| 1. |
- Ciancio, Regina, 1978, et al.
(författare)
-
Electron backscattering diffraction and X-ray diffraction studies of interface relationships in Sr3Ru2O7/Sr2RuO4 eutectic crystals
- 2011
-
Ingår i: Micron. - : Elsevier BV. - 0968-4328. ; 42:4, s. 324-329
-
Tidskriftsartikel (refereegranskat)abstract
- Sr3Ru2O7/Sr2RuO4 eutectic system is investigated by electron backscattering diffraction (EBSD) and X-ray diffraction (XRD). The eutectic growth enables the solidification of the two phases in an ordered lamellar pattern extending along the growth direction, namely the b-axis direction. The eutectic material thus provides in the a-c plane two distinct interfaces having different microstructures with respect to the growth direction. Our analysis shows that, across the inplane c-axis direction (characterized by a poor lattice matching), the b-axis orientation is not constant at the individual interfaces, showing an orientation spread of about 5 degrees. However, across the in-plane a-axis direction (characterized by a good lattice matching), the b-axis orientation does not change within a few tenths of degree (about 0.25 degrees). Such information at nanoscale is also verified on a macroscopic level by standard XRD investigation.
|
|
| 2. |
- Ngaloy, Roselle, 1994, et al.
(författare)
-
Strong In-Plane Magnetization and Spin Polarization in (Co 0.15 Fe 0.85 ) 5 GeTe 2 /Graphene van der Waals Heterostructure Spin-Valve at Room Temperature
- 2023
-
Ingår i: ACS Nano. - 1936-086X .- 1936-0851. ; In Press
-
Tidskriftsartikel (refereegranskat)abstract
- Van der Waals (vdW) magnets are promising, because of their tunable magnetic properties with doping or alloy composition, where the strength of magnetic interactions, their symmetry, and magnetic anisotropy can be tuned according to the desired application. However, so far, most of the vdW magnet-based spintronic devices have been limited to cryogenic temperatures with magnetic anisotropies favoring out-of-plane or canted orientation of the magnetization. Here, we report beyond room-temperature lateral spin-valve devices with strong in-plane magnetization and spin polarization of the vdW ferromagnet (Co0.15Fe0.85)5GeTe2 (CFGT) in heterostructures with graphene. Density functional theory (DFT) calculations show that the magnitude of the anisotropy depends on the Co concentration and is caused by the substitution of Co in the outermost Fe layer. Magnetization measurements reveal the above room-temperature ferromagnetism in CFGT and clear remanence at room temperature. Heterostructures consisting of CFGT nanolayers and graphene were used to experimentally realize basic building blocks for spin valve devices, such as efficient spin injection and detection. Further analysis of spin transport and Hanle spin precession measurements reveals a strong in-plane magnetization with negative spin polarization at the interface with graphene, which is supported by the calculated spin-polarized density of states of CFGT. The in-plane magnetization of CFGT at room temperature proves its usefulness in graphene lateral spin-valve devices, thus revealing its potential application in spintronic technologies.
|
|
| 3. |
- Zhao, Bing, 1990, et al.
(författare)
-
A Room-Temperature Spin-Valve with van der Waals Ferromagnet Fe 5 GeTe 2 /Graphene Heterostructure
- 2023
-
Ingår i: Advanced Materials. - : Wiley. - 0935-9648 .- 1521-4095. ; 35:16
-
Tidskriftsartikel (refereegranskat)abstract
- The discovery of van der Waals (vdW) magnets opened a new paradigm for condensed matter physics and spintronic technologies. However, the operations of active spintronic devices with vdW ferromagnets are limited to cryogenic temperatures, inhibiting their broader practical applications. Here, the robust room-temperature operation of lateral spin-valve devices using the vdW itinerant ferromagnet Fe5GeTe2 in heterostructures with graphene is demonstrated. The room-temperature spintronic properties of Fe5GeTe2 are measured at the interface with graphene with a negative spin polarization. Lateral spin-valve and spin-precession measurements provide unique insights by probing the Fe5GeTe2/graphene interface spintronic properties via spin-dynamics measurements, revealing multidirectional spin polarization. Density functional theory calculations in conjunction with Monte Carlo simulations reveal significantly canted Fe magnetic moments in Fe5GeTe2 along with the presence of negative spin polarization at the Fe5GeTe2/graphene interface. These findings open opportunities for vdW interface design and applications of vdW-magnet-based spintronic devices at ambient temperatures.
|
|
| 4. |
|
|
| 5. |
- Öisjöen, Fredrik, 1982, et al.
