| 1. |
- Björklund, Sofie, et al.
(författare)
-
Distribution of per- and polyfluoroalkyl substances (PFASs ) in a waste-to-energy plant : tracking PFASs in internal residual streams
- 2024
-
Ingår i: Environmental Science and Technology. - : American Chemical Society (ACS). - 0013-936X .- 1520-5851. ; 58:19, s. 8457-8463
-
Tidskriftsartikel (refereegranskat)abstract
- Per- and polyfluoroalkyl substances (PFASs) constitute a diverse group of man-made chemicals characterized by their water- and oil-repellent properties and persistency. Given their widespread use in consumer products, PFASs will inevitably be present in waste streams sent to Waste-to-Energy (WtE) plants. We have previously observed a subset of PFASs in residual streams (ashes, treated process water, and flue gas) from a WtE plant. However, the transport and distribution of PFASs inside the WtE plant have remained unaddressed. This study is part of a comprehensive investigation to create a synoptic overview of the distribution of PFASs in WtE residues. PFASs were found in all sample types except for boiler ash. The total levels of 18 individual PFASs (Σ18PFASs) in untreated flue gas ranged from 5.2 to 9.5 ng m-3, decreasing with 35% ± 10% after wet flue gas treatment. Σ18PFASs in the condensate ranged from 46 to 50 ng L-1, of which perfluorohexanoic acid (PFHxA) made up 90% on a ng L-1 basis. PFHxA was also dominant in filter ash, where Σ18PFASs ranged from 0.28 to 0.79 ng g-1. This study shows that flue gas treatment can capture some PFASs and transfer them into WtE residues.
|
|
| 2. |
- Björklund, Sofie, et al.
(författare)
-
Emission of per- and polyfluoroalkyl substances from a waste-to-energy plant-occurrence in ashes, treated process water, and first observation in flue gas
- 2023
-
Ingår i: Environmental Science and Technology. - : American Chemical Society (ACS). - 0013-936X .- 1520-5851. ; 57:27, s. 10089-10095
-
Tidskriftsartikel (refereegranskat)abstract
- Per- and polyfluoroalkyl substances (PFASs) are a large group of compounds commonly used as industrial chemicals and constituents of consumer products, e.g., as surfactants and surface protectors. When products containing PFASs reach their end of life, some end up in waste streams sent to waste-to-energy (WtE) plants. However, the fate of PFASs in WtE processes is largely unknown, as is their potential to enter the environment via ash, gypsum, treated process water, and flue gas. This study forms part of a comprehensive investigation of the occurrence and distribution of PFASs in WtE residues. Sampling was performed during incineration of two different waste mixes: normal municipal solid waste incineration (MSWI) and incineration of a waste mix with 5-8 wt % sewage sludge added to the MSWI (referred to as Sludge:MSWI). PFASs were identified in all examined residues, with short-chain (C4-C7) perfluorocarboxylic acids being the most abundant. Total levels of extractable PFASs were higher during Sludge:MSWI than during MSWI, with the total annual release estimated to be 47 and 13 g, respectively. Furthermore, PFASs were detected in flue gas for the first time (4.0-5.6 ng m-3). Our results demonstrate that some PFASs are not fully degraded by the high temperatures during WtE conversion and can be emitted from the plant via ash, gypsum, treated process water, and flue gas.
