| 1. |
- Shah, F. U., et al.
(författare)
-
Halogen-free chelated orthoborate ionic liquids and organic ionic plastic crystals
- 2012
-
Ingår i: Journal of Materials Chemistry. - : Royal Society of Chemistry (RSC). - 0959-9428 .- 1364-5501. ; 22:14, s. 6928-6938
-
Tidskriftsartikel (refereegranskat)abstract
- Five halogen-free orthoborate salts comprised of three different cations (cholinium, pyrrolidinium and imidazolium) and two orthoborate anions, bis(mandelato) borate and bis(salicylato) borate, were synthesised and characterised by DSC, X-ray diffraction and NMR. DSC measurements revealed that glass transition points of these orthoborate salts are in the temperature range from -18 to -2 degrees C. In addition, it was found that [EMPy][BScB] and [EMIm][BScB] salts have solid-solid phase transitions below their melting points, i.e. they exhibit typical features of plastic crystals. Salts of the bis(salicylato) borate anion [BScB](-) have higher melting points compared with corresponding salts of the bis(mandelato) borate anion [BMB](-). Single crystal X-ray diffraction crystallography (for [Chol][BScB] crystals) and solid-state multinuclear (C-13, B-11 and N-15) NMR spectroscopy were employed for the structural characterisation of [Chol][BScB], [EMPy][BScB] and [EMIm][BScB], which are solids at room temperature: a strong interaction between [BScB](-) anions and [Chol](+) cations was identified as (i) hydrogen bonding between OH of [Chol](+) and carbonyl groups of [BScB](-) and (ii) as the inductive C-H center dot center dot center dot pi interaction. In the other salt, [EMIm][BScB], anions exhibit pi center dot center dot center dot pi stacking in combination with C-H center dot center dot center dot pi interactions with [EMIm]+ cations. These interactions were not identified in [EMPy] [BScB] probably because of the lack of aromaticity in cations of the latter system. Our data on the formation of a lanthanum complex with bis(salicylato) borate in the liquid mixture of La3+(aq) with [Chol][BScB] suggest that this class of novel ILs can be potentially used in the extraction processes of metal ions of rare earth elements.
|
|
| 2. |
- Adebahr, Josefina, 1973, et al.
(författare)
-
Ab initio calculations, Raman and NMR investigation of the plastic crystal di-methyl pyrrolidinium iodide
- 2003
-
Ingår i: Electrochimica Acta. - 0013-4686. ; 48:14-16, s. 2283-2289
-
Tidskriftsartikel (refereegranskat)abstract
- Above 110 °C the symmetric di-methyl-pyrrolidinium iodide salt forms a plastic crystal phase of interest in the area of new electrolyte materials. In this study ab initio calculations of this material has been conducted in order to assign the vibrational spectra. Raman spectroscopy measurements on the solid salt as well as on the salt dissolved in different solvents has been performed and these have been compared to the theoretical spectra. Furthermore, Raman spectra as a function of temperature have been recorded to investigate possible changes in inter-ionic interaction and/or structure through the phase transition. 1 H NMR linewidth measurements as a function of temperature showed a large decrease in linewidth above 100 °C, attributed here to an increase in mobility in agreement with a previously reported phase transition at ∼ 110 °C. © 2003 Elsevier Science Ltd. All rights reserved.
|
|
| 3. |
- Adebahr, Josefina, 1973, et al.
(författare)
-
Ion transport in polymer electrolytes containing nanoparticulate TiO2: The influence of polymer morphology
- 2003
-
Ingår i: Physical Chemistry Chemical Physics. - : Royal Society of Chemistry (RSC). - 1463-9084 .- 1463-9076. ; 5:4, s. 720-725
-
Tidskriftsartikel (refereegranskat)abstract
- Recent studies have shown that composite polymer electrolytes, formed by dispersing nanosized ceramic particles in polyether-based electrolytes, have improved ion transport properties as compared to their unfilled analogues. In the present study polymer electrolytes with different loadings of nano-sized ceramic particles (TiO 2 ) and different polymer chemistry and morphology have been investigated. Of special interest are filler induced effects on polymer, solvent and cationic mobility. Partly crystalline polymer electrolytes based on poly(ethylene oxide) have been compared to fully amorphous polymer electrolytes based on a polyether urethane, as well as gel electrolytes based on PMMA. 7 Li pfg-NMR, linewidth and spin-spin relaxation times as well as 1 H pfg-NMR and spin-spin relaxation times, were measured as a function of temperature and composition. The 1 H spin-spin relaxation measurements reveal increased average polymer mobility with the addition of filler up to a maximum at 4 and 8 wt.% TiO 2 for the fully amorphous and the partly crystalline electrolytes, respectively. The 7 Li linewidth measurements for the fully amorphous system show a broadening of the linewidth with addition of filler. Based on variable temperature measurements this broadening is interpreted as a result of the inhomogeneity introduced by the filler particles. Pulsed field gradient (pfg) diffusion measurements were employed to determine ion and solvent self-diffusion coefficients. In the case of the PMMA-based gel electrolyte and the fully amorphous electrolytes enhanced cation self-diffusion was observed upon addition of TiO 2 .
|
|
| 4. |
- Adebahr, Josefina, 1973, et al.
