| 1. |
|
|
| 2. |
|
|
| 3. |
|
|
| 4. |
- Boström, Cecilia, et al.
(författare)
-
Experimental results from an offshore wave energy converter
- 2008
-
Ingår i: Volume 6. ; , s. 653-657
-
Konferensbidrag (refereegranskat)abstract
- Anoffshore wave energy converter (WEC) was successfully launched at theSwedish west coast in the middle of March 2006. TheWEC is based on a permanent magnet linear generator locatedon the ocean floor driven by a point absorber. Ameasuring station has been installed on a nearby island whereall measurements and experiments on the WEC have been carriedout. The output voltage from the generator fluctuates both inamplitude and frequency and must therefore be converted to enablegrid connection. In order to study the voltage conversion, themeasure station was fitted with a six pulse diode rectifierand a capacitive filter during the autumn of 2006. Theobject of this paper is to present a detailed descriptionof the existing wave energy system of the Islandsberg project.Special attention will be given to the power absorption bythe generator when it is connected to a non linearload
|
|
| 5. |
- Boström, Cecilia, et al.
(författare)
-
Experimental Results From an Offshore Wave Energy Converter
- 2010
-
Ingår i: Journal of Offshore Mechanics and Arctic Engineering-Transactions of The Asme. - : ASME International. - 0892-7219 .- 1528-896X. ; 132:4, s. 041103-
-
Tidskriftsartikel (refereegranskat)abstract
- An offshore wave energy converter (WEC) was successfully launched at the Swedish west coast in the middle of March 2006. The WEC is based on a permanent magnet linear generator located on the sea floor driven by a point absorber. A measuring station has been installed on a nearby island where all measurements and experiments on the WEC have been carried out. The output voltage from the generator fluctuates both in amplitude and frequency and must therefore be converted to enable grid connection. In order to study the voltage conversion, the measuring station was fitted with a six pulse diode rectifier and a capacitive filter during the autumn of 2006. The object of this paper is to present a detailed description of the Lysekil research site. Special attention will be given to the power absorption by the generator when it is connected to a nonlinear load.
|
|
| 6. |
|
|
| 7. |
- Boström, Cecilia, et al.
(författare)
-
Linear Generator Connected to a Resonance-Rectifier Circuit
- 2013
-
Ingår i: IEEE Journal of Oceanic Engineering. - 0364-9059 .- 1558-1691. ; 38:2, s. 255-262
-
Tidskriftsartikel (refereegranskat)abstract
- This paper describes a linear direct driven generator used for wave energy utilization. The generator is placed on the seabed and connected to a buoy on the ocean surface. Due to the reciprocating motion of the translator, an electrical conversion system is needed between the wave energy converter (WEC) and the grid. Depending on how the conversion system is designed, the generator will be subjected to different loads. A novel conversion system is presented in this paper where the voltage from the WEC is rectified in a resonance circuit. Both simulations and experiments are performed on the circuit. The results from the simulations show that a higher power absorption and power production can be achieved with the resonance circuit compared to a WEC connected to a passive rectifier. A WEC, L9, developed by Uppsala University (Uppsala, Sweden) was used in the experiment. Significantly higher power absorption was obtained for L9 compared to power data from the first installed WEC, L1, at the Lysekil research site.
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
- Danielsson, Oskar, et al.
(författare)
-
Study of a Longitudinal Flux Permanent Magnet Linear Generator for Wave Energy Converters
- 2006
-
Ingår i: International Journal of Energy Research. - : Hindawi Limited. - 0363-907X .- 1099-114X. ; 30:14, s. 1130-1145
-
Tidskriftsartikel (refereegranskat)abstract
- A directly coupled linear permanent magnet generator of longitudinal flux-type is investigated. The generator will be used for power take-off in a wave energy converter. A combined field- and circuit model, solved by a time stepping finite element technique, is used to model and analyse the electromagnetic behaviour of the machine. A large number of simulations form the basis of a design study where the influence of armature current level, number of cables per slot, and pole width is investigated with respect to efficiency, generator size, and the load angle. A case study is performed for a chosen generator design. The electromagnetic behaviour is examined both for nominal load and for overloads. The generator has a nominal output power of 10 kW for a constant piston speed of 0.7 m s(-1). The electromagnetic efficiency at nominal load is 86.0%, the load angle 6.6 degrees, and the power fluctuation 1.3%. At 300% overload the load angle barely exceeds 12 degrees and the cable temperature is below 25 degrees C provided that the stator back is thermally connected to the sea water. The numerical calculations have been verified for small speeds by experiments.
|
|
