| 1. |
- Bentham, James, et al.
(författare)
-
A century of trends in adult human height
- 2016
-
Ingår i: eLIFE. - : eLife Sciences Publications Ltd. - 2050-084X. ; 5
-
Tidskriftsartikel (refereegranskat)abstract
- Being taller is associated with enhanced longevity, and higher education and earnings. We reanalysed 1472 population-based studies, with measurement of height on more than 18.6 million participants to estimate mean height for people born between 1896 and 1996 in 200 countries. The largest gain in adult height over the past century has occurred in South Korean women and Iranian men, who became 20.2 cm (95% credible interval 17.5–22.7) and 16.5 cm (13.3– 19.7) taller, respectively. In contrast, there was little change in adult height in some sub-Saharan African countries and in South Asia over the century of analysis. The tallest people over these 100 years are men born in the Netherlands in the last quarter of 20th century, whose average heights surpassed 182.5 cm, and the shortest were women born in Guatemala in 1896 (140.3 cm; 135.8– 144.8). The height differential between the tallest and shortest populations was 19-20 cm a century ago, and has remained the same for women and increased for men a century later despite substantial changes in the ranking of countries.
|
|
| 2. |
|
|
| 3. |
- Cheng, Li, et al.
(författare)
-
Safety and Protection Measures of Underground Non-Coal Mines with Mining Depth over 800 m: A Case Study in Shandong, China
- 2022
-
Ingår i: Sustainability. - : MDPI. - 2071-1050. ; 14:20
-
Tidskriftsartikel (refereegranskat)abstract
- With the increase in mining depth, the risk of ground pressure disasters in yellow gold mines is becoming more and more serious. This paper carries out a borehole test for the pressure behavior in a non-coal mining area with a mining depth of more than 800 m in the Jiaodong area. The test results show that under a depth of 1050 m, the increase in the vertical principal stress is the same as the increase in the minimum horizontal principal stress, which is about 3 MPa per 100 m. When the depth increases to 1350 m, the vertical principal stress increases by about 3% per 100 m, and the self-weight stress and the maximum horizontal principal stress maintain a steady growth rate of about 3 MPa per 100 m. In addition, based on the test results, the operation of the ground pressure monitoring system in each mine is investigated. The investigation results show that in some of the roadway and stope mines with depths of more than 800 m, varying degrees of rock mass instability have occurred, and a few mines have had sporadic slight rockbursts, accounting for about 5%. There was a stress concentration area in the lower part of the goaf formed in the early stage of mining, and slight rockburst phenomena such as rock mass ejection have occurred; meanwhile, the area stability for normal production and construction was good, and there was no obvious ground pressure. This paper compares the researched mines horizontally as well as to international high-level mines and puts forward some suggestions, including: carrying out ground pressure investigations and improving the level of intelligence, which would provide countermeasures to balance the safety risks of deep mining, reducing all kinds of safety production accidents and providing a solid basis for risk prevention and supervision.
|
|
| 4. |
- Zhou, Bin, et al.
(författare)
-
Worldwide trends in diabetes since 1980: A pooled analysis of 751 population-based studies with 4.4 million participants
- 2016
-
Ingår i: The Lancet. - : Elsevier B.V.. - 0140-6736 .- 1474-547X. ; 387:10027, s. 1513-1530
-
Tidskriftsartikel (refereegranskat)abstract
- Background: One of the global targets for non-communicable diseases is to halt, by 2025, the rise in the age standardised adult prevalence of diabetes at its 2010 levels. We aimed to estimate worldwide trends in diabetes, how likely it is for countries to achieve the global target, and how changes in prevalence, together with population growth and ageing, are aff ecting the number of adults with diabetes.Methods: We pooled data from population-based studies that had collected data on diabetes through measurement of its biomarkers. We used a Bayesian hierarchical model to estimate trends in diabetes prevalence-defined as fasting plasma glucose of 7.0 mmol/L or higher, or history of diagnosis with diabetes, or use of insulin or oral hypoglycaemic drugs-in 200 countries and territories in 21 regions, by sex and from 1980 to 2014. We also calculated the posterior probability of meeting the global diabetes target if post-2000 trends continue.Findings: We used data from 751 studies including 4372000 adults from 146 of the 200 countries we make estimates for. Global age-standardised diabetes prevalence increased from 4.3% (95% credible interval 2.4-17.0) in 1980 to 9.0% (7.2-11.1) in 2014 in men, and from 5.0% (2.9-7.9) to 7.9% (6.4-9.7) in women. The number of adults with diabetes in the world increased from 108 million in 1980 to 422 million in 2014 (28.5% due to the rise in prevalence, 39.7% due