(författare)
-
High-Tc SQUID gradiometer system for immunoassays
- 2008
-
Ingår i: Superconductor Science and Technology. - : IOP Publishing. - 0953-2048 .- 1361-6668. ; 21:3, s. Art. Nr. 034004-
-
Tidskriftsartikel (refereegranskat)abstract
- A high-Tc dc SQUID (superconducting quantum interference device) gradiometer was developed for magnetic immunoassays where magnetic nanoparticles are used as markers todetect biological reactions. The gradiometer was fabricated on a 5 × 10 mm2 SrTiO3 bicrystal substrate and has a gradiometer resolution of 2.1 pT cm−1 Hz−1/2. A magnetic signal was detected from a sample of 1 μl of Fe3O4 nanoparticles in a 40 mg ml−1 solution kept in amicrocavity fabricated on Si wafers with Si3N4 membranes using MEMS (micro-electro-mechanical-systems) technology. It was found that volumes as small as 0.3 nl in principle would be detectable with our present device. This corresponds to a total number of particles of 2.2 × 107. The estimated average dipole moment per particle is 4.8 × 10−22 Am2.We are aiming at reading out immunoassays by detecting the Brownian relaxation of magnetic nanoparticles, and we also intend to integrate MEMS technology into our system.
|
|
| 6. |
- Ahrentorp, Fredrik, et al.
(författare)
-
Sensitive magnetic biodetection using magnetic multi-core nanoparticles and RCA coils
- 2017
-
Ingår i: Journal of Magnetism and Magnetic Materials. - : Elsevier BV. - 0304-8853 .- 1873-4766. ; 427, s. 14-18
-
Tidskriftsartikel (refereegranskat)abstract
- We use functionalized iron oxide magnetic multi-core particles of 100 nm in size (hydrodynamic particle diameter) and AC susceptometry (ACS) methods to measure the binding reactions between the magnetic nanoparticles (MNPs) and bio-analyte products produced from DNA segments using the rolling circle amplification (RCA) method. We use sensitive induction detection techniques in order to measure the ACS response. The DNA is amplified via RCA to generate RCA coils with a specific size that is dependent on the amplification time. After about 75 min of amplification we obtain an average RCA coil diameter of about 1 mu m. We determine a theoretical limit of detection (LOD) in the range of 11 attomole (corresponding to an analyte concentration of 55 fM for a sample volume of 200 mu L) from the ACS dynamic response after the MNPs have bound to the RCA coils and the measured ACS readout noise. We also discuss further possible improvements of the LOD.
|
|
| 7. |
- Andersson, Eric, 1992, et al.
(författare)
-
Nondestructive cleaning of the LaAlO3/SrTiO3 surface with ultraviolet light and ozone
- 2016
-
Ingår i: Journal of Vacuum Science and Technology B: Nanotechnology and Microelectronics. - : American Vacuum Society. - 2166-2746 .- 2166-2754. ; 34:4
-
Tidskriftsartikel (refereegranskat)abstract
- The effect of ultraviolet light produced ozone and irradiation (UV/ozone) cleaning on the surface properties and interface electrical properties of 4 unit cell (uc) LaAlO3/SrTiO3 samples is examined. A standard photolithography process is used to contaminate the samples which are then cleaned in UV/ozone. Atomic force microscopy measurements show that the photoresist contaminated samples can be cleaned efficiently using this method. The surface roughness of the cleaned samples is comparable to that of the as-grown samples. Furthermore, electrical transport measurements show that the mobility decreases and the sheet carrier density increases for the contaminated samples, which also display indications of an onset to the Kondo effect. By removing the contaminants with UV/ozone cleaning, the mobility and sheet carrier density can be partially restored toward the as-grown values. The mobility is increased by about two times from approximate to 1000 cm(2) V-1 s(-1) for the contaminated samples to approximate to 2000 cm(2) V-1 s(-1) for the ozone cleaned ones. (C) 2016 American Vacuum Society.
|
|
| 8. |
- Arpaia, Riccardo, 1985, et al.
