| 1. |
- Vernet, Nicolas, et al.
(författare)
-
Experimental determination of the permeability of engineering textiles : Benchmark II
- 2014
-
Ingår i: Composites. Part A, Applied science and manufacturing. - : Elsevier Ltd. - 1359-835X .- 1878-5840. ; 61, s. 172-184
-
Tidskriftsartikel (refereegranskat)abstract
- In this second international permeability benchmark, the in-plane permeability values of a carbon fabric were studied by twelve research groups worldwide. One participant also investigated the deformation of the tested carbon fabric. The aim of this work was to obtain comparable results in order to make a step toward standardization of permeability measurements. Unidirectional injections were thus conducted to determine the unsaturated in-plane permeability tensor of the fabric. Procedures used by participants were specified in the guidelines defined for this benchmark. Participants were asked to use the same values for parameters such as fiber volume fraction, injection pressure and fluid viscosity to minimize sources of scatter. The comparison of the results from each participant was encouraging. The scatter between data obtained while respecting the guidelines was below 25%. However, a higher dispersion was observed when some parameters differed from the recommendations of this exercise.
|
|
| 2. |
- Alberini, Andrew, et al.
(författare)
-
Investigating the stability of aromatic carboxylic acids in hydrated magnesium sulfate under UV irradiation to assist detection of organics on Mars
- 2024
-
Ingår i: Scientific Reports. - : Nature Research. - 2045-2322. ; 14:1
-
Tidskriftsartikel (refereegranskat)abstract
- The Scanning Habitable Environments with Raman and Luminescence for Organics and Chemicals (SHERLOC) instrument onboard the Mars 2020 Perseverance rover detected so far some of the most intense fluorescence signals in association with sulfates analyzing abraded patches of rocks at Jezero crater, Mars. To assess the plausibility of an organic origin of these signals, it is key to understand if organics can survive exposure to ambient Martian UV after exposure by the Perseverance abrasion tool and prior to analysis by SHERLOC. In this work, we investigated the stability of organo-sulfate assemblages under Martian-like UV irradiation and we observed that the spectroscopic features of phthalic and mellitic acid embedded into hydrated magnesium sulfate do not change for UV exposures corresponding to at least 48 Martian sols and, thus, should still be detectable in fluorescence when the SHERLOC analysis takes place, thanks to the photoprotective properties of magnesium sulfate. In addition, different photoproduct bands diagnostic of the parent carboxylic acid molecules could be observed. The photoprotective behavior of hydrated magnesium sulfate corroborates the hypothesis that sulfates might have played a key role in the preservation of organics on Mars, and that the fluorescence signals detected by SHERLOC in association with sulfates could potentially arise from organic compounds.
|
|
| 3. |
- Jiménez-Ruano, A., et al.
(författare)
-
Assessing human-caused wildfire ignition likelihood across Europe
- 2023
-
Ingår i: Int. Conf. Smart Sustain. Technol., SpliTech. - : Institute of Electrical and Electronics Engineers Inc.. - 9789532901283
-
Konferensbidrag (refereegranskat)abstract
- Fire ignition probability is an essential component of most fire risk assessment frameworks. This study, framed within the H2020 project FirEUrisk, features a cohesive modelling approach in a set of representative regions (pilot sites; PS) in terms of fire activity across the European territory. These PS encompass different wildfire regimes in contrasting environmental settings: PS-1 Northern Europe, Kalmar Iän (South-East Sweden); PS-2 Central Europe, Southern Brandenburg and Eastern Saxony (Germany), North Bohemia (Czechia), and Lower Silesia (Poland); PS-3 Central Portugal; PS-4 Barcelona province (Spain); and PS-5 Attica region (Greece). Our main goal was to develop a common approach to model human-caused ignitions at a fine-grained spatial resolution (100 meters). For each pilot site we: (i) ascertain which factors influence ignition, hence, addressing potential differences in driving forces and, (ii) provide a spatial-explicit depiction of the patterns of ignition probability. For that propose, we fitted a Random Forest (RF) model in each PS from historical fire records (compiled by local fire agencies) and geospatial layers for land cover, accessibility, and population related factors. All models attained a high predictive accuracy, with AUCs that ranging from 0.69 (Northern Europe) to 0.89 (Attica Region). In turn, the most relevant explanatory variable was the population density that ranked most influential in four out of the five PS, followed by the fuel type, distance to roads, distance to the WUI, and percent cover of forest and wildlands. These findings are a valuable product to upscale future solutions at regional level (beyond NUTS3-type areas), conduct fire behavior modelling simulations, and enrich the science-based decisions which come from the forest and fire management agents at national and European level. © 2023 University of Split, FESB.
|
|
| 4. |
- Merlone, A., et al.
