| 1. |
- Acharya, B. S., et al.
(författare)
-
Introducing the CTA concept
- 2013
-
Ingår i: Astroparticle physics. - : Elsevier BV. - 0927-6505 .- 1873-2852. ; 43, s. 3-18
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- The Cherenkov Telescope Array (CTA) is a new observatory for very high-energy (VHE) gamma rays. CTA has ambitions science goals, for which it is necessary to achieve full-sky coverage, to improve the sensitivity by about an order of magnitude, to span about four decades of energy, from a few tens of GeV to above 100 TeV with enhanced angular and energy resolutions over existing VHE gamma-ray observatories. An international collaboration has formed with more than 1000 members from 27 countries in Europe, Asia, Africa and North and South America. In 2010 the CTA Consortium completed a Design Study and started a three-year Preparatory Phase which leads to production readiness of CTA in 2014. In this paper we introduce the science goals and the concept of CTA, and provide an overview of the project. (C) 2013 Elsevier B.V. All rights reserved.
|
|
| 2. |
- Actis, M., et al.
(författare)
-
Design concepts for the Cherenkov Telescope Array CTA : an advanced facility for ground-based high-energy gamma-ray astronomy
- 2011
-
Ingår i: Experimental astronomy. - : Springer. - 0922-6435 .- 1572-9508. ; 32:3, s. 193-316
-
Tidskriftsartikel (refereegranskat)abstract
- Ground-based gamma-ray astronomy has had a major breakthrough with the impressive results obtained using systems of imaging atmospheric Cherenkov telescopes. Ground-based gamma-ray astronomy has a huge potential in astrophysics, particle physics and cosmology. CTA is an international initiative to build the next generation instrument, with a factor of 5-10 improvement in sensitivity in the 100 GeV-10 TeV range and the extension to energies well below 100 GeV and above 100 TeV. CTA will consist of two arrays (one in the north, one in the south) for full sky coverage and will be operated as open observatory. The design of CTA is based on currently available technology. This document reports on the status and presents the major design concepts of CTA.
|
|
| 3. |
- Christiansen, Evald H, et al.
(författare)
-
Instantaneous Wave-free Ratio versus Fractional Flow Reserve to Guide PCI.
- 2017
-
Ingår i: The New England journal of medicine. - : Massachussetts Medical Society. - 1533-4406 .- 0028-4793. ; 376:19, s. 1813-1823
-
Tidskriftsartikel (refereegranskat)abstract
- The instantaneous wave-free ratio (iFR) is an index used to assess the severity of coronary-artery stenosis. The index has been tested against fractional flow reserve (FFR) in small trials, and the two measures have been found to have similar diagnostic accuracy. However, studies of clinical outcomes associated with the use of iFR are lacking. We aimed to evaluate whether iFR is noninferior to FFR with respect to the rate of subsequent major adverse cardiac events.We conducted a multicenter, randomized, controlled, open-label clinical trial using the Swedish Coronary Angiography and Angioplasty Registry for enrollment. A total of 2037 participants with stable angina or an acute coronary syndrome who had an indication for physiologically guided assessment of coronary-artery stenosis were randomly assigned to undergo revascularization guided by either iFR or FFR. The primary end point was the rate of a composite of death from any cause, nonfatal myocardial infarction, or unplanned revascularization within 12 months after the procedure.A primary end-point event occurred in 68 of 1012 patients (6.7%) in the iFR group and in 61 of 1007 (6.1%) in the FFR group (difference in event rates, 0.7 percentage points; 95% confidence interval [CI], -1.5 to 2.8; P=0.007 for noninferiority; hazard ratio, 1.12; 95% CI, 0.79 to 1.58; P=0.53); the upper limit of the 95% confidence interval for the difference in event rates fell within the prespecified noninferiority margin of 3.2 percentage points. The results were similar among major subgroups. The rates of myocardial infarction, target-lesion revascularization, restenosis, and stent thrombosis did not differ significantly between the two groups. A significantly higher proportion of patients in the FFR group than in the iFR group reported chest discomfort during the procedure.Among patients with stable angina or an acute coronary syndrome, an iFR-guided revascularization strategy was noninferior to an FFR-guided revascularization strategy with respect to the rate of major adverse cardiac events at 12 months. (Funded by Philips Volcano; iFR SWEDEHEART ClinicalTrials.gov number, NCT02166736 .).
|
|
| 4. |
- Sharifi, Sina, et al.
(författare)
-
Electron Beam Sterilization of Poly(Methyl Methacrylate)-Physicochemical and Biological Aspects
- 2021
-
Ingår i: Macromolecular Bioscience. - : John Wiley & Sons. - 1616-5187 .- 1616-5195. ; 21:4
-
Tidskriftsartikel (refereegranskat)abstract
- Electron beam (E-beam) irradiation is an attractive and efficient method for sterilizing clinically implantable medical devices made of natural and/or synthetic materials such as poly(methyl methacrylate) (PMMA). As ionizing irradiation can affect the physicochemical properties of PMMA, understanding the consequences of E-beam sterilization on the intrinsic properties of PMMA is vital for clinical implementation. A detailed assessment of the chemical, optical, mechanical, morphological, and biological properties of medical-grade PMMA after E-beam sterilization at 25 and 50 kiloGray (kGy) is reported. Fourier transform infrared spectroscopy, thermogravimetric analysis, and differential scanning calorimetry studies indicate that E-beam irradiation has minimal effect on the chemical properties of the PMMA at these doses. While 25 kGy irradiation does not alter the mechanical and optical properties of the PMMA, 50 kGy reduces the flexural strength and transparency by 10% and 2%, respectively. Atomic force microscopy demonstrates that E-beam irradiation reduces the surface roughness of PMMA in a dose dependent manner. Live-Dead, AlamarBlue, immunocytochemistry, and complement activation studies show that E-beam irradiation up to 50 kGy has no adverse effect on the biocompatibility of the PMMA. These findings suggest that E-beam irradiation at 25 kGy may be a safe and efficient alternative for PMMA sterilization.
|
|
