| 1. |
- Aad, G., et al.
(författare)
-
- 2011
-
swepub:Mat__t (refereegranskat)
|
|
| 2. |
- Aad, G, et al.
(författare)
-
- 2015
-
swepub:Mat__t
|
|
| 3. |
- Abel, I, et al.
(författare)
-
Overview of the JET results with the ITER-like wall
- 2013
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 53:10, s. 104002-
-
Tidskriftsartikel (refereegranskat)abstract
- Following the completion in May 2011 of the shutdown for the installation of the beryllium wall and the tungsten divertor, the first set of JET campaigns have addressed the investigation of the retention properties and the development of operational scenarios with the new plasma-facing materials. The large reduction in the carbon content (more than a factor ten) led to a much lower Z(eff) (1.2-1.4) during L- and H-mode plasmas, and radiation during the burn-through phase of the plasma initiation with the consequence that breakdown failures are almost absent. Gas balance experiments have shown that the fuel retention rate with the new wall is substantially reduced with respect to the C wall. The re-establishment of the baseline H-mode and hybrid scenarios compatible with the new wall has required an optimization of the control of metallic impurity sources and heat loads. Stable type-I ELMy H-mode regimes with H-98,H-y2 close to 1 and beta(N) similar to 1.6 have been achieved using gas injection. ELM frequency is a key factor for the control of the metallic impurity accumulation. Pedestal temperatures tend to be lower with the new wall, leading to reduced confinement, but nitrogen seeding restores high pedestal temperatures and confinement. Compared with the carbon wall, major disruptions with the new wall show a lower radiated power and a slower current quench. The higher heat loads on Be wall plasma-facing components due to lower radiation made the routine use of massive gas injection for disruption mitigation essential.
|
|
| 4. |
- Romanelli, F, et al.
(författare)
-
Overview of the JET results
- 2011
-
Ingår i: Nuclear Fusion. - : IOP Publishing. - 1741-4326 .- 0029-5515. ; 51:9
-
Tidskriftsartikel (refereegranskat)abstract
- Since the last IAEA Conference JET has been in operation for one year with a programmatic focus on the qualification of ITER operating scenarios, the consolidation of ITER design choices and preparation for plasma operation with the ITER-like wall presently being installed in JET. Good progress has been achieved, including stationary ELMy H-mode operation at 4.5 MA. The high confinement hybrid scenario has been extended to high triangularity, lower ρ*and to pulse lengths comparable to the resistive time. The steady-state scenario has also been extended to lower ρ*and ν*and optimized to simultaneously achieve, under stationary conditions, ITER-like values of all other relevant normalized parameters. A dedicated helium campaign has allowed key aspects of plasma control and H-mode operation for the ITER non-activated phase to be evaluated. Effective sawtooth control by fast ions has been demonstrated with3He minority ICRH, a scenario with negligible minority current drive. Edge localized mode (ELM) control studies using external n = 1 and n = 2 perturbation fields have found a resonance effect in ELM frequency for specific q95values. Complete ELM suppression has, however, not been observed, even with an edge Chirikov parameter larger than 1. Pellet ELM pacing has been demonstrated and the minimum pellet size needed to trigger an ELM has been estimated. For both natural and mitigated ELMs a broadening of the divertor ELM-wetted area with increasing ELM size has been found. In disruption studies with massive gas injection up to 50% of the thermal energy could be radiated before, and 20% during, the thermal quench. Halo currents could be reduced by 60% and, using argon/deuterium and neon/deuterium gas mixtures, runaway electron generation could be avoided. Most objectives of the ITER-like ICRH antenna have been demonstrated; matching with closely packed straps, ELM resilience, scattering matrix arc detection and operation at high power density (6.2 MW m-2) and antenna strap voltages (42 kV). Coupling measurements are in very good agreement with TOPICA modelling. © 2011 IAEA, Vienna.
|
|
| 5. |
- Abazov, V. M., et al.
(författare)
-
Search for the pair production of scalar top quarks in the acoplanar charm jet final state in p(p)over-bar collisions at root s=1.96 TeV
- 2007
-
Ingår i: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 645:2-3, s. 119-127
-
Tidskriftsartikel (refereegranskat)abstract
- A search for the pair production of scalar top quarks, (t) over tilde, has been performed in 360 pb(-1) of data from pp collisions at a center-of-mass energy of 1.96 TeV, collected by the D phi detector at the Fermilab Tevatron collider. The (t) over tilde decay mode considered is (t) over tilde -> c (chi) over tilde (0)(1), where (chi) over tilde (0)(1) is the lightest supersymmetric particle. The topology analyzed therefore consists of a pair of acoplanar heavy-flavor jets with missing transverse energy. The data and standard model expectation are in agreement, anda 95% C.L. exclusion domain in the (m((t) over tilde), m((chi) over tilde1)(0)) plane has been determined, extending the domain excluded by previous experiments.
|
|
| 6. |
- Abazov, V. M., et al.