to population growth and ageing, and 31.8% due to interaction of these two factors). Age-standardised adult diabetes prevalence in 2014 was lowest in northwestern Europe, and highest in Polynesia and Micronesia, at nearly 25%, followed by Melanesia and the Middle East and north Africa. Between 1980 and 2014 there was little change in age-standardised diabetes prevalence in adult women in continental western Europe, although crude prevalence rose because of ageing of the population. By contrast, age-standardised adult prevalence rose by 15 percentage points in men and women in Polynesia and Micronesia. In 2014, American Samoa had the highest national prevalence of diabetes (>30% in both sexes), with age-standardised adult prevalence also higher than 25% in some other islands in Polynesia and Micronesia. If post-2000 trends continue, the probability of meeting the global target of halting the rise in the prevalence of diabetes by 2025 at the 2010 level worldwide is lower than 1% for men and is 1% for women. Only nine countries for men and 29 countries for women, mostly in western Europe, have a 50% or higher probability of meeting the global target.Interpretation: Since 1980, age-standardised diabetes prevalence in adults has increased, or at best remained unchanged, in every country. Together with population growth and ageing, this rise has led to a near quadrupling of the number of adults with diabetes worldwide. The burden of diabetes, both in terms of prevalence and number of adults aff ected, has increased faster in low-income and middle-income countries than in high-income countries.
|
|
| 5. |
- Chen, Zhixiong, et al.
(författare)
-
Experiment and simulation analysis of tribological and dynamic characteristics in aeroengine hybrid ceramic bearing
- 2023
-
Ingår i: Aircraft Engineering And Aerospace Technology. - : Emerald Group Publishing Limited. - 1748-8842 .- 1758-4213. ; 95:10, s. 1694-1705
-
Tidskriftsartikel (refereegranskat)abstract
- PurposeThis paper aims to research the tribological and dynamic characteristics of aeroengine hybrid ceramic bearings through wear experiments and simulation analysis.Design/methodology/approachFirst, the authors carried out wear experiments on Si3N4–GCr15 and GCr15–GCr15 friction pairs through the ball-disc wear test rig to explore the tribological properties of their materials. Second, using ANSYS/LS-DYNA simulation software, the dynamic simulation analysis of hybrid bearings was carried out under certain working conditions, and the dynamic contact stress of all-steel bearings of the same size was simulated and compared. Finally, the change of the maximum contact stress of the main bearing under the change of load and rotation speed was studied.FindingsThe results show that the Si3N4–GCr15 pair has better tribological performance. At the same time, under the conditions of high speed and heavy load, the simulation analysis shows that the contact stress between the ceramic ball and the raceway of the ring is smaller than the steel ball. That is, hybrid bearings have better transient mechanical properties than all-steel bearings. With the speed increasing to 12,000 r/min, the maximum stress point will shift in the inner and outer rings.Originality/valueIn this study, the tribological and transient mechanical properties of Si3N4 material were comprehensively analyzed through wear experiments and dynamic simulation analysis, which provided a reference for the design of hybrid bearings for next-generation aeroengines.
|
|
| 6. |
- Eichhorn, S. J., et al.
(författare)
-
Current international research into cellulose as a functional nanomaterial for advanced applications
- 2022
-
Ingår i: Journal of Materials Science. - : Springer Nature. - 0022-2461 .- 1573-4803. ; 57:10, s. 5697-5767
-
Tidskriftsartikel (refereegranskat)abstract
- This review paper provides a recent overview of current international research that is being conducted into the functional properties of cellulose as a nanomaterial. A particular emphasis is placed on fundamental and applied research that is being undertaken to generate applications, which are now becoming a real prospect given the developments in the field over the last 20 years. A short introduction covers the context of the work, and definitions of the different forms of cellulose nanomaterials (CNMs) that are most widely studied. We also address the terminology used for CNMs, suggesting a standard way to classify these materials. The reviews are separated out into theme areas, namely healthcare, water purification, biocomposites, and energy. Each section contains a short review of the field within the theme and summarizes recent work being undertaken by the groups represented. Topics that are covered include cellulose nanocrystals for directed growth of tissues, bacterial cellulose in healthcare, nanocellulose for drug delivery, nanocellulose for water purification, nanocellulose for thermoplastic composites, nanocellulose for structurally colored materials, transparent wood biocomposites, supercapacitors and batteries.
|
|
| 7. |
- Farnocchia, Davide, et al.
