| 1. |
|
|
| 2. |
- Grip, Carl Erik, et al.
(författare)
-
Numerical prediction and experimental verification of thermal stratification during holding in pilot plant and production ladles
- 1999
-
Ingår i: ISIJ International. - : Iron and Steel Institute of Japan. - 0915-1559 .- 1347-5460. ; 39:7, s. 715-721
-
Tidskriftsartikel (refereegranskat)abstract
- A 3-dimensional CFD-model has been developed to simulate the natural convection flow in ladles. Qualified measurements of temperature and velocities in 107 and 7 tonne ladles have been made to verify the model. The downward convection flow at the ladle wall has been studied using radioactive isotopes and the thermal stratification has been studied by means of continuous temperature measurements. The experimental techniques are complex and additional numerical simulations have been carried out to study the effect of the measurement technique on the measurement error. The result indicates that the measurements are of sufficient accuracy for the validation. The measurements are compared to predictions from the numerical model. The main conclusion is that the theoretical CFD model gives a very accurate estimation of the temperature distribution during holding.
|
|
| 3. |
- Grip, Carl-Erik, et al.
(författare)
-
Theoretical and practical study of thermal stratification and drainage in ladles of different geometry
- 2000
-
Ingår i: Scandinavian journal of metallurgy. - : Wiley. - 0371-0459 .- 1600-0692. ; 29:1, s. 30-38
-
Tidskriftsartikel (refereegranskat)abstract
- SSAB Lulea, SSAB Oxelosund, MEFOS and Lulea University of Technology have cooperated in developing theoretical models for prediction of thermal stratification and drainage in steel ladles. Predicted results have been verified by measurements done in production ladles with heat weighs of 105 and 200 tonne as well as in a 7-tonne pilot plant ladle. The thermal stratification was measured by thermocouples at different depths. The drainage flow was studied by means of tracer experiments. Numerical simulation models of the steel flow were developed for 7, 105 and 200 tonne steel ladles. The agreement between predictions and measurements was found to be good. The conclusion is that CFD simulation gives a good prediction of stratification and drainage flows in production ladles.
|
|
| 4. |
|
|
| 5. |
|
|
| 6. |
|
|
