| 1. |
- Davidsson, Kent, 1967, et al.
(författare)
-
Potassium, chlorine, and sulfur in ash, particles, deposits, and corrosion during wood combustion in a circulating fluidized-bed boiler
- 2007
-
Ingår i: Energy & Fuels. - : American Chemical Society (ACS). - 1520-5029 .- 0887-0624. ; 21:1, s. 71-81
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of the addition of chlorine and/or sulfur to the fuel on fly ash composition, deposit formation, and superheater corrosion has been studied during biomass combustion in a circulating fluidized-bed boiler. The chlorine (HCl (aq)) and sulfur (SO2 (g)) were added in proportions of relevance for the potassium chemistry. The composition of the bottom and the fly ashes was analyzed. Gas and particle measurements were performed downstream of the cyclone before the convection pass and the flue gas composition was recorded in the stack with a series of standard instruments and an FTIR analyzer. At the position downstream of the cyclone, a deposit probe was situated, simulating a superheater tube. Deposits on the probe and initial corrosion were examined. It is concluded that addition of sulfur and chlorine increases the formation of submicron particles leading to deposition of potassium sulfate and chloride. The results compare well with earlier work based on laboratory-scale experiments concerning effects of chlorine and sulfur on potassium chemistry.
|
|
| 2. |
- Fridell, Erik, 1963, et al.
(författare)
-
Investigation of NOx storage catalysts
- 1997
-
Ingår i: 4th International Congress on Catalysis and Automotive Pollution Control (CAPoC4) in Brussels, Belgium, April 9-11, 1997.
-
Konferensbidrag (refereegranskat)
|
|
| 3. |
- Fridell, Erik, 1963, et al.
(författare)
-
Investigations of NOx storage catalysts
- 1998
-
Ingår i: Studies in Surface Science and Catalysis. - 0167-2991. ; 116, s. 537-547
-
Tidskriftsartikel (refereegranskat)abstract
- NOx storage catalysts are used to reduce nitrogen oxides from lean-burn vehicles. The nitrogen oxides are stored in the catalyst during lean conditions and subsequently released and reduced during short periods of rich conditions. In the present study, we systematically investigate the sequence of elementary steps in the NOx reduction cycle, and the extent to which these steps influence the maximum NOx, reduction potential of the catalyst. As a model system, we use barium oxide as the NOx, storing compound in a Pt/Rh/Al2O3 system. Kinetics of NO oxidation, NO and NO2 adsorption, NO and NO2 release and reduction are studied under controlled conditions with systematic variations of temperature, gas composition, and storing/release times. The transient experiments comprise a storing phase using a lean NO/C3H6/O2/N2 gas mixture, and a regenerating phase where the O2 now is turned off. Experimentally, a significant amount of NOx is found to be stored in the Ba-containing material. A maximum in NOx storage is observed around 380 degrees C. For most of the experiments, there are clear NO and NO2 desorption peaks upon switching from the storing to the regeneration phase. TPD studies of NO and NO2 reveal a significant difference between prereduced and pre-oxidised samples where the former produce predominantly N2 and N2O at around 200 degrees C while NO and O2 desorb from the latter around 500 degrees C. In situ FTIR spectra show nitrate peaks in the region 1300-1400 cm(-1) when NOx is stored under lean conditions.
|
|
| 4. |
|
|
| 5. |
- Herstad-Svärd, S., et al.