(författare)
-
Experimental discrimination between charge 2e/3 top quark and charge 4e/3 exotic quark production scenarios
- 2007
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 98:4, s. 041801-
-
Tidskriftsartikel (refereegranskat)abstract
- We present the first experimental discrimination between the 2e/3 and 4e/3 top quark electric charge scenarios, using top quark pairs (t (t) over bar) produced in p (p) over bar collisions at root s =1.96 TeV by the Fermilab Tevatron Collider. We use 370 pb(-1) of data collected by the D0 experiment and select events with at least one high transverse momentum electron or muon, high transverse energy imbalance, and four or more jets. We discriminate between b- and (b) over bar -quark jets by using the charge and momenta of tracks within the jet cones. The data are consistent with the expected electric charge, |q|=2e/3. We exclude, at the 92% C.L., that the sample is solely due to the production of exotic quark pairs Q (Q) over bar with |q|=4e/3. We place an upper limit on the fraction of Q (Q) over bar pairs rho < 0.80 at the 90% C.L.
|
|
| 7. |
- Abazov, V. M., et al.
(författare)
-
Limits on anomalous trilinear gauge couplings from WW -> e(+)e(-), WW -> e(+/-)mu(-/+), and WW ->mu(+)mu(-) events from pp collisions at root s=1.96 TeV
- 2006
-
Ingår i: Physical Review D - Particles, Fields, Gravitation and Cosmology. - 1550-7998 .- 1550-2368. ; 74:5, s. 057101-
-
Tidskriftsartikel (refereegranskat)abstract
- Limits are set on anomalous WW gamma and WWZ trilinear gauge couplings using W+W--> e(+)nu(e)e(-)(nu) over bar (e), W+W--> e(+/-)nu(e)mu(-/+)nu(mu), and W+W-->mu(+)nu(mu)mu(-)(nu) over bar (mu) events. The data set was collected by the Run II D0 detector at the Fermilab Tevatron Collider and corresponds to approximately 250 pb(-1) of integrated luminosity at root s=1.96 TeV. Under the assumption that the WW gamma couplings are equal to the WWZ couplings and using a form factor scale of Lambda=2.0 TeV, the combined 95% C.L. one-dimensional coupling limits from all three channels are -0.32
|
|
| 8. |
- Abazov, V. M., et al.
(författare)
-
Measurement of B-d mixing using opposite-side flavor tagging
- 2006
-
Ingår i: Physical Review D - Particles, Fields, Gravitation and Cosmology. - 1550-7998 .- 1550-2368. ; 74:11, s. 112002-
-
Tidskriftsartikel (refereegranskat)abstract
- We report on a measurement of the B-d(0) mixing frequency and the calibration of an opposite-side flavor tagger in the D0 experiment. Various properties associated with the b quark on the opposite side of the reconstructed B meson are combined using a likelihood-ratio method into a single variable with enhanced tagging power. Its performance is tested with data, using a large sample of reconstructed semileptonic B ->mu(DX)-X-0 and B ->mu(DX)-X-* decays, corresponding to an integrated luminosity of approximately 1 fb(-1). The events are divided into groups depending on the value of the combined tagging variable, and an independent analysis is performed in each group. Combining the results of these analyses, the overall effective tagging power is found to be epsilon D-2=(2.48 +/- 0.21(-0.06)(+0.08))%. The measured B-d(0) mixing frequency Delta m(d)=0.506 +/- 0.020(stat)+/- 0.016(syst) ps(-1) is in good agreement with the world average value.
|
|
| 9. |
- Abazov, V. M., et al.
(författare)
-
Measurement of beta (t -> Wb)/beta(t -> Wq) at root s=1.96 TeV
- 2006
-
Ingår i: Physics Letters B. - : Elsevier BV. - 0370-2693 .- 1873-2445. ; 639:6, s. 616-622
-
Tidskriftsartikel (refereegranskat)abstract
- We present the measurement of R = B(t -> Wb)/B(t -> Wq) in pp collisions at root s = 1.96 TeV, using 230 pb(-1) of data collected by the DO experiment at the Fermilab Tevatron Collider. We fit simultaneously R and the number (N-tt) of selected top quark pairs (tt), to the number of identified b-quark jets in events with one electron or one muon, three or more jets, and high transverse energy imbalance. To improve sensitivity, kinematical properties of events with no identified b-quark jets are included in the fit. We measure R = 1.03(-0.17)(0.19) (stat + syst), in good agreement with the standard model. We set lower limits of R > 0.61 and vertical bar V-tb vertical bar > 0.78 at 95% confidence level.
|
|
| 10. |
- Abazov, V. M., et al.
(författare)
-
Measurement of the B-s(0) lifetime using semileptonic decays
- 2006
-
Ingår i: Physical Review Letters. - 0031-9007 .- 1079-7114. ; 97:24, s. 241801-
-
Tidskriftsartikel (refereegranskat)abstract
- We report a measurement of the B-s(0) lifetime in the semileptonic decay channel B-s(0)-> D-s(-)mu(+)nu X (and its charge conjugate), using approximately 0.4 fb(-1) of data collected with the D0 detector during 2002-2004. Using 5176 reconstructed D-s(-)mu(+) signal events, we have measured the B-s(0) lifetime to be tau(B-s(0))=1.398 +/- 0.044(stat)(-0.025)(+0.028)(syst) ps. This is the most precise measurement of the B-s(0) lifetime to date.
|
|
