| 1. |
|
|
| 2. |
- Ekelund, Maria, et al.
(författare)
-
Evaporative loss kinetics of di(2-ethylhexyl)phthalate (DEHP) from pristine DEHP and plasticized PVC
- 2010
-
Ingår i: Polymer degradation and stability. - : Elsevier BV. - 0141-3910 .- 1873-2321. ; 95:9, s. 1789-1793
-
Tidskriftsartikel (refereegranskat)abstract
- The migration of di(2-ethylhexyl)phthalate (DEHP) from poly(vinyl chloride) (PVC) to a surrounding gas phase at temperatures below 120 degrees C kinetically is controlled by evaporation. The effects on the DEHP loss rate of nitrogen flow rate, relative humidity and degradation of the plasticizer at 100 degrees C was assessed. The sample mass decreased linearly with time for both pristine DEHP and plasticized PVC at comparable rates, suggesting that a thin film of DEHP was present on the jacketing insulation during desorption. The latter hypothesis was supported by infrared spectroscopy and by the fact that DEHP is an amphiphilic molecule that will tend to aggregate at the surface with the hydrophobic 2-ethylhexyl units at the air interface. The effect on the migration rate of moisture present in the gas phase was negligible. The DEHP loss rate increased in a retarding non-linear fashion with increasing gas flow rate. In one of the experiments, DEHP was accidently degraded as revealed by discoloration, the presence of low molar mass degradation products (liquid chromatography) containing additional carbonyl groups (infrared spectroscopy) and an increase in the evaporation rate at temperatures between 100 and 130 degrees C. (C) 2010 Elsevier Ltd. All rights reserved.
|
|
| 3. |
- Ekelund, Maria, et al.
(författare)
-
Lifetime prediction : different strategies by example
- 2009
-
Ingår i: POLYMER DEGRADATION AND PERFORMANCE. - Washington, DC : American Chemical Society. - 9780841269781 ; , s. 159-169
-
Konferensbidrag (refereegranskat)abstract
- Two different approaches for lifetime prediction are presented. The underlying lifetime limiting processes have been identified in two cases. Mathematical expressions of chemical/physical relevance were used for the lifetime predictions for PE hot-water pipes and cables insulated with plasticized PVC. Accelerated testing, extrapolation and validation of the extrapolation by assessment of the remaining lifetime of objects aged during service conditions for 25 years were successfully applied to cables insulated with chlorosulfonated polyethylene. Polyolefin pipes exposed to chlorinated water showed a very complex deterioration scenario and it was only possible to find a method suitable for predicting the time for the depletion of the stabilizer system.
|
|
| 4. |
- Ekelund, Maria, 1977-
(författare)
-
Long-term performance of poly(vinyl chloride) cables : mechanical and electrical performances and the effect of plasticizer migration
- 2007
-
Licentiatavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Cables insulated with plasticized poly(vinyl chloride) were aged at temperatures between 80 and 180 °C in air and their conditions were assessed by indenter modulus measurements, tensile testing, infrared (IR) spectroscopy, differential scanning calorimetry (DSC) and liquid chromatography (HPLC). Electrical testing of oven-aged cable samples was performed in order to relate the electrical functionality during a high-energy line break accident to the mechanical properties and to establish a lifetime criterion. The mechanical data taken at room temperature after ageing could be superimposed with regard to ageing time and temperature. The ageing-temperature shift factor showed Arrhenius temperature dependence. The jacketing material showed an immediate increase in stiffness (indenter and Young’s modulus) and a decrease in the strain at break on ageing; these changes were dominated by loss of plasticizer by migration also confirmed by IR spectroscopy, DSC and HPLC. The core insulation showed smaller and also delayed changes in these mechanical parameters; the loss of plasticizer by migration was retarded by the closed environment and the changes in the mechanical parameters were due to chemical degradation (dehydrochlorination). Comparison with data obtained from this study and from other studies indicates that extrapolation of data for the jacketing insulation can be performed according to the Arrhenius equation even down to service temperatures (20-40 °C). Extraction of plasticizer of samples from cables that have been exposed to service for 25 years showed a minor decrease (within the margin of error) in plasticizer content with reference to that of unexposed cable samples. The low temperature deterioration of the jacketing is according to this scheme dominated by loss of plasticizer by migration. Numerical analysis were performed on desorption data obtained by liquid chromatography. The fitting of the data to Fick’s law showed a transition between 100 and 120 ºC. This was interpreted as a change from evaporation-control of migration at low temperatures to a diffusion-control of migration at the higher temperatures.
|
|
| 5. |
- Ekelund, Maria, et al.
