| 1. |
- Eeg-Olofsson, Måns, 1967, et al.
(författare)
-
BCI-bone conduction implant.
- 2013
-
Ingår i: The Fourth International Symposium on Bone Conduction Hearing – Craniofacial Osseointegration. Newcastle, UK.
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)
|
|
| 2. |
- Eeg-Olofsson, Måns, 1967, et al.
(författare)
-
Evaluation of bone tissue formation in a flat surface attachment of a Bone Conduction Implant - A pilot study in a sheep model
- 2014
-
Ingår i: Audiology & Neurotology Extra. - : S. Karger AG. - 1664-5537. ; 4:3, s. 62-76
-
Tidskriftsartikel (refereegranskat)abstract
- The Bone Conduction Implant (BCI) is a new bone conduction hearing device implanted under intact skin. The transducer has a flat direct contact to the mastoid part of the temporal bone and no screws are used. The sound signal is transmitted from the external audio processor to the implant by means of magnetic induction. In this study, osseointegration of a flat passive BCI transducer dummy in sheep skulls was assessed using quantitative and qualitative histology as well as Cone Beam Computed Tomography (CBCT) and Computed Tomography (CT). The histology results were also related to the mechanical properties of the bone to implant interface. Eight months after the surgical implantation, histology sections of the bone close to the implant showed bone remodelling, compact bone and some degree of osseointegration. The histological findings corresponded well to the mechanical measurements indicating stiffer bone close to the implant, and unaffected skull vibration transmission. Neither CBCT nor CT had enough resolution to visualize the bone to implant interface in detail. In this study, using an animal model, it is shown that a flat implant in contact with bone, can be a feasible method for efficient vibration transmission to the skull bone.
|
|
| 3. |
|
|
| 4. |
- Elamin, Khalid, 1977, et al.
(författare)
-
Calorimetric and relaxation properties of xylitol-water mixtures
- 2012
-
Ingår i: Journal of Chemical Physics. - : AIP Publishing. - 1089-7690 .- 0021-9606. ; 136:10
-
Tidskriftsartikel (refereegranskat)abstract
- We present the first broadband dielectric spectroscopy (BDS) and differential scanning calorimetry study of supercooled xylitol-water mixtures in the whole concentration range and in wide frequency (10(-2)-10(6) Hz) and temperature (120-365 K) ranges. The calorimetric glass transition, T-g, decreases from 247 K for pure xylitol to about 181 K at a water concentration of approximately 37 wt. %. At water concentrations in the range 29-35 wt. % a plentiful calorimetric behaviour is observed. In addition to the glass transition, almost simultaneous crystallization and melting events occurring around 230-240 K. At higher water concentrations ice is formed during cooling and the glass transition temperature increases to a steady value of about 200 K for all higher water concentrations. This Tg corresponds to an unfrozen xylitol-water solution containing 20 wt. % water. In addition to the true glass transition we also observed a glass transition-like feature at 220 K for all the ice containing samples. However, this feature ismore likely due to ice dissolution [A. Inaba and O. Andersson, Thermochim. Acta, 461, 44 (2007)]. In the case of the BDS measurements the presence of water clearly has an effect on both the cooperative a-relaxation and the secondary beta-relaxation. The a-relaxation shows a non-Arrhenius temperature dependence and becomes faster with increasing concentration of water. The fragility of the solutions, determined by the temperature dependence of the a-relaxation close to the dynamic glass transition, decreases with increasing water content up to about 26 wt. % water, where ice starts to form. This decrease in fragility with increasing water content is most likely caused by the increasing density of hydrogen bonds, forming a network-like structure in the deeply supercooled regime. The intensity of the secondary beta-relaxation of xylitol decreases noticeably already at a water content of 2 wt. %, and at a water content above 5 wt. % it has been replaced by a considerably stronger water (w) relaxation at about the same frequency. However, the similarities in time scale and activation energy between the w-relaxation and the beta-relaxation of xylitol at water contents below 13 wt. % suggest that the w-relaxation is governed, in some way, by the beta-relaxation of xylitol, since clusters of water molecules are rare at these water concentrations. At higher water concentrations the intensity and relaxation rate of the w-relaxation increase rapidly with increasing water content (up to the concentration where ice starts to form), most likely due to a rapid increase of small water clusters where an increasing number of water molecules interacting with other water molecules.
|
|
| 5. |
- Fredén Jansson, Karl-Johan, 1988, et al.
