of simultaneous multi-messenger data during potential neutrino flaring activity, which can increase the discovery potential and constrain the phenomenological interpretation of the high-energy emission of selected source classes (e. g. blazars). The requirements of a fast and stable online analysis of potential neutrino signals and its operation are presented, along with first results of the program operating between 14 March 2012 and 31 December 2015.
|
|
| 3. |
- Iyer, Nirmal, et al.
(författare)
-
The design and performance of the XL-Calibur anticoincidence shield
- 2023
-
Ingår i: Nuclear Instruments and Methods in Physics Research Section A. - : Elsevier BV. - 0168-9002 .- 1872-9576. ; 1048
-
Tidskriftsartikel (refereegranskat)abstract
- The XL-Calibur balloon-borne hard X-ray polarimetry mission comprises a Compton-scattering polarimeter placed at the focal point of an X-ray mirror. The polarimeter is housed within a BGO anticoincidence shield, which is needed to mitigate the considerable background radiation present at the observation altitude of -40 km. This paper details the design, construction and testing of the anticoincidence shield, as well as the performance measured during the week-long maiden flight from Esrange Space Centre to the Canadian Northwest Territories in July 2022. The in-flight performance of the shield followed design expectations, with a veto threshold <100 keV and a measured background rate of -0.5 Hz (20-40 keV). This is compatible with the scientific goals of the mission, where %-level minimum detectable polarisation is sought for a Hz-level source rate.
|
|
| 4. |
- Bose, A., et al.
(författare)
-
Hybrid renewable power systems for generation of own power by small and medium-scale enterprises
- 2018
-
Ingår i: E3S Web of Conferences. - : EDP Sciences. - 2267-1242.
-
Konferensbidrag (refereegranskat)abstract
- Decentralized power generation, from renewables, is an attractive option for the future energy transition. Through a case study, the techno-economic feasibility to produce own power from distributed renewable to de-carbonize the operations of the Small and Medium Scale Enterprises (SMEs) was critically analysed. The case study was performed on one of the leading printing outfits of Sri Lanka. Solar photovoltaic (PV) and biomass gasification systems are the most cost-efficient and easy to operate technologies for grid-connected, small-scale power generation, at present, for the context. Grid integration has been found as a major challenge, in both technical and economic parameters of the project. The low capacity factor of solar PV and complexity of the supply chain for biomass power systems are critical to the respective technologies. A hybrid Solar PV-Biomass gasification power plant would have superior techno-economic performances with lower environmental impact than stand-alone systems. An equal share of the net power capacity between the technologies was obtained as the most suitable combination for the proposed hybrid power plant. A net carbon dioxide reduction of more than eighty percent of the operations of the SMEs is feasible. Socio-political factors also have a high impact on overall viability of such small-scale systems.
|
|
| 5. |
- Cunha, J. M. V., et al.
(författare)
-
Insulator Materials for Interface Passivation of Cu(In,Ga)Se-2 Thin Films
- 2018
-
Ingår i: IEEE Journal of Photovoltaics. - : IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC. - 2156-3381 .- 2156-3403. ; 8:5, s. 1313-1319
-
Tidskriftsartikel (refereegranskat)abstract
- In this work, metal-insulator-semiconductor structures were fabricated in order to study different types of insulators, namely, aluminum oxide (Al2O3), silicon nitride, and silicon oxide (SiOx) to be used as passivation layers in Cu(In,Ga)Se-2 (CIGS) thin-film solar cells. The investigated stacks consisted of SLG/Mo/CIGS/insulator/Al. Raman scattering and photoluminescence measurements were done to verify the insulator deposition influence on the CIGS surface. In order to study the electrical properties of the CIGS-insulator interface, capacitance versus conductance and voltage (C-G-V) measurements were done to estimate the number and polarity of fixed insulator charges (Q(f)). The density of interface defects (D-it) was estimated from capacitance versus conductance and frequency (C-G-f) measurements. This study evidences that the deposition of the insulators at high temperatures (300 degrees C) and the use of a sputtering technique cause surface modification on the CIGS surface. We found that, by varying the SiOx deposition parameters, it is possible to have opposite charges inside the insulator, which would allow its use in different device architectures. The material with lower Dit values was Al2O3 when deposited by sputtering.
|
|
| 6. |
- Edoff, Marika, 1965-, et al.
(författare)
-
Ultrathin CIGS Solar Cells with Passivated and Highly Reflective Back Contacts – : Results from the ARCIGS-M Consortium
- 2019
-
Ingår i: Proceedings of 36th European Photovoltaic Solar Energy Conference and Exhibition. ; , s. 597-600
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)abstract
- In this work, we report results from the EU-funded project ARCIGS-M. The project started in 2016 and aims to reduce the use of indium and gallium by enabling the use of very thin Cu(In,Ga)Se2 (CIGS) layers while retaining high efficiency and developing innovative low-cost steel substrates as alternatives to glass. In the project, reflective layers containing TCO´s and silver have successfully been used to enhance the reflective properties of the rear contact. In addition, passivation layers based on alumina (Al2O3) deposited by atomic layer deposition (ALD) have been found to yield good passivation of the rear contact. Since the alumina layers are dielectric, perforation of these layers is necessary to provide adequate contacting. The design of the perforation patterns has been investigated by a combination of modeling and experimental verification by electron beam lithography. In parallel a nano-imprint lithography (NIL) process is further developed for scale-up and application in prototype modules. Advanced optoelectrical characterization supported by modeling is used to fill in the missing gaps in optical and electrical properties, regarding CIGS, interfaces and back contact materials.
|
|
| 7. |
- Vijayakumar, P., et al.
(författare)
-
Hierarchical key management scheme for securing mobile agents with optimal computation time
- 2012
-
Ingår i: International Conference on Modelling Optimization and Computing. - : Elsevier. ; , s. 1432-1443
-
Konferensbidrag (refereegranskat)abstract
- The Mobile agents are well suited for accessing contents of distributed web based applications including internet business. Such kinds of access must be secure enough enabling only authorized mobile agents to retrieve the contents from the distributed servers. This kind of security is provided by several algorithms including RSA based digital signature and elliptic curve digital signature cryptography. The main differences among the algorithms of the past literatures lie in the computational time of encryption and decryption of the keys used for encrypting and decrypting the content. In this paper we propose a modified hierarchical date constrained key management scheme which potentially reduces the overall computation time needed for key derivation and key signature check operations. Different algorithms are compared with our proposed mechanism and the experimental results show that the proposed method reduces the overall key derivation and key signature check computational time.
|
|
