| 1. |
|
|
| 2. |
- Claesson, Hans, et al.
(författare)
-
Rheological behaviour during UV-curing of a star-branched polyester
- 2002
-
Ingår i: Progress in organic coatings. - 0300-9440 .- 1873-331X. ; 44:1, s. 63-67
-
Tidskriftsartikel (refereegranskat)abstract
- Using a rheometer coupled with an UV-light generator, the viscoelastic behaviour during the fast cure of star-branched polyester is investigated. The 32 arm star polymers consist of a hyperbranched polyester core, Boltorn(TM) and linear grafts of poly(E-caprolactone) (degree of polymerisation: 20-52) with methacrylate end groups. The resins are crystalline and the melting points range from 34 to 50degreesC; films can be formed and cured below 80degreesC. The crossover of G' and G was used as the gel point. The time to reach the gel point, a few seconds, increases linearly with molecular weight.
|
|
| 3. |
- Claesson, Hans, et al.
(författare)
-
Semi-crystalline thermoset resins : tailoring rheological properties in melt using comb structures with crystalline grafts
- 2004
-
Ingår i: Progress in organic coatings. - : Elsevier BV. - 0300-9440 .- 1873-331X. ; 49:1, s. 13-22
-
Tidskriftsartikel (refereegranskat)abstract
- Thermosetting resins with semi-crystalline grafts have been synthesized. An amorphous resin with epoxide groups was first functionalized with hydroxyl groups using 2,2-bis(methylol) propionic acid, bis-MPA in bulk at 155 degreesC. Functionalization with bis-MPA was monitored using FT-IR, FT-Raman and SEC. The reaction was complete in 30 min. Grafts of poly(epsilon-caprolactone) were then grown from the hydroxyl functional resin and end capped with methacrylate groups. The polymerization Of epsilon-caprolactone, performed in bulk at 110 degreesC using Sn(Oct)(2), was characterized using H-1 NMR and SEC. The obtained molecular weights agreed well with theoretical values. The final end capping was performed using methacrylic anhydride, and monitored with SEC and H-1 NMR, which indicated full substitution. Two combs were synthesized with different arm lengths, DP 10 and 20, and the obtained M-W were close to calculated values. The complex viscosity was measured from low to high temperature for the crystalline resins, the amorphous resin and blends thereof. Rheological data show a rapid decrease in viscosity within a temperature change of 10-15 degreesC for the crystalline resins while the amorphous resin exhibited a slow softening. The blends exhibited a behavior in-between that of the crystalline and the amorphous resin. Films were prepared from the pure resins and the blends. The films were cured using UV irradiation. The comb architecture of these resins has advantages such as crystallinity, high molecular weight and low viscosity, facilitating leveling and resulting in smooth films. The final film properties varied with the ratio of crystalline to amorphous resin, where increase in the amount of crystalline resin correlated with increased the flexibility.
|
|
| 4. |
- Claesson, Hans, et al.
(författare)
-
Synthesis and characterisation of star branched polyesters with dendritic cores and the effect of structural variations on zero shear rate viscosity
- 2002
-
Ingår i: Polymer. - 0032-3861 .- 1873-2291. ; 43:12, s. 3511-3518
-
Tidskriftsartikel (refereegranskat)abstract
- A series of branched polyesters consisting of poly(epsilon-caprolactone) (PCL) (degree of polymerisation: 5-200) initiated from hydroxy-functional cores and end-capped with methylmethacrylate have been prepared. The cores were third-generation hyperbranched polyester, Boltorn, with approximately 32 hydroxyl groups, a third-generation dendrimer with 24 hydroxyl groups and a third-generation dendron with eight hydroxyl groups. Finally, a linear PCL was synthesised as a reference material. All initiators were based on 2,2-bis(methylol) propionic acid (bis-MPA). C-13 NMR spectra of the polymers showed that those with shorter arms contained unreacted hydroxyl groups on the core. Rheological measurements of zero shear rate viscosity, eta(0), showed that the branched polyesters had a considerably lower eta(0) than linear polyester with similar molecular weight. The low melt viscosity and the crystallity produced a theological behaviour suitable for the film formation process for powder coatings. Measurements of mechanical properties of cured films showed that those with low arm molecular weight, M-a, were amorphous while those of high M-a were crystalline.
|
|
| 5. |
|
|
| 6. |
- Fogelström, Linda, et al.