(författare)
-
Lithium coordination and mobility in gel electrolytes based on an acrylate polymer with ethylene oxide side chains
- 2003
-
Ingår i: Journal of Materials Chemistry. - : Royal Society of Chemistry (RSC). - 1364-5501 .- 0959-9428. ; 13:4, s. 814-817
-
Tidskriftsartikel (refereegranskat)abstract
- Multinuclear NMR has been used to investigate the structure and mobility of a series of polymer gel electrolytes. The co-polymers used as matrixes in the gels have acrylate backbones and side chains of ethylene oxide, where the length of the side chains has been varied, while the ratio of acrylate to ethylene oxide has been kept constant. The electrolyte is a mixture of lithium perchlorate and two solvents, ethylene carbonate and gamma butyrolactone. 13 C spectra of the different gel electrolytes shows that both solvents interact with the salt, and that the strength of the interaction increases with decreasing length of the polymer side chains. It also appears that the lithium ions show no selectivity between the two types of solvent. Furthermore, the lithium chemical shift moves progressively upfield with increasing length of the side chains, showing a gradual change in interaction from lithium-solvent to lithium-(ethylene oxide).
|
|
| 5. |
|
|
| 6. |
|
|
| 7. |
- Nordström, Jonas, 1980, et al.
(författare)
-
Aggregation, ageing and transport properties of surface modified fumed silica dispersions
- 2010
-
Ingår i: Soft Matter. - : Royal Society of Chemistry (RSC). - 1744-6848 .- 1744-683X. ; 6:10, s. 2293-2299
-
Tidskriftsartikel (refereegranskat)abstract
- We have investigated the aggregation, ageing and transport properties of surface modified silica dispersions in DMSO by photon correlation spectroscopy and conductivity measurements. The surface modification introduces Li+-ions that dissociate in the dispersion creating a single Li+-ion conducting electrolyte. We show that the surface modification changes the aggregation and ageing properties of the material. There is a pronounced ageing observed for the modified silica dispersions. At high concentrations of fumed silica a gel state is found, which in the case of the surface modified silica is a very weak gel that can be rejuvenated by ultrasonic treatment. The key parameter controlling the aggregation in this system is hydrogen bonding and the surface modification results in a very low number of sites for hydrogen bonding. In addition there is a contribution from repulsive electrostatic interactions in the surface modified silica dispersions due to the highly charged surfaces of these particles. Furthermore, the Li+-ion diffusion, at low silica concentration, is three orders of magnitude faster than that of the silica particles and in the gel state the silica particles are immobile. We also find that the Li+-ion diffusion is virtually independent of the silica concentration in the dispersions.
|
|
| 8. |
- Yan, Yajing, 1990, et al.
(författare)
-
Investigating discharge performance and Mg interphase properties of an Ionic Liquid electrolyte based Mg-air battery
- 2017
-
Ingår i: Electrochimica Acta. - : Elsevier BV. - 0013-4686. ; 235, s. 270-279
-
Tidskriftsartikel (refereegranskat)abstract
- The performance of a primary Mg-air cell was evaluated at room temperature using a 72 mol% ethylene glycol/trihexyl(tetradecyl) phosphonium chloride ([P-6,P-6,P-6,P-14][Cl]) ionic liquid (IL) electrolyte. The cell was cycling in ambient air as well as in the presence of pure oxygen, and interestingly the cell presented much higher discharge capacity in air than in oxygen, which was attributed to the effect of water in the ambient air. When operated in ambient air, the cell showed promising discharge behaviour with a maximum rate of 0.2 mA cm(-2) and a discharge capacity of around 4.8 mAh cm(-2). When operated at a low rate 0.0075 mA cm(-2), the cell lasted for over 260 h, 10 days, at a potential above 1.3 V. Thus, the main focus of this study is the analysis of the mechanism of discharge capacity loss in this electrolyte, which revealed that, both the polarization due to the presence of a resistive Mg interphase on the anode surface and, concentration polarization due to the quick accumulation of Mg2+ ions in the IL based electrolyte are responsible. In-depth surface characterization suggested the discharge products accumulated on the Mg surface with a proposed formula [P6,6,6,14].Cl.Mg(OH)(2).9[Mg(OCH2CH2OH)Cl]. 40H(2)O most likely had a highly-crosslinked chemical structure, which were responsible for the limited ionic conductivity of the Mg interphase.
|
|
