| 1. |
- Annergren, Mariette, 1982-
(författare)
-
Application-Oriented Input Design and Optimization Methods Involving ADMM
- 2016
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- This thesis is divided into two main parts. The first part considers application-oriented input design, specifically for model predictive control (MPC). The second part considers alternating direction method of multipliers (ADMM) for ℓ1 regularized optimization problems and primal-dual interior-point methods.The theory of system identification provides methods for estimating models of dynamical systems from experimental data. This thesis is focused on identifying models used for control, with special attention to MPC. The objective is to minimize the cost of the identification experiment while guaranteeing, with high probability, that the obtained model gives an acceptable control performance. We use application-oriented input design to find such a model. We present a general procedure of implementing application-oriented input design to unknown, possibly nonlinear, systems controlled using MPC. The practical aspects of application-oriented input design are addressed and the method is tested in an experimental study.In addition, a MATLAB-based toolbox for solving application-oriented input design problems is presented. The purpose of the toolbox is threefold: it is used in research; it facilitates communication of research results; it helps an engineer to use application-oriented input design.Several important problems in science can be formulated as convex optimization problems. As such, there exist very efficient algorithms for finding the solutions. We are interested in methods that can handle optimization problems with a very large number of variables. ADMM is a method capable of handling such problems. We derive a scalable and efficient algorithm based on ADMM for two ℓ1 regularized optimization problems: ℓ1 mean and covariance filtering, and ℓ1 regularized MPC. The former occurs in signal processing and the latter is a specific type of model based control.We are also interested in optimization problems with certain structural limitations. These limitations inhibit the use of a central computational unit to solve the problems. We derive a distributed method for solving them instead. The method is a primal-dual interior-point method that uses ADMM to distribute all the calculations necessary to solve the optimization problem at hand.
|
|
| 2. |
|
|
| 3. |
- Ebadat, Afrooz, et al.
(författare)
-
Blind identification strategies for room occupancy estimation
- 2015
-
Ingår i: 2015 European Control Conference (ECC). - Piscataway, NJ : IEEE Communications Society. - 9783952426937 ; , s. 1315-1320
-
Konferensbidrag (refereegranskat)abstract
- We propose and test on real data a two-tier estimation strategy for inferring occupancy levels from measurements of CO2 concentration and temperature levels. The first tier is a blind identification step, based either on a frequentist Maximum Likelihood method, implemented using non-linear optimization, or on a Bayesian marginal likelihood method, implemented using a dedicated Expectation-Maximization algorithm. The second tier resolves the ambiguity of the unknown multiplicative factor, and returns the final estimate of the occupancy levels. The overall procedure addresses some practical issues of existing occupancy estimation strategies. More specifically, first it does not require the installation of special hardware, since it uses measurements that are typically available in many buildings. Second, it does not require apriori knowledge on the physical parameters of the building, since it performs system identification steps. Third, it does not require pilot data containing measured real occupancy patterns (i.e., physically counting people for some periods, a typically expensive and time consuming step), since the identification steps are blind.
|
|
| 4. |
- Ebadat, Afrooz, 1986-
(författare)
-
Experiment Design for Closed-loop System Identification with Applications in Model Predictive Control and Occupancy Estimation
- 2017
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- The objective of this thesis is to develop algorithms for application-oriented input design. This procedure takes the model application into account when designing experiments for system identification.This thesis is divided into two parts. The first part considers the theory of application-oriented input design, with special attention to Model Predictive Control (MPC). We start by studying how to find a convex approximation of the set of models that result in acceptable control performance using analytical methods when controllers with no closed-form control law, for e.g., MPC are employed. The application-oriented input design is formulated in time domain to enable handling of signals constraints. The framework is extended to closed-loop systems where two cases are considered i.e., when the plant is controlled by a general but known controller and for the case of MPC. To this end, an external stationary signal is designed via graph theory. Different sources of uncertainty in application-oriented input design are investigated and a robust application-oriented input design framework is proposed.The second part of this thesis is devoted to the problem of estimating the number of occupants based on the information available to HVAC systems in buildings. The occupancy estimation is first formulated as a two-tier problem. In the first tier, the room dynamic is identified using temporary measurements of occupancy. In the second tier, the identified model is employed to formulate the problem as a fused-lasso problem. The proposed method is further developed to be used as a multi-room estimator using a physics-based model. However, since it is not always possible to collect measurements of occupancy, we proceed by proposing a blind identification algorithm which estimates the room dynamic and occupancy, simultaneously. Finally, the application-oriented input design framework is employed to collect data that is informative enough for occupancy estimation purposes.
|
|
| 5. |
- Ebadat, Afrooz, et al.
(författare)
-
Multi-room occupancy estimation through adaptive gray-box models
- 2015
-
Ingår i: IEEE 54th Annual Conference on Decision and Control (CDC). - Piscataway, NJ : IEEE Communications Society. - 9781479978861 ; , s. 3705-3711, s. 3705-3711
-
Konferensbidrag (refereegranskat)abstract
- We consider the problem of estimating the occupancy level in buildings using indirect information such as CO2 concentrations and ventilation levels. We assume that one of the rooms is temporarily equipped with a device measuring the occupancy. Using the collected data, we identify a gray-box model whose parameters carry information about the structural characteristics of the room. Exploiting the knowledge of the same type of structural characteristics of the other rooms in the building, we adjust the gray-box model to capture the CO2 dynamics of the other rooms. Then the occupancy estimators are designed using a regularized deconvolution approach which aims at estimating the occupancy pattern that best explains the observed CO2 dynamics. We evaluate the proposed scheme through extensive simulation using a commercial software tool, IDA-ICE, for dynamic building simulation.
|
|
