| 1. |
|
|
| 2. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
A Flexible Multi-Gbps Transmitter Using Ultra-High Speed Sigma- Delta-over- Fiber
- 2018
-
Ingår i: IEEE MTT-S International Microwave Symposium Digest. - 0149-645X. ; 2018-June, s. 1195-1198
-
Konferensbidrag (refereegranskat)abstract
- Sigma-delta-over-fiber (SDoF) using high speed-low cost optical components for datacom enables high speed transmission at X-band. This paper examines the limitations of SDoF in terms of maximum frequencies and highest bit rates. Different modulation formats, symbol rates and carrier frequencies are investigated. A high speed 850 nm vertical-cavity surface-emiting-laser (VCSEL) is used as an optical source to transmit the optical signal over a 50 meter, OM4, multimode fiber (MMF). Error vector magnitude (EVM) less than 6% is achieved at a 12-GHz center frequency for a 8-Gbps QAM256 modulated signal.
|
|
| 3. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
A Low-Complexity Distributed-MIMO Testbed Based on High-Speed Sigma-Delta-Over-Fiber
- 2019
-
Ingår i: IEEE Transactions on Microwave Theory and Techniques. - 0018-9480 .- 1557-9670. ; 67:7, s. 2861-2872
-
Tidskriftsartikel (refereegranskat)abstract
- Distributed multiple-input-multiple-output (D-MIMO) is a very promising technique to improve capacity and quality of service for emerging 5G systems. In this paper, we propose a flexible and low-cost testbed for D-MIMO systems, where a sigma-delta over fiber (SDoF) solution is proposed to address the fundamental challenge of phase-coherent transmission between multiple distributed access points (APs) from a central unit (CU). Employing low-cost standardized optical data interconnects, SDoF, brings a very flexible and software controlled transmission of RF signals over optical fiber. An SDoF-based D-MIMO testbed with a CU feeding 12 distributed APs has been realized and experimentally evaluated. Initial experiments of D-MIMO and conventional colocated MIMO systems at 2.365 GHz have been performed to demonstrate the flexibility and potential of the proposed testbed as a new powerful tool in the design and analysis of emerging communication system concepts.
|
|
| 4. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
Effect of VCSEL Characteristics on Ultra-High Speed Sigma-Delta-Over-Fiber Communication Links
- 2019
-
Ingår i: Journal of Lightwave Technology. - 0733-8724 .- 1558-2213. ; 37:9, s. 2109-2119
-
Tidskriftsartikel (refereegranskat)abstract
- State-of-the-art high-speed multi-mode vertical-cavity surface-emitting-lasers (VCSELs) have a 3-dB analog bandwidth of ∼25 GHz and can operate up to 55 Gbps error-free, without need of equalization electronics. This makes them strong candidates as optical sources for ultra-high speed sigma-delta-over-fiber (SDoF) communication links. This paper examines the effects of VCSEL characteristics on a 32-Gbps SDoF communication link with a 50 m, OM4, multimode optical fiber. Three high-speed, 850-nm-wavelength VCSELs with oxide aperture sizes of 8.3, 6.6, and 4.6 μm were tested. The effects of different modulation voltage amplitudes and bias currents were also investigated. The link performance and VCSEL power consumption were used as figures-of-merits. By avoiding sub-laser threshold modulation for the VCSEL, each of three VCSELs could provide similar link performance. We show that, compared to conventional datacom links, eased bit-error-rate requirements enabled by bi-level nature of sigma-delta modulation makes it possible to use significantly lower VCSEL bias currents. This in turn enables a reduced VCSEL power consumption (50% lower heat-to-bit ratio) and a potential longer VCSEL lifespan. For a SDoF modulated, 160-Mbaud, QAM64 signal centered at 12 GHz an error vector magnitude of -28 dB was achieved with the VCSEL having oxide aperture size of 4.6 μm operating at only 2 mA bias current and 0.25 V modulation amplitude. This results in a heat-to-bit ratio of only 0.1 mW/Gb/s (or equivalently 0.1 pJ/b), and a current density in the VCSEL that is less than 10 kA/cm2.
|
|
| 5. |
- Sezgin, Ibrahim Can, 1992, et al.
(författare)
-
Evaluation of Distributed MIMO Communication Using a Low-Complexity Sigma-Delta-over-Fiber Testbed
- 2019
-
Ingår i: IEEE MTT-S International Microwave Symposium Digest. - 0149-645X. ; 2019-June, s. 754-757
-
Konferensbidrag (refereegranskat)abstract
- Distributing the antennas of a base station is a method to increase the coverage and the capacity of a conventional, co-located MIMO communication system. However, physically separated antennas/access points (AP) creates a fundamental challenge of RF phase synchronization required for joint/coordinated transmission in distributed MIMO (D-MIMO) systems. In this paper we compare co-located-and distributed-MIMO wireless communication thru various measurements using a fully synchronized, low-complexity, twelve-channel testbed based on sigma-delta-over-fiber (SDoF). Single and multi-user measurements are performed in a laboratory environment and the error-vector-magnitude (EVM), the received power and signal-to-interference ratio (SIR) is calculated. We show that distributing the access points improves the received symbol EVM up to 1.6-dB and increases the coverage of the service area by delivering more uniform received power levels.
|
|
| 6. |
|
|
| 7. |
|
|
| 8. |
|
|
| 9. |
|
|
| 10. |
|
|