|
|
| 3. |
- Björklund, Sofie, 1992-
(författare)
-
Exploring the occurrence, distribution and transport of per- and polyfluoroalkyl substances in waste-to-energy plant
- 2024
-
Doktorsavhandling (övrigt vetenskapligt/konstnärligt)abstract
- Efficient municipal solid waste (MSW) management promotes resource conservation, climate-change mitigation, public health, and environmental protection. A key aspect of environmental protection within MSW management is ensuring that potential pollutants are not released into the environment. One group of environmental pollutants of global concern is per- and polyfluoroalkyl substances (PFAS). Also known as “forever chemicals”, these are used in a wide variety of consumer products and industrial processes, and are known for their persistence. The fate of PFAS in waste-management processes, such as Waste-to-Energy (WtE), is largely unknown. This thesis aimed to investigate the fate of PFAS in a WtE plant.Comprehensive sampling was performed to provide a synoptic overview of the occurrence and distribution of PFAS in residual streams, and to investigate the potential emission of PFAS from the WtE process to the environment.Short-chain (C ≤ 7) perfluorocarboxylic acids were the dominant class of PFAS across all matrices analysed. PFAS was found in leachate from the temporary MSW stockpile located at the WtE plant, as well as in most incineration residues (e.g., bottom ash, condensate, and flue gas) during the incineration of MSW. Co-incineration of sewage sludge from a wastewater treatment plant and MSW (with the former added at 5–8 wt.% of the latter) led to an increase in the concentration of PFAS in all matrices, with the exception of filter ash and stack flue gas.In general, the wet flue-gas treatment was able to capture some PFAS and transfer them to the in-house process-water treatment; however, further optimisation is required to increase the ability of this treatment to capture the shortest PFAS investigated (perfluorobutanoic acid).Overall, these findings highlight that some PFAS are not fully degraded during WtE conversion, and that PFAS could enter the environment via both leaching from unburnt MSW and incineration residues.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
- Björklund, Sofie, et al.
(författare)
-
Occurrence of per- and polyfluoroalkyl substances and unidentified organofluorine in leachate from waste-to-energy stockpile : A case study
- 2021
-
Ingår i: Chemosphere. - : Pergamon Press. - 0045-6535 .- 1879-1298. ; 278
-
Tidskriftsartikel (refereegranskat)abstract
- Per- and polyfluoroalkyl substances (PFASs) are a diverse group of chemicals used in consumer products, which will inevitably end up in waste streams. Landfills are widely recognized secondary point sources of PFASs, but other types of waste management sites have received less attention. Therefore, in a case study presented here we investigated releases of PFASs from temporarily stored waste by determining quantities of 34 PFASs in leachate from a Waste-to-Energy stockpile (45 000 ± 2000 tonnes) during five months in 2019. We also measured extractable organofluorine (EOF) to account for PFASs not included in the target list. The mean total concentration of the 34 PFAS (Σ34PFAS) was 211 ± 31 ng/L, and short-chain (C4–C7) perfluorocarboxylic acids (PFCAs) accounted for 56–60% of the total. Moreover, we found that Σ34PFAS only accounted for 12% ± 4% of EOF detected in the leachate. Our results demonstrate that waste stockpiles are previously unexplored sources of PFASs in the environment, and the dominance of short-chain PFCAs is consistent with observed profiles of contaminants in landfill leachates.
|
|
| 7. |
- Duong Phan, Ngoc Chau, et al.
(författare)
-
Accurate sampling of PCDD/F in high temperature flue-gas using cooled sampling probes
- 2012
-
Ingår i: Chemosphere. - : Elsevier. - 0045-6535 .- 1879-1298. ; 88:7, s. 832-836
-
Tidskriftsartikel (refereegranskat)abstract
- In a laboratory-scale combustion reactor, flue-gas samples were collected at two temperatures in the post-combustion zone, 700 °C and 400 °C, using two different water-cooled sampling probes. The probes were the cooled probe described in the European Standard method EN-1948:1, referred to as the original probe, and a modified probe that contained a salt/ice mixture to assist the cooling, referred to as the sub-zero probe. To determine the efficiency of the cooling probes, internal temperature measurements were recorded at 5 cm intervals inside the probes. Flue-gas samples were analyzed for polychlorinated dibenzo-p-dioxin and dibenzofurans (PCDD/Fs). Samples collected at 700 °C using the original cooling probe showed higher concentrations of PCDD/Fs compared to samples collected using the sub-zero probe. No significant differences were observed between samples collected at 400 °C. The results indicated that artifact formation of PCDD/Fs readily occurs during flue-gas sampling at high temperatures if the cooling within the probe is insufficient, as found for the original probe at 700 °C. It was also shown that this problem could be alleviated by using probes with an enhanced cooling capacity, such as the sub-zero probe.Although this may not affect samples collected for regulatory purposes in exit gases, it is of great importance for research conducted in the high-temperature region of the post-combustion zone.
|
|
| 8. |
- Kozyatnyk, Ivan, 1982-, et al.