(författare)
-
Long-term performance of poly(vinyl chloride) cables. Part 1 : Mechanical and electrical performances
- 2007
-
Ingår i: Polymer degradation and stability. - : Elsevier BV. - 0141-3910 .- 1873-2321. ; 92:4, s. 617-629
-
Tidskriftsartikel (refereegranskat)abstract
- Cables insulated with plasticized poly(vinyl chloride) were aged in air at temperatures between 80 degrees C and 180 degrees C and their conditions were assessed by indenter modulus measurements, tensile testing, infrared (IR) spectroscopy and differential scanning calorimetry (DSC). Electrical testing of oven-aged cable samples was performed in order to relate the electrical functionality during a high-energy line break (HELB) to the mechanical properties and to establish a lifetime criterion. The mechanical data taken at room temperature after ageing could be superimposed with regard to ageing time and temperature. The ageing-temperature shift factor showed an Arrhenius temperature dependence. The jacketing material showed an immediate increase in stiffness (indenter modulus and Young's modulus) and a decrease in the strain at break on ageing; these changes were dominated by loss of plasticizer by migration which was confirmed by IR spectroscopy and DSC. The core insulation showed smaller changes in these mechanical parameters; the loss of plasticizer by migration was greatly retarded by the closed environment, according to data obtained by IR spectroscopy and DSC, and the changes in the mechanical parameters were due to chemical degradation (dehydrochlorination). A comparison of data obtained from this study and data from other studies indicates that extrapolation of data for the jacketing insulation can be performed according to the Arrhenius equation even down to service temperatures (20-50 degrees C). The low-temperature deterioration of the jacketing is, according to this scheme, dominated by loss of plasticizer by migration.
|
|
| 6. |
- Ekelund, Maria, et al.
(författare)
-
Long-term performance of poly(vinyl chloride) cables, Part 2 : Migration of plasticizer
- 2008
-
Ingår i: Polymer degradation and stability. - : Elsevier BV. - 0141-3910 .- 1873-2321. ; 93:9, s. 1704-1710
-
Tidskriftsartikel (refereegranskat)abstract
- Cable samples with plasticized poly(vinyl chloride) insulations were aged in air at temperatures between 80 and 155 degrees C. The concentrations of the plasticizer (di-(2-ethylhexyl) phthalate, DEHP) in the insulations of the aged cables were determined by extraction of samples in tetrahydrofuran followed by analysis of the extract by liquid chromatography. The plasticizer concentration data for different ageing times were analysed by numerical methods, fitting Fick's second law with a concentration-dependent diffusivity. The analysis showed that the transport of the plasticizer to the surrounding air phase was controlled by diffusion at 120 and 155 degrees C with an activation energy of 89 kJ mol(-1). The evaporation of the plasticizer from the outer boundary was rate controlling at lower temperatures (<= 100 degrees C), The rate of evaporation was initially constant and independent of the plasticizer concentration at both 80 and 100 degrees C. The activation energy for the initial DEHP loss rate from PVC at these temperatures was the same as that obtained for evaporation of pure DEHP on a glass plate at 60-100 degrees C measured by thermogravimetry, 98 2 kJ mol-1. Furthermore, the evaporation rate of pure DEHP on a glass plate was also of the same order of magnitude as the rate of plasticizer loss from the cable insulation. Extrapolation of the plasticizer loss rate data (from the cable at 80 degrees C and from pure liquid DEHP at temperatures between 60 and 100 IQ to 25 degrees C predicted a maximum loss of plasticizer of 1% over 25 years. This is in accordance with earlier presented data and with the data presented in this report.
|
|
| 7. |
|
|