(författare)
-
International Asteroid Warning Network Timing Campaign: 2019 XS
- 2022
-
Ingår i: The Planetary Science Journal. - : Institute of Physics Publishing (IOPP). - 2632-3338. ; 3:7
-
Tidskriftsartikel (refereegranskat)abstract
- As part of the International Asteroid Warning Network's observational exercises, we conducted a campaign to observe near-Earth asteroid 2019 XS around its close approach to Earth on 2021 November 9. The goal of the campaign was to characterize errors in the observation times reported to the Minor Planet Center, which become an increasingly important consideration as astrometric accuracy improves and more fast-moving asteroids are observed. As part of the exercise, a total of 957 astrometric observations of 2019 XS during the encounter were reported and subsequently were analyzed to obtain the corresponding residuals. While the timing errors are typically smaller than 1 s, the reported times appear to be negatively biased, i.e., they are generally earlier than they should be. We also compared the observer-provided position uncertainty with the cross-track residuals, which are independent of timing errors. A large fraction of the estimated uncertainties appear to be optimistic, especially when <0 2. We compiled individual reports for each observer to help identify and remove the root cause of any possible timing error and improve the uncertainty quantification process. We suggest possible sources of timing errors and describe a simple procedure to derive reliable, conservative position uncertainties.
|
|
| 8. |
- Hu, Kaibo, et al.
(författare)
-
Highly selective recovery of rare earth elements from mine wastewater by modifying kaolin with phosphoric acid
- 2023
-
Ingår i: Separation and Purification Technology. - : Elsevier. - 1383-5866 .- 1873-3794. ; 309
-
Tidskriftsartikel (refereegranskat)abstract
- Recovery of rare earth elements (REEs) from mine wastewater is essential for maintaining rare earth reserves and sustainable application of REEs. In the present study, we prepared a phosphoric acid modified kaolin (P-K) adsorbent by a simple mechanochemical process for the selective recovery of REEs from rare earth wastewater. The impacts of phosphoric acid dosage, milling duration, initial pH, temperature, initial ion concentration, and adsorbent dosage on the selective adsorption of REEs were investigated. The findings demonstrate that the adsorption of REEs by P-K follows pseudo-second-order kinetic model and the Langmuir isotherm model, and is dominated by chemical adsorption, with a maximum adsorption capacity of 19.82 mg/g at 50 ℃. Additionally, in an original mine wastewater, the recovery rate of REEs can reach more than 90%, whereas the adsorption rates of calcium, magnesium and, ammonia nitrogen (whose concentration is 18 times that of REEs) are nearly zero, indicating that P-K has extremely high selectivity for REEs. Furthermore, the feedstock solution containing 40 mg/L of REEs may be concentrated to 3510 mg/L following enrichment treatment, and 99.9% of the REEs are eluted using a low concentration of hydrochloric acid. The findings illustrate that P-K has a wide range of potential applications in the treatment of rare earth industrial effluents.
|
|
| 9. |
|
|
| 10. |
- Xie, Lan, et al.
(författare)
-
Shear capacity of stud-groove connector in Glulam-concrete composite structure
- 2017
-
Ingår i: BioResources. - : North Carolina State University. - 1930-2126. ; 12:3, s. 4690-4706
-
Tidskriftsartikel (refereegranskat)abstract
- A timber-concrete composite structure (TCC) is economically and environmentally friendly. One of the key design points of this kind of structure is to ensure the reliability of the shear connectors. The objective of this paper is to study the mechanical property of stud-groove-type connectors and to provide shear capacity equations for stud-groove connectors in timber-concrete composite structures. Based on the Johansen Yield Theory (European Yield Model), some mechanical models and capacity equations for stud-groove-type connectors in timber-concrete structures were studied. Push-out specimens with different parameters (stud diameter, stud length, groove width, and groove depth) were tested to obtain the shear capacity and slip modulus. The experimental strengths were used to validate equations given in the paper. The shear capacity and slip modulus of stud-groove-type connectors was in direct proportion to the diameter of studs and the dimension of the groove. Comparison between the theoretical and the experimental shear strength results showed reasonable agreement. The highlight of this study on shear capacity equations could significantly reduce the push-out tests before investigating the other properties of TCC.
|
|