(författare)
-
The MeteoMet project - metrology for meteorology: challenges and results
- 2015
-
Ingår i: Meteorological Applications. - : Wiley. - 1350-4827 .- 1469-8080. ; 22, s. 820-829
-
Tidskriftsartikel (refereegranskat)abstract
- The study describes significant outcomes of the Metrology for Meteorology' project, MeteoMet, which is an attempt to bridge the meteorological and metrological communities. The concept of traceability, an idea used in both fields but with a subtle difference in meaning, is at the heart of the project. For meteorology, a traceable measurement is the one that can be traced back to a particular instrument, time and location. From a metrological perspective, traceability further implies that the measurement can be traced back to a primary realization of the quantity being measured in terms of the base units of the International System of Units, the SI. These two perspectives reflect long-standing differences in culture and practice and this project - and this study - represents only the first step towards better communication between the two communities. The 3 year MeteoMet project was funded by the European Metrology Research Program (EMRP) and involved 18 European National Metrological Institutes, 3 universities and 35 collaborating stakeholders including national meteorology organizations, research institutes, universities, associations and instrument companies. The project brought a metrological perspective to several long-standing measurement problems in meteorology and climatology, varying from conventional ground-based measurements to those made in the upper atmosphere. It included development and testing of novel instrumentation as well as improved calibration procedures and facilities, instrument intercomparison under realistic conditions and best practice dissemination. Additionally, the validation of historical temperature data series with respect to measurement uncertainties and a methodology for recalculation of the values were included.
|
|
| 5. |
- Pollinger, F., et al.
(författare)
-
The European GeoMetre project : developing enhanced large-scale dimensional metrology for geodesy
- 2023
-
Ingår i: Applied Geomatics. - : Springer Science and Business Media Deutschland GmbH. - 1866-9298 .- 1866-928X. ; 15:2, s. 371-381
-
Tidskriftsartikel (refereegranskat)abstract
- We provide a survey on the joint European research project “GeoMetre”, which explores novel technologies and their inclusion to existing surveying strategies to improve the traceability of geodetic reference frames to the SI definition of the metre. This work includes the development of novel distance meters with a range of up to 5 km, the realisation of optical multilateration systems for large structure monitoring at an operation distance of 50 m and beyond, and a novel strategy for GNSS-based distance determination. Different methods for refractivity compensation, based on classical sensors, on dispersion, on spectroscopic thermometry, and on the speed of sound to reduce the meteorological uncertainties in precise distance measurements, are developed further and characterised. These systems are validated at and applied to the novel European standard baseline EURO5000 at the Pieniny Kippen Belt, Poland, which was completely refurbished and intensely studied in this project. We use our novel instruments for a reduced uncertainty of the scale in the surveillance networks solutions for local tie measurements at space-geodetic co-location stations. We also investigate novel approaches like close-range photogrammetry to reference point determination of space-geodetic telescopes. Finally, we also investigate the inclusion of the local gravity field to consider the deviations of the vertical in the data analysis and to reduce the uncertainty of coordinate transformations in this complex problem.
|
|
| 6. |
|
|
| 7. |
- Gracia-Marco, Luis A., et al.
(författare)
-
Seasonal variation in physical activity and sedentary time in different European regions. The HELENA study
- 2013
-
Ingår i: Journal of Sports Sciences. - : Routledge. - 0264-0414 .- 1466-447X. ; 31:16, s. 1831-1840
-
Tidskriftsartikel (refereegranskat)abstract
- This report aims (1) to examine the association between seasonality and physical activity (PA) and sedentary time in European adolescents and (2) to investigate whether this association was influenced by geographical location (Central-North versus South of Europe), which implies more or less extreme weather and daylight hours. Valid data on PA, sedentary time and seasonality were obtained in 2173 adolescents (1175 females; 12.5-17.5 years) included in this study. Physical activity and sedentary time were measured by accelerometers. ANCOVA was conducted to analyse the differences in PA and sedentary time across seasons. Results showed that girls had lower levels of moderate to vigorous PA (MVPA) and average PA, and spent more time in sedentary activities in winter compared with spring (all P < 0.05). Stratified analyses showed differences in PA and sedentary time between winter and spring in European girls from Central-North of Europe (P < 0.05 for sedentary time). There were no differences between PA and sedentary time across seasonality in boys. In conclusion, winter is related with less time spent in MVPA, lower average PA and higher time spent in sedentary activities in European adolescent girls, compared with spring. These differences seem to mainly occur in Central-North Europe.
|
|
| 8. |
- Medvedevskikh, Maria, et al.