(författare)
-
Untwinned YBa2Cu3O7-delta thin films on MgO substrates: A platform to study strain effects on the local orders in cuprates
- 2019
-
Ingår i: Physical Review Materials. - 2475-9953. ; 3:11
-
Tidskriftsartikel (refereegranskat)abstract
- We have grown untwinned YBa2Cu3O7-delta (YBCO) films on (110) MgO substrates that were preannealed at high temperature in oxygen atmosphere. The annealing results in surface reconstruction with shallow facets, which induce the suppression of the YBCO twinning domains, and the preferential alignment of the CuO chains along one of the in-plane directions of the substrate. Because of the large mismatch between the in-plane lattice parameters of film and substrate, the strain induced by the MgO into the YBCO layer is strong and very peculiar. The YBCO film is compressed, with respect to the bulk, and presents a unidirectional buckling of the atomic planes, along the chains' direction, due to a deformation of the copper-oxygen octahedra. The YBCO films, which can be grown with thicknesses down to few unit cells and oxygen doping levels spanning most of the superconducting dome, are patterned into nanowires with dimensions down to 50 nm. The anisotropies due to the untwinning state are preserved in these structures; moreover, additional anisotropies appear in ultrathin structures where strain effects become more pronounced. Such untwinned and compressively strained films can therefore be used as a platform to study the interplay between strain and the various local orders in the normal state of YBCO.
|
|
| 9. |
- Aurino, Pier Paolo, 1985, et al.
(författare)
-
Nano-patterning of the electron gas at the LaAlO3/SrTiO3 interface using low-energy ion beam irradiation
- 2013
-
Ingår i: Applied Physics Letters. - : AIP Publishing. - 0003-6951 .- 1077-3118. ; 102:20, s. 201610-
-
Tidskriftsartikel (refereegranskat)abstract
- The quasi-two dimensional electron gas formed at the interface between LaAlO3 (LAO) and SrTiO3 (STO) shows fascinating properties, such as two-dimensional superconductivity, giant electric field effect, and the possible co-existence of ferromagnetic and superconducting phases. In this work, we demonstrate that the conducting LAO/STO interface can be made insulating after short irradiation by a beam of low energy Ar+ ions. The irradiation process does neither result in physical removal of the LAO film nor produces oxygen vacancies in the STO layer. Using electron beam lithography and low ion beam energy irradiation, we fabricated conducting nano-structures in the LAO/STO interface with dimensions down to 50 nm. Such a reliable and robust method of nano-patterning may be a prerequisite for future electronic applications of the LAO/STO interface.
|
|
| 10. |
- Aurino, Pier Paolo, 1985, et al.
(författare)
-
Retention of Electronic Conductivity in LaAlO3/SrTiO3 Nanostructures Using a SrCuO2 Capping Layer
- 2016
-
Ingår i: Physical Review Applied. - : American Physical Society. - 2331-7019. ; 6:2
-
Tidskriftsartikel (refereegranskat)abstract
- The interface between two wide band-gap insulators, LaAlO3 and SrTiO3 (LAO/STO) offers a unique playground to study the interplay and competitions between different ordering phenomena in a strongly correlated two- dimensional electron gas. Recent studies of the LAO/STO interface reveal the inhomogeneous nature of the 2DEG that strongly influences electrical-transport properties. Nanowires needed in future applications may be adversely affected, and our aim is, thus, to produce a more homogeneous electron gas. In this work, we demonstrate that nanostructures fabricated in the quasi-2DEG at the LaAlO3/SrTiO3 interface, capped with a SrCuO2 layer, retain their electrical resistivity and mobility independent of the structure size, ranging from 100 nm to 30 mu m. This is in contrast to noncapped LAO/STO structures, where the room-temperature electrical resistivity significantly increases when the structure size becomes smaller than 1 mu m. High-resolution intermodulation electrostatic force microscopy reveals an inhomogeneous surface potential with "puddles" of a characteristic size of 130 nm in the noncapped samples and a more uniform surface potential with a larger characteristic size of the puddles in the capped samples. In addition, capped structures show superconductivity below 200 mK and nonlinear currentvoltage characteristics with a clear critical current observed up to 700 mK. Our findings shed light on the complicated nature of the 2DEG at the LAO/STO interface and may also be used for the design of electronic devices.
|
|