(författare)
-
Hard and Flexible Nanocomposite Coatings using Nanoclay‐filled Hyperbranched Polymers
- 2010
-
Ingår i: ACS Applied Materials and Interfaces. - : American Chemical Society (ACS). - 1944-8244 .- 1944-8252. ; 2:6, s. 1679-1684
-
Tidskriftsartikel (refereegranskat)abstract
- The combination of hardness, scratch resistance, and flexibility is a highly desired feature in many coating applications. The aim of this study is to achieve this through the introduction of an unmodified nanoclay, montmorillonite (Na+MMT), in a polymer resin based on the hyperbranched polyester Bottom H30. Smooth and transparent films were prepared from both the neat and the nanoparticle-filled hyperbranched resins. X-ray diffraction (XRD) and transmission electron microscopy (TEM) corroborated a mainly exfoliated structure in the nanocomposite films, which was also supported by results from dynamic mechanical analysis (DMA). Furthermore, DMA measurements showed a 9-16 degrees C increase in Tg and a higher storage modulus above and below the T-g-both indications of a more cross-linked network, for the clay-containing film. Thermogravimetric analysis (TGA) demonstrated the influence of the nanofiller on the thermal properties of the nanocomposites, where a shift upward of the decomposition temperature in oxygen atmosphere is attributed to the improved barrier properties of the nanoparticle-filled materials. Conventional coating characterization methods demonstrated an increase in the surface hardness, scratch resistance and flexibility, with the introduction of clay, and all coatings exhibited excellent chemical resistance and adhesion.
|
|
| 7. |
- Gode, Peter, et al.
(författare)
-
A novel sulfonated dendritic polymer as the acidic component in proton conducting membranes
- 2006
-
Ingår i: Solid State Ionics. - : Elsevier BV. - 0167-2738 .- 1872-7689. ; 177:7-8, s. 787-794
-
Tidskriftsartikel (refereegranskat)abstract
- The present study involves the synthesis of sulfonated poly(3-ethyl-3-(hydroxymethyl)oxetane), sPTMPO, by end-capping the hydroxy-groups in the PTMPO with 1,4-butane sultone. A series of the polymer with different degrees of substitution was investigated. Furthermore, the subsequent use of the sulfonated PTMPO as the acidic component in proton conducting membranes was explored. The membranes were prepared by either a) mixing the partly sulfonated PTMPO with hexamethoxymethyl melamine (HMMM) to form cross-links by ether formation between the methylol groups on HMMM and the remaining hydroxyl groups on the hyperbranched polyether or b) using the sulfonated polyether in conjunction with a pyridine functionalised polysulfone, PSU-pyridine, to produce acid-base blend membranes. Membrane properties such as proton conductivity, water uptake and mechanical properties are discussed.
|
|
| 8. |
- Hedenqvist, Mikael S., et al.
(författare)
-
Transport properties of hyperbranched and dendrimer-like star polymers
- 2000
-
Ingår i: Polymer. - 0032-3861 .- 1873-2291. ; 41:5, s. 1827-1840
-
Tidskriftsartikel (refereegranskat)abstract
- Moisture transport properties were assessed by sorption and desorption measurements on hydroxyl-functional hyperbranched polyesters based on 2,2-bis(methylol) propionic acid (bis-MPA) as AB(2)-monomer with ethoxylated pentaerythritol. A series of these polymers with different molar masses were studied. For the first time, it is reported that sigmoidal sorption curves were successfully modelled using a time-dependent surface boundary concentration, where the relaxation time was obtained from the mechanical stress relaxation data. The zero concentration diffusivities were very small and comparable with the values of fully amorphous poly(vinyl alcohol). Both the diffusivity data and the stress relaxation data indicated that these materials were plasticized by moisture. Ethylene glycol transport properties were measured on a hexadecanoate(C16)-terminated bis-MPA hyperbranched polymer. The replacement of the hydroxyl groups with C16 paraffin tails resulted in an increase in solute diffusivity despite the fact that these polymers became semicrystalline. The shape of the desorption curves indicated that continuous micropores were present and facilitated mass transport. The moisture transport properties were also measured on a series of semicrystalline dendrimer-like star poly(epsilon-caprolactone(s)). The low measured densities of these highly crystalline dendrimers confirmed that the porosity, as indicated by the shape of the desorption curves, had to be discontinuous. The porosity in the (C16)-terminated and the poly(epsilon-caprolactone(s)) was impossible to eliminate by applying a high external pressure during crystallization. A collective view of all the results obtained confirm that the transport properties are primarily controlled by the hydroxyl group concentration.
|
|
| 9. |
- Hult, Anders, et al.
(författare)
-
Dendritic macromolecule, process for preparation thereof and use thereof
- 1992
-
Patent (populärvet., debatt m.m.)abstract
- The invention relates to a dendritic macromolecule of the polyester type comprising a central initiator molecule or initiator polymer having one or more reactive hydroxyl groups (A). The groups (A) are under formation of an initial tree structure bonded to reactive carboxyl groups (B) of a monomeric chain extender having the two reactive groups (A) and (B). The tree structure is optionally extended and further branched from the initiator molecule or initiator polymer by addition of further molecules of a monomeric chain extender by means of bonding between the reactive groups (A) and (B) thereof and is thereafter optionally further extended by reaction with a chain stopper. The invention also comprises a process for preparation of the dendritic macromolecule.
|
|
| 10. |
|
|