(författare)
-
Ramprogram – Åtgärder för samtidig minimering av alkalirelaterade driftproblem, Etapp 2
- 2007
-
Rapport (övrigt vetenskapligt/konstnärligt)abstract
- Combustion of an increasing amount of biofuel and waste woods has resulted in certainenvironmental advantages, including decreased emissions of fossil CO2, SO2 andmetals. On the other hand, a number of chloride and alkali related operational problemshave occurred which are related to combustion of these fuels.Alkali related operational problems have been studied in a project consisting of twoparts. The overall scope has been to characterise the operational problems and to studymeasures to minimise them. The first part was reported in Värmeforsk report 997 wherethe results were summarised in a table of different measures. In part two, additionalmeasures have been included in the test plan and initial corrosion has been studiedlinked to the different measures. The tests have also in part two been carried out at the12 MW CFB boiler at Chalmers. The effect of the selected measures has beeninvestigated concerning both deposit formation and bed agglomeration, and at the sametime emissions and other operational conditions were characterised.The second part of the project has among other things focused on:• To investigate measures which decrease the content of alkali and chloride in thedeposits, and consequently decrease the risk for corrosion (by investigating theinitial corrosion). Focus was also on trying to explain favourable effects.• To investigate if it is possible to combine a rather low dosage of kaolin and injectionof ammonium sulphate. This was done in order to reduce both bed agglomerationand problems from deposits during combustion of fuels rich in chlorine.• To investigate if co-combustion with sewage sludge, de-inking sludge or peat withhigh ash content, could give similar advantages as conventional additives.• Investigate if ash from PFBC is possible to use as an alternative bed material.By comparing the different measures in part two, it could be concluded that cocombustionof sewage sludge gave the best overall effect. The judgement was based onthe effects concerning bed agglomeration, level of alkali chloride in the flue gas,deposits and initial corrosion. Simultaneous addition of kaolin and ammonia sulphatealso had a favourable impact both in the bed and on the alkali chlorides in the gas phase.Dosage of kaolin did not reduce the effect of injected ammonium sulphate. Cocombustionof peat could also be a very attractive alternative, but it is critical to select asuitable peat type. It is of special concern to avoid peat with a high content of calcium,since it can increase the level of alkali chlorides by reacting with available sulphur.Change of bed material to ash from PFBC can decrease problems with bedagglomeration, but there is a risk of increased deposit formation and corrosion. A boileroperated with high steam data should consequently combine the change of bed materialwith injection of ammonium sulphate or another source of sulphur.Co-combustion of de-inking sludge from pulp and paper production can reduceproblems with bed agglomeration. There is, however, an increased chance of corrosiondue to the high content of calcium. Injection of sulphates may improve the situationconcerning corrosion. The results also showed that low potassium chlorine content in the flue gas decreasesthe risk of corrosion. Increased amount of potassium chlorine content in the flue gaswill not necessary give a high amount of chlorine content in the deposits if there is sulphur in the system.Key words: agglomeration, deposits, corrosion, alkali, kaolin, ammonium sulphate,sludge
|
|
| 6. |
- Johansson, Erik, et al.
(författare)
-
Adsorption Behavior and Adhesive Properties of Biopolyelectrolyte Multilayers formed from Cationic and Anionic Starch
- 2009
-
Ingår i: Biomacromolecules. - : American Chemical Society (ACS). - 1525-7797 .- 1526-4602. ; 10:7, s. 1768-1776
-
Tidskriftsartikel (refereegranskat)abstract
- Cationic starch (D.S. 0.065) and anionic starch (D.S. 0.037) were used to form biopolyelectrolyte multilayers. The influence of the solution concentration of NaCl on the adsorption of starch onto silicon oxide substrates and on the formation of multilayers was investigated using stagnation point adsorption reflectometry (SPAR) and quartz crystal microbalance with dissipation (QCM-D). The wet adhesive properties of the starch multilayers were examined by measuring pull-off forces with the AFM colloidal probe technique. It was shown that polyelectrolyte multilayers (PEM) can be successfully constructed from cationic starch and anionic starch at electrolyte concentrations of 1 mM NaCl and 10 mM NaCl. The water content of the PEMs was approximately 80% at both electrolyte concentrations. However, the thickness of the PEMs formed at 10 mM NaCl was approximately twice the thickness formed at I mM NaCl. The viscoelastic properties of the starch PEMs, modeled as Voigt elements, were dependent on the polyelectrolyte that was adsorbed in the outermost layer. The PEMs appeared to be more rigid when capped by anionic starch than when capped by cationic starch. The wet adhesive pull-off forces increased with layer number and were also dependent oil the polyelectrolyte adsorbed in the outermost layer. Thus, starch PEM treatment has a large potential for increasing the adhesive interaction between solid substrates to levels higher than can be reached by a single layer of cationic starch.
|
|
| 7. |
- Quiding-Järbrink, Marianne, 1964, et al.
(författare)
-
Decreased IgA antibody production in the stomach of gastric adenocarcinoma patients.