(författare)
-
Influence of hydrothermal carbonization conditions on the porosity, functionality, and sorption properties of microalgae hydrochars
- 2023
-
Ingår i: Scientific Reports. - : Springer Nature. - 2045-2322. ; 13:1
-
Tidskriftsartikel (refereegranskat)abstract
- Green microalgae is a possible feedstock for the production of biofuels, chemicals, food/feed, and medical products. Large-scale microalgae production requires large quantities of water and nutrients, directing the attention to wastewater as a cultivation medium. Wastewater-cultivated microalgae could via wet thermochemical conversion be valorised into products for e.g., water treatment. In this study, hydrothermal carbonization was used to process microalgae polycultures grown in municipal wastewater. The objective was to perform a systematic examination of how carbonization temperature, residence time, and initial pH affected solid yield, composition, and properties. Carbonization temperature, time and initial pH all had statistically significant effects on hydrochar properties, with temperature having the most pronounced effect; the surface area increased from 8.5 to 43.6 m2 g−1 as temperature was increased from 180 to 260 °C. However, hydrochars produced at low temperature and initially neutral pH generally had the highest capacity for methylene blue adsorption. DRIFTS analysis of the hydrochar revealed that the pH conditions changed the functional group composition, implying that adsorption was electrostatic interactions driven. This study concludes that un-activated hydrochars from wastewater grown microalgae produced at relatively low hydrothermal carbonization temperatures adsorb methylene blue, despite having low surface area.
|
|
| 9. |
- Svensson Myrin, Eva, et al.
(författare)
-
The influence of food waste on dioxin formation during incineration of refuse-derived fuels
- 2014
-
Ingår i: Fuel. - : Elsevier. - 0016-2361 .- 1873-7153. ; 132, s. 165-169
-
Tidskriftsartikel (refereegranskat)abstract
- We report a preliminary characterization of three refuse-derived fuels (RDFs) produced from recovered wood (RW) and two municipal solid wastes (MSWs) with different food waste contents. The fuels were characterized with respect to elemental composition and emissions of polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF) during combustion in a full-scale incinerator. The first RDF (RDF 1) had a low food waste content because it was based on MSW collected from a region where extensive separation of kitchen waste in the household is common. RDF 2 was based on MSW from a region with no organized separation of kitchen waste and therefore had a higher food waste content. A RW fuel with no added MSW was combusted to provide reference data. RDF 1 had very favourable fuel quality and PCDD/F emissions. In particular, its combustion generated lower PCDD/F concentrations (14.6 ng/m3) than that of RDF 2 (23.9 ng/m3) or RW (22.6 ng/m3). This may have been because its relatively high heating value increased its combustion efficiency and the relatively high Cl and Fe contents of RDF 2 promoted PCDD/F formation and chlorination. Both RDF materials had lower moisture contents and higher heating values than the RW fuel.
|
|
| 10. |
- Weidemann, Eva, et al.
(författare)
-
14th congress of combustion by-products and their health effects-origin, fate, and health effects of combustion-related air pollutants in the coming era of bio-based energy sources
- 2016
-
Ingår i: Environmental Science and Pollution Research. - : Springer Science and Business Media LLC. - 0944-1344 .- 1614-7499. ; 23:8, s. 8141-8159
-
Tidskriftsartikel (refereegranskat)abstract
- The 14th International Congress on Combustion By-Products and Their Health Effects was held in UmeAyen, Sweden from June 14th to 17th, 2015. The Congress, mainly sponsored by the National Institute of Environmental Health Sciences Superfund Research Program and the Swedish Research Council for Environment, Agricultural Sciences and Spatial Planning, focused on the Origin, fate and health effects of combustion-related air pollutants in the coming era of bio-based energy sources. The international delegates included academic and government researchers, engineers, scientists, policymakers and representatives of industrial partners. The Congress provided a unique forum for the discussion of scientific advances in this research area since it addressed in combination the health-related issues and the environmental implications of combustion by-products. The scientific outcomes of the Congress included the consensus opinions that: (a) there is a correlation between human exposure to particulate matter and increased cardiac and respiratory morbidity and mortality; (b) because currently available data does not support the assessment of differences in health outcomes between biomass smoke and other particulates in outdoor air, the potential human health and environmental impacts of emerging air-pollution sources must be addressed. Assessment will require the development of new approaches to characterize combustion emissions through advanced sampling and analytical methods. The Congress also concluded the need for better and more sustainable e-waste management and improved policies, usage and disposal methods for materials containing flame retardants.
|
|
