| 1. |
- Mussa, Abdilbari, et al.
(författare)
-
Fast-charging effects on ageing for energy-optimized automotive LiNi1/3Mn1/3Co1/3O2/graphite prismatic lithium-ion cells
- 2019
-
Ingår i: Journal of Power Sources. - : ELSEVIER SCIENCE BV. - 0378-7753 .- 1873-2755. ; 422, s. 175-184
-
Tidskriftsartikel (refereegranskat)abstract
- The reactions in energy-optimized 25 Ah prismatic NMC/graphite lithium-ion cell, as a function of fast charging (1C-4C), are more complex than earlier described. There are no clear charging rate dependent trends but rather different mechanisms dominating at the different charging rates. Ageing processes are faster at 3 and 4C charging. Cycling with 3C-charging results in accelerated lithium plating but the 4C-charging results in extensive gas evolution that contribute significantly to the large cell impedance rise. Graphite exfoliation and accelerated lithium inventory loss point to the graphite electrode as the source of the gas evolution. The results are based on careful post-mortem analyses of electrodes using: scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and electrochemical impedance spectroscopy (EIS). SEM results show particle cracking independent of the charging rate used for the cycling. XPS and EIS generally indicate thicker surface film and larger impedance, respectively, towards the edge of the jellyrolls. For the intended application of a battery electric inner-city bus using this type of cell, charging rates of 3C and above are not feasible, considering battery lifetime. However, charging rates of 2C and below are too slow from the point of view of practical charging time.
|
|
| 2. |
- Renman, Viktor, et al.
(författare)
-
Manganese pyrosilicates as novel positive electrode materials for Na-ion batteries
- 2018
-
Ingår i: Sustainable Energy & Fuels. - : Royal Society of Chemistry (RSC). - 2398-4902. ; 2:5, s. 941-945
-
Tidskriftsartikel (refereegranskat)abstract
- A carbon-coated pyrosilicate, Na2Mn2Si2O7/C, was synthesized and characterized for use as a new positive-electrode material for sodium ion batteries. The material consists of 20-80 nm primary particles embedded in a approximate to 10 nm-thick conductive carbon matrix. Reversible insertion of Na+ ions is clearly demonstrated with approximate to 25% of its theoretical capacity (165 mA h g(-1)) being accessible at room temperature at a low cycling rate. The material yields an average potential of 3.3 V vs. Na+/Na on charge and 2.2 V on discharge. DFT calculations predict an equilibrium potential for Na2Mn2Si2O7 in the range of 2.8-3.0 V vs. Na+/Na, with a possibility of a complete flip in the connectivity of neighboring Mn-polyhedra - from edge-sharing to disconnected and vice versa. This significant rearrangement in Mn coordination (approximate to 2 angstrom) and large volume contraction (>10%) could explain our inability to fully desodiate the material, and illustrates well the need for a new electrode design strategy beyond the conventional down-sizing/coating procedure.
|
|