(författare)
-
MRI Induced Torque and Demagnetization in Retention Magnets for a Bone Conduction Implant
- 2014
-
Ingår i: IEEE Transactions on Biomedical Engineering. - : Institute of Electrical and Electronics Engineers (IEEE). - 0018-9294 .- 1558-2531. ; 61:6, s. 1887-1893
-
Tidskriftsartikel (refereegranskat)abstract
- Performing magnetic resonance imaging (MRI) examinations in patients who use implantable medical devices involve safety risks both for the patient and the implant. Hearing implants often use two permanent magnets, one implanted and one external, for the retention of the external transmitter coil to the implanted receiver coil to achieve an optimal signal transmission. The implanted magnet is subjected to both demagnetization and torque, magnetically induced by the MRI scanner. In this paper, demagnetization and a comparison between measured and simulated induced torque is studied for the retention magnet used in a bone conduction implant (BCI) system. The torque was measured and simulated in a uniform static magnetic field of 1.5 T. The magnetic field was generated by a dipole electromagnet and permanent magnets with two different types of coercive fields were tested. Demagnetization and maximum torque for the high coercive field magnets was 7.7% +/- 2.5% and 0.20 +/- 0.01 Nm, respectively and 71.4% +/- 19.1% and 0.18 +/- 0.01 Nm for the low coercive field magnets, respectively. The simulated maximum torque was 0.34 Nm, deviating from the measured torque in terms of amplitude, mainly related to an insufficient magnet model. The BCI implant with high coercive field magnets is believed to be magnetic resonance (MR) conditional up to 1.5 T if a compression band is used around the skull to fix the implant. This is not approved and requires further investigations, and if removal of the implant is needed, the surgical operation is expected to be simple.
|
|
| 6. |
- Glimming, Johan, et al.
(författare)
-
What is the next programming paradigm?
- 2012
-
Ingår i: Second International Software Technology Exchange Workshop 2012.
-
Konferensbidrag (övrigt vetenskapligt/konstnärligt)
|
|
| 7. |
- Sandström, Johan, 1978, et al.
(författare)
-
Deterioration of insulated rail joints – a three-year field study
- 2012
-
Ingår i: Proceedings of the 9th International Conference on Contact Mechanics and Wear of Rail/Wheel Systems (CM2012). ; , s. 301-308
-
Konferensbidrag (refereegranskat)abstract
- Four operational joints at the Swedish West Coast Line have been monitored in field from installation and during three years of operation to follow degradation. Even though operational loads were comparatively low, material damage was found to occur early after installation. All joints showed a similar damage pattern with dominating deformation on the side towards a nearby station. In addition some joints showed “cavity-like” damage on the off-station side. The paper reports observations on continuing degradation of the joints as well as hardness evolution and increased joint dip over time.
|
|
| 8. |
- Svensson, Johan, 1964, et al.
(författare)
-
Liver-derived igf-I regulates mean life span in mice
- 2011
-
Ingår i: PLoS ONE. - : Public Library of Science (PLoS). - 1932-6203. ; 6:7
-
Tidskriftsartikel (refereegranskat)abstract
- Transgenic mice with low levels of global insulin-like growth factor-I (IGF-I) throughout their life span, including pre- and postnatal development, have increased longevity. This study investigated whether specific deficiency of liver-derived, endocrine IGF-I is of importance for life span.
|
|
| 9. |
- Tengblad, Olof, 1957, et al.
(författare)
-
LaBr3(Ce):LaCl3(Ce) Phoswich with pulse shape analysis for high energy gamma-ray and proton identification
- 2013
-
Ingår i: Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment. - : Elsevier BV. - 0168-9002. ; 704:0, s. 19-26
-
Tidskriftsartikel (refereegranskat)abstract
- A novel Phoswich design based on new generation scintillator crystals is presented. The detector composed from a combination of a LaBr3(Ce) with a LaCl3(Ce) crystal in one cylinder coupled to a photo multiplier tube has been tested both for incident gamma rays in the range of 0.3–6 MeV, as well as for high energy protons in the range 120–180 MeV. The Phoswich assembly has not significantly deteriorated the energy resolution, which for 662 KeV gamma rays gives a resolution of 4.5%, while for high energy protons (Ep=180 MeV) an energy resolution of 1% was obtained. It is shown that the signals from the two crystals can be separated in an event by event based mode. Using direct digitizing of the detector pulse an off-line pulse-shape analysis was performed built either on a total to tail or total to pulse height method in order to fully identify the incoming radiation. Our aim with this R&D is to in the future build a detector which is able to detect with good efficiency and resolution over a wide energy range; 0.1–30 MeV gamma rays and 20–400 MeV protons. Monte Carlo simulations made in order to design the next prototype are presented.
|
|
| 10. |
- Tengblad, O., et al.
(författare)
-
Phoswich scintillator for proton and gamma radiation of high energy
- 2011
-
Ingår i: AIP Conference Proceedings. - : AIP. - 1551-7616 .- 0094-243X. - 9780735409835 ; 1409, s. 141-144
-
Konferensbidrag (refereegranskat)abstract
- We present here a Phoswich scintillator design to achieve both high resolution gamma ray detection, and good efficiency for high energy protons. There are recent developments of new high resolution scintillator materials. Especially the LaBr3(Ce) and LaCl3(Ce) crystals have very good energy resolution in the order of 3% for 662 keV gamma radiation. In addition, these materials exhibit a very good light output (63 and 32 photons/keV respectively). A demonstrator detector in the form of an Al cylinder of 24 mm diameter and a total length of 80 mm with 2 mm wall thickness, containing a LaBr3(Ce) crystal of 20 mm diameter and 30 mm length directly coupled to a LaCl3(Ce) crystal of 50 mm length, and closed with a glass window of 5 mm, was delivered by Saint Gobain. To the glass window a Hamamatsu R5380 Photomultiplier tube (PMT) was coupled using silicon optical grease. © 2011 American Institute of Physics.
|
|