- 2009
-
Ingår i: Clinical immunology. - : Elsevier BV. - 1521-7035 .- 1521-6616. ; 131:3, s. 463-71
-
Tidskriftsartikel (refereegranskat)abstract
- Gastric adenocarcinoma is closely associated with Helicobacter pylori infection. It is also much more frequent in patients with common variable immunodeficiency or selective IgA-deficiency than in the general population. To investigate a possible link between local antibody production and gastric tumors, we studied gastric B cell infiltration and local IgA production in patients with H. pylori induced gastric adenocarcinomas. These studies showed that total and H. pylori-specific IgA antibody levels were substantially lower in gastric tissue from the cancer patients compared to those from asymptomatic H. pylori carriers. However, serum IgA levels were similar in the cancer patients and asymptomatic carriers. As could be expected, H. pylori infected asymptomatic carriers had considerably increased IgA antibody levels compared to uninfected subjects. We conclude that patients suffering from gastric adenocarcinoma have a dramatically decreased local IgA production in the stomach compared to asymptomatic H. pylori infected individuals.
|
|
| 8. |
- Rosqvist, Fredrik, 1985-, et al.
(författare)
-
Overeating saturated fat promotes fatty liver and ceramides compared to polyunsaturated fat : a randomized trial
- 2019
-
Ingår i: Journal of Clinical Endocrinology and Metabolism. - : Oxford University Press. - 0021-972X .- 1945-7197. ; 104:12, s. 6207-6219
-
Tidskriftsartikel (refereegranskat)abstract
- CONTEXT: Saturated fat (SFA) versus polyunsaturated fat (PUFA) may promote non-alcoholic fatty liver disease (NAFLD) by yet unclear mechanisms.OBJECTIVE: To investigate if overeating SFA- and PUFA-enriched diets lead to differential liver fat accumulation in overweight and obese humans.DESIGN: Double-blind randomized trial (LIPOGAIN-2). Overfeeding SFA vs PUFA for 8 weeks, followed by 4 weeks of caloric restriction.SETTING: General community.Participants: n=61 overweight or obese men and women.INTERVENTION: Muffins high in either palm (SFA)- or sunflower oil (PUFA) were added to the habitual diet.MAIN OUTCOME MEASURE: Lean tissue mass (not reported here). Secondary and exploratory outcomes included liver and ectopic fat depots.RESULTS: By design, body weight gain was similar in SFA (2.31±1.38 kg) and PUFA (2.01±1.90 kg) groups, P=0.50. SFA markedly induced liver fat content (50% relative increase) along with liver enzymes and atherogenic serum lipids. In contrast, despite similar weight gain, PUFA did not increase liver fat or liver enzymes or cause any adverse effects on blood lipids. SFA had no differential effect on the accumulation of visceral fat, pancreas fat or total body fat compared with PUFA. SFA consistently increased, while PUFA reduced circulating ceramides; changes that were moderately associated with liver fat changes and proposed markers of hepatic lipogenesis. The adverse metabolic effects of SFA were reversed by calorie restriction.CONCLUSIONS: Saturated fat markedly induces liver fat and serum ceramides whereas dietary polyunsaturated fat prevent liver fat accumulation, reduce ceramides and hyperlipidemia during excess energy intake and weight gain in overweight individuals.
|
|
| 9. |
- Acke, Filip, 1968, et al.
(författare)
-
Influence of the platinum-support interaction on the direct reduction of NOx under lean conditions
- 1998
-
Ingår i: Studies in Surface Science and Catalysis. - 0167-2991. ; 116, s. 285-294
-
Tidskriftsartikel (refereegranskat)abstract
- Catalysts containing Pt supported on SiC, Al2O3 and ZSM-5 were prepared and studied for NOx reduction by C3H6 in Oz excess under transient (temperature ramps) and steady-state conditions. The maximum NOx reduction activity in the heating ramp experiments was similar for Pt/SiC and Pt/ZSM-5, while Pt/Al2O3 showed higher maximum activity. Both N-2 and N2O formation was observed for all catalysts, although the respective amounts varied with the investigated system. Highest Nz selectivity was observed for Pt/Al2O3. When the NOx reduction activity was studied under steady-state conditions the activity of Pt/Al2O3 decreased substantially (mainly due to a loss in N-2 production). Pt/ZSM-5 became somewhat more selective towards Na production whereas the activity and selectivity of Pt/SiC remained at about the same values as far the heating ramp experiments. Adsorbed species on the surface of the different catalysts were investigated using in-situ FTIR in order to obtain information about the reaction mechanisms. The adsorption of species on Pt/SiC was negligible, while a number of absorption bands were observed for Pt/Al2O3 (N and C containing species, and -NCO) and Pt/ZSM-5 (HC).
|
|
| 10. |
|
|