(författare)
-
Report of the CCQM-K130 : Nitrogen mass fraction measurements in glycine
- 2017
-
Ingår i: Metrologia. - 0026-1394 .- 1681-7575. ; 54:1A
-
Tidskriftsartikel (refereegranskat)abstract
- Mass fraction of nitrogen is very important pointer because the results of these measurements are often used for determination of protein mass fraction that is an important indicator of the quality of the vast majority of food products and raw materials, in particular dry milk powder. Proteins-enzymes catalyze chemical reactions, protein along with fats and carbohydrates is one of the indicators characterizing the energy value of food, so its definition is mandatory for all food products. The aim of this key comparison CCQM-K130 and pilot study P166 is to support National Measurement Institutes (NMIs) and Designated Institutes (DIs) to demonstrate the validity of the procedures the employed for determination of nitrogen mass fraction in glycine. The study material for this key comparison and pilot study has been selected to be representative as one of the aminoacid-the simplest part of the protein. Glycine is an amino acid, single acid that does not have any isomers (melting point-290 °C; specific heat of evaporation-528,6 J/kg; specific melting heat-981,1 J/kg; pKa-2,34, molar mass-75,07 g/mol, density-1,607 g/cm3). Ural Scientific Research Institute for Metrology (UNIIM) acted as the coordinating laboratory of this comparison and pilot study. Eight NMIs participated in this key comparison and two NMIs participated in Pilot study. The results of Pilot study are excluded from the Report B.
|
|
| 9. |
- Ploeg, Jeroen, et al.
(författare)
-
Cooperative Automated Maneuvering at the 2016 Grand Cooperative Driving Challenge
- 2018
-
Ingår i: IEEE transactions on intelligent transportation systems (Print). - Piscataway : IEEE Press. - 1524-9050 .- 1558-0016. ; 19:4, s. 1213-1226
-
Tidskriftsartikel (refereegranskat)abstract
- Cooperative adaptive cruise control and platooning are well- known applications in the field of cooperative automated driving. However, extension toward maneuvering is desired to accommodate common highway maneuvers, such as merging, and to enable urban applications. To this end, a layered control architecture is adopted. In this architecture, the tactical layer hosts the interaction protocols, describing the wireless information exchange to initiate the vehicle maneuvers, supported by a novel wireless message set, whereas the operational layer involves the vehicle controllers to realize the desired maneuvers. This hierarchical approach was the basis for the Grand Cooperative Driving Challenge (GCDC), which was held in May 2016 in The Netherlands. The GCDC provided the opportunity for participating teams to cooperatively execute a highway lane-reduction scenario and an urban intersection-crossing scenario. The GCDC was set up as a competition and, hence, also involving assessment of the teams' individual performance in a cooperative setting. As a result, the hierarchical architecture proved to be a viable approach, whereas the GCDC appeared to be an effective instrument to advance the field of cooperative automated driving.
|
|
| 10. |
- Thielke, M. W., et al.
(författare)
-
Full Lignin-Derived Electrospun Carbon Materials as Electrodes for Supercapacitors
- 2022
-
Ingår i: Frontiers in Materials. - : Frontiers Media S.A.. - 2296-8016. ; 9
-
Tidskriftsartikel (refereegranskat)abstract
- In the search for more sustainable energy storage devices, biomass-derived materials have been widely researched as carbon source for electrode applications. Here we present the processing of high molecular lignin, an abundant carbon rich biopolymer and byproduct of the pulp and paper industry, into freestanding nonwoven carbon fiber (CNFs) electrodes by using electrospinning. It is worth mentioning that no petrol-derived polymers that are usually included in the electrospinning of lignin, were employed in this work, making these electrodes more sustainable than common lignin-derived carbon electrodes. The effect of the carbonization temperature and oxygen plasma treatment in the electrochemical performance of the CNFs as electrodes for supercapacitors was studied. The upscaling of the processing of lignin into carbon electrodes was also explored by comparing a standard electrospinning set up with a needleless electrospinning equipment that enabled faster and higher throughput. The electrochemical performance of the CNFs increased after plasma treatment of the surface and the electrodes prepared using the standard set up exhibited the highest activity, achieving specific capacitances of up to 103.6 F g−1. Copyright © 2022 Thielke, Lopez Guzman, Victoria Tafoya, García Tamayo, Castro Herazo, Hosseinaei and Sobrido.
|
|
