| 1. |
- Cui, Yong, et al.
(författare)
-
Accurate photovoltaic measurement of organic cells for indoor applications
- 2021
-
Ingår i: Joule. - : CELL PRESS. - 2542-4351. ; 5:5, s. 1016-1023
-
Tidskriftsartikel (övrigt vetenskapligt/konstnärligt)abstract
- Photovoltaic (PV) cells offer a convenient energy source to drive micropower electronic devices for indoor applications. However, it is challenging to measure the power conversion efficiency (PCE) of PV cells under indoor lighting and the PV community lacks a feasible and accurate measurement protocol. Here, we start with the fundamental parameters which determine the PCE, and carefully design a series of experiments to examine the origins which might cause measurement errors for organic PV measurements under indoor lighting. We demonstrate the critical importance of: 1, temporal stability and spatial homogeneity of the light sources, 2, calibration of the spectral irradiance and illuminations of the light sources, 3, the area of the cells (1 cm2 or large cells are preferred), 4, the aperture of the mask (an aperture slightly smaller than the cell area is preferred), and 5, stray lights from the measurement environment. Based on these careful investigations, we suggest a feasible measurement method, by which accurate measurement of the indoor PV efficiency is made possible. Our study will promote the healthy development of indoor PV technology for practical applications.
|
|
| 2. |
- Cui, Yong, et al.
(författare)
-
Over 16% efficiency organic photovoltaic cells enabled by a chlorinated acceptor with increased open-circuit voltages
- 2019
-
Ingår i: Nature Communications. - : NATURE PUBLISHING GROUP. - 2041-1723. ; 10
-
Tidskriftsartikel (refereegranskat)abstract
- Broadening the optical absorption of organic photovoltaic (OPV) materials by enhancing the intramolecular push-pull effect is a general and effective method to improve the power conversion efficiencies of OPV cells. However, in terms of the electron acceptors, the most common molecular design strategy of halogenation usually results in down-shifted molecular energy levels, thereby leading to decreased open-circuit voltages in the devices. Herein, we report a chlorinated non-fullerene acceptor, which exhibits an extended optical absorption and meanwhile displays a higher voltage than its fluorinated counterpart in the devices. This unexpected phenomenon can be ascribed to the reduced non-radiative energy loss (0.206 eV). Due to the simultaneously improved short-circuit current density and open-circuit voltage, a high efficiency of 16.5% is achieved. This study demonstrates that finely tuning the OPV materials to reduce the bandgap-voltage offset has great potential for boosting the efficiency.
|
|
| 3. |
- Cui, Yong, et al.
(författare)
-
Single-Junction Organic Photovoltaic Cells with Approaching 18% Efficiency
- 2020
-
Ingår i: Advanced Materials. - : WILEY-V C H VERLAG GMBH. - 0935-9648 .- 1521-4095. ; 32:19
-
Tidskriftsartikel (refereegranskat)abstract
- Optimizing the molecular structures of organic photovoltaic (OPV) materials is one of the most effective methods to boost power conversion efficiencies (PCEs). For an excellent molecular system with a certain conjugated skeleton, fine tuning the alky chains is of considerable significance to fully explore its photovoltaic potential. In this work, the optimization of alkyl chains is performed on a chlorinated nonfullerene acceptor (NFA) named BTP-4Cl-BO (a Y6 derivative) and very impressive photovoltaic parameters in OPV cells are obtained. To get more ordered intermolecular packing, the n-undecyl is shortened at the edge of BTP-eC11 to n-nonyl and n-heptyl. As a result, the NFAs of BTP-eC9 and BTP-eC7 are synthesized. The BTP-eC7 shows relatively poor solubility and thus limits its application in device fabrication. Fortunately, the BTP-eC9 possesses good solubility and, at the same time, enhanced electron transport property than BTP-eC11. Significantly, due to the simultaneously enhanced short-circuit current density and fill factor, the BTP-eC9-based single-junction OPV cells record a maximum PCE of 17.8% and get a certified value of 17.3%. These results demonstrate that minimizing the alkyl chains to get suitable solubility and enhanced intermolecular packing has a great potential in further improving its photovoltaic performance.
|
|